Chang Kyu Rhee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Chang Kyu Rhee has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
Y.R. Uhm
4 shared publicationsW. W. Kim
Department of Nuclear Materials Technology Development, Korea Atomic Energy Research Institute (KAERI), Daejeon, 305-600, Korea
3 shared publicationsAlexey P. Puzyr
2 shared publicationsAndrey E. Burov
2 shared publications- Min Ku Lee
Nuclear System Integrity Sensing & Diagnosis Division, Korea Atomic Energy Research Institute, Daejeon 34057, Republic of Korea
2 shared publications Vladimir S. Bondar
2 shared publications
Latest Publications
- 6 March 2023
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 68 (1) , 191-194
Lithium-Ion Conductive Film Membrane of Li 0.3La 0.57TiO 2 Perovskite Structure and its Application in Li-Air Batteries
Impacts of precursor solution recipe, processing parameters, and pellet thickness on the lithium ionic conductivity of the ceramic materials with perovskite structure of Li 0.3La 0.57TiO 2 0.3La 0.57TiO 2 0.3La 0.57TiO 22 (i.e., TiO 2 sol) and then Li+ and La+ were added to the colloidal TiO 2 was on the order of 10-5 S/cm. It also showed that the temperatures corresponding to a full decomposition for Li 0.3La 0.57TiO 2 is about 750°C and materials start forming perovskite structure when temperature reaches about 900°C and the lithium ionic conductivity gains about 21% increase when the pellet thickness is reduced to about ¼.
- 6 March 2023
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 68 (1) , 191-194
Lithium-Ion Conductive Film Membrane of Li 0.3La 0.57TiO 2 Perovskite Structure and its Application in Li-Air Batteries
Impacts of precursor solution recipe, processing parameters, and pellet thickness on the lithium ionic conductivity of the ceramic materials with perovskite structure of Li 0.3La 0.57TiO 2 0.3La 0.57TiO 2 0.3La 0.57TiO 22 (i.e., TiO 2 sol) and then Li+ and La+ were added to the colloidal TiO 2 was on the order of 10-5 S/cm. It also showed that the temperatures corresponding to a full decomposition for Li 0.3La 0.57TiO 2 is about 750°C and materials start forming perovskite structure when temperature reaches about 900°C and the lithium ionic conductivity gains about 21% increase when the pellet thickness is reduced to about ¼.
- 30 December 2020
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 27 (6) , 458-463
Interaction of Detonation Nanodiamonds with Hispidin
- 30 December 2020
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 27 (6) , 458-463
Interaction of Detonation Nanodiamonds with Hispidin
- 30 December 2020
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 27 (6) , 464-467
Features of Nickel Nanoparticles Structure Synthesized by the Spark Discharge Method
- 30 December 2020
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 27 (6) , 464-467
Features of Nickel Nanoparticles Structure Synthesized by the Spark Discharge Method
- 31 December 2018
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 25 (6) , 459-465
Nanodiamonds Conjugated with Nonsteroidal Anti-inflammatory Drugs for Transdermal Delivery
- 31 December 2018
- Published by The Korean Powder Metallurgy & Materials Institute in Journal of Powder Materials
- Vol. 25 (6) , 459-465
Nanodiamonds Conjugated with Nonsteroidal Anti-inflammatory Drugs for Transdermal Delivery
- Open Access
- 25 March 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 258
Round-robin test on thermal conductivity measurement of ZnO nanofluids and comparison of experimental results with theoretical bounds
Ethylene glycol (EG)-based zinc oxide (ZnO) nanofluids containing no surfactant have been manufactured by one-step pulsed wire evaporation (PWE) method. Round-robin tests on thermal conductivity measurements of three samples of EG-based ZnO nanofluids have been conducted by five participating labs, four using accurate measurement apparatuses developed in house and one using a commercial device. The results have been compared with several theoretical bounds on the effective thermal conductivity of heterogeneous systems. This study convincingly demonstrates that the large enhancements in the thermal conductivities of EG-based ZnO nanofluids tested are beyond the lower and upper bounds calculated using the models of the Maxwell and Nan et al. with and without the interfacial thermal resistance.
- 25 March 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 258
Open AccessRound-robin test on thermal conductivity measurement of ZnO nanofluids and comparison of experimental results with theoretical bounds
Ethylene glycol (EG)-based zinc oxide (ZnO) nanofluids containing no surfactant have been manufactured by one-step pulsed wire evaporation (PWE) method. Round-robin tests on thermal conductivity measurements of three samples of EG-based ZnO nanofluids have been conducted by five participating labs, four using accurate measurement apparatuses developed in house and one using a commercial device. The results have been compared with several theoretical bounds on the effective thermal conductivity of heterogeneous systems. This study convincingly demonstrates that the large enhancements in the thermal conductivities of EG-based ZnO nanofluids tested are beyond the lower and upper bounds calculated using the models of the Maxwell and Nan et al. with and without the interfacial thermal resistance.
- 16 September 2010
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 36 (6-7) , 867-873
Synthesis of carbon encapsulated metal (Ni and Cu) nano particles and applications for chiral catalysts
- 16 September 2010
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 36 (6-7) , 867-873
Synthesis of carbon encapsulated metal (Ni and Cu) nano particles and applications for chiral catalysts
- 1 January 2010
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 51 (9) , 1689-1693
Fabrication of an Yttria Thin-Wall Tube by Radial Magnetic Pulsed Compaction of Powder-Based Tapes
Highly dense and homogeneous yttria (Y2O3) thin-wall tubes have been successfully fabricated by applying tape-casting and radial magnetic pulsed compaction (RMPC) followed by thermal sintering. Since a homogeneous density distribution was obtained in the RMPCed compact, by using the Y2O3-based tape instead of a stuck of raw powder, cracking and bending were inhibited throughout the process up to the final sintered body. The relative density of the resultant tube reached 99.9%, and the structure was very fine with grain sizes of 2∼5 μm. Moreover, when the granulated powder was used as the precursor of the tape, the thermal densification was promoted due to its enhanced sinterability as compared to the raw powder.
- 1 January 2010
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 51 (9) , 1689-1693
Fabrication of an Yttria Thin-Wall Tube by Radial Magnetic Pulsed Compaction of Powder-Based Tapes
Highly dense and homogeneous yttria (Y2O3) thin-wall tubes have been successfully fabricated by applying tape-casting and radial magnetic pulsed compaction (RMPC) followed by thermal sintering. Since a homogeneous density distribution was obtained in the RMPCed compact, by using the Y2O3-based tape instead of a stuck of raw powder, cracking and bending were inhibited throughout the process up to the final sintered body. The relative density of the resultant tube reached 99.9%, and the structure was very fine with grain sizes of 2∼5 μm. Moreover, when the granulated powder was used as the precursor of the tape, the thermal densification was promoted due to its enhanced sinterability as compared to the raw powder.
- 30 June 2009
- Published by The Korean Magnetics Society in Journal of Magnetics
- Vol. 14 (2) , 75-79
Synthesis of Metal and Ceramic Magnetic Nanoparticles by Levitational Gas Condensation (LGC)
- 30 June 2009
- Published by The Korean Magnetics Society in Journal of Magnetics
- Vol. 14 (2) , 75-79
Synthesis of Metal and Ceramic Magnetic Nanoparticles by Levitational Gas Condensation (LGC)
- 14 December 2007
- Published by Wiley in physica status solidi (c)
- Vol. 4 (12) , 4408-4411
Magnetic and photocatalytic effect of Fe‐doped nano‐rod ZnO synthesized by the hydrolysis of metal powders
- 14 December 2007
- Published by Wiley in physica status solidi (c)
- Vol. 4 (12) , 4408-4411
Magnetic and photocatalytic effect of Fe‐doped nano‐rod ZnO synthesized by the hydrolysis of metal powders