JLJindi Liang

Jindi Liang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jindi Liang has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study on effects of ultrasound on microstructure refinement at semi-solid statement of ultrasonic-assisted brazing SiCp/Al composites

    by Jindi Liang, Lin Ma, Chao Zhu, Changhzhuang Zhou, Zhi Zhu, Chunxia Wang

    Ultrasonic composite brazing uses ultrasonic cavitation and acoustic flow effects to ameliorate the soakage property of SiC particles and brazing material, enabling flux-free brazing of SiCp/Al-MMCs under atmospheric conditions. However, its mechanical properties are limited by the performance of the brazing material, which is often difficult to apply in structures with high strength requirements. In order to break through the limitations of conventional ultrasonic composite brazing of SiCp/Al-MMCs, this paper uses 50 vol.% SiCp/Al MMCs as base material and Zn-16Al brazing material. It applies secondary ultrasound at different times during the solidification of the liquid brazing material to reduce the weld grain size and reinforce the weld intensity by using ultrasonic cavitation and acoustic flow effects. The results show that the addition of secondary ultrasound can reduce the α-Al size and make the SiC particles and α-Al evenly distributed in the joint, which can significantly reinforce the intensity of the weld. The shear performance enhanced with the increase of supersound application second, but too long secondary sonication caused atomization of the brazing material, resulting in unfilled brazing material in the weld, which seriously affected the properties of the weld.

  • The Effect of Power Ultrasound on Microstructure Evolution During the Transient Liquid Stage of Ultrasonic-Promoted TLP Bonding SiCp/Al MMCs

    by Changzhuang Zhou, Lin Ma, Chao Zhu, Qinghe Cui, Jindi Liang, Yujian Song

    Ultrasound-promoted transient liquid phase bonding (U-TLP) is a high quality, high efficiency, and low-cost method for fast bonding of difficult-wetting materials in the atmospheric environment. In this paper, U-TLP was used to bond SiC particles reinforced aluminium-based metal matrix composite which particle volume fraction was 70%. The pure zinc foil was used as the intermediate layer. The effects of ultrasonic on microstructure evolution and mechanical properties of joints during the transient liquefaction stage were investigated. The mechanism of ultrasonic effects in the transient liquefaction stage of U-TLP was also inducted. The results showed that high volume fraction SiCp/Al MMCs were bonded well at low temperature in the air environment. Ultrasonic vibration can remove the oxide film on the surface of aluminum matrix composites, enhance the wettability of SiC particles with weld metal, promote atomic diffusion and homogenization of SiC particles, and improve the welding quality and efficiency. Reasonable increase of ultrasonic vibration time could effectively improve the joint strength.