Fangchao Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fangchao Li has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Jingxiang Gao
School of Environment and Spatial Informatics, China University of Mining and Technology, Xuzhou 221116, China
2 shared publications - Jie Yang
College of Forestry (Academy of Forestry), Northwest A&F University, Yangling 712100, China
1 shared publication - Le Niu
Power China Northwest Engineering Corporation Limited, Xi’an 710065, China
1 shared publication - Liu Yang
School of Internet of Things, Nanjing University of Posts and Telecommunications, Nanjing 210042, China
1 shared publication - Nijia Qian
School of Environment and Spatial Informatics, China University of Mining and Technology, Xuzhou 221116, China
1 shared publication - Panos Psimoulis
Nottingham Geospatial Institute, University of Nottingham, Nottingham, UK
1 shared publication
Latest Publications
- Open Access
- 16 February 2025
- Published by MDPI AG in Remote Sensing
- Vol. 17 (4) , 677
An Enhanced Local Optimization Algorithm for GNSS Shadow Matching in Mobile Phones
In the context of mobile phones, the local optimal global navigation satellite systems (GNSS) shadow matching algorithm, which is based on the urban three-dimensional model, can effectively reduce the error of GNSS pseudo-range single-point positioning. However, the positioning accuracy of this algorithm is susceptible to noise, and its continuous signal-to-noise ratio (SNR) scoring method does not fully exploit the probability density and probability distribution information contained in the SNR. Therefore, this paper proposes two improvements for the local optimal shadow matching algorithm: (1) utilizing low-pass filtering to filter SNR, thereby reducing the influence of noise on the algorithm and (2) introducing a probability-based SNR scoring method to fully leverage the probability density and probability distribution information of SNR. In dynamic single-point positioning, the improved algorithm attains an absolute positioning accuracy of up to 3 m, representing a decimeter-level enhancement over the original algorithm. Experiments confirm that using the SNR statistical information of non-line of sight (NLOS) and line-of-sight (LOS) as prior information results in better positioning accuracy compared to when this information is distorted by multipath effects. Additionally, to address the issue of high time complexity in the shadow matching algorithm, especially when considering local optima, this paper presents a scheme to simplify the algorithm’s flow, reducing its time complexity by approximately 75%.
- 16 February 2025
- Published by MDPI AG in Remote Sensing
- Vol. 17 (4) , 677
Open AccessAn Enhanced Local Optimization Algorithm for GNSS Shadow Matching in Mobile Phones
In the context of mobile phones, the local optimal global navigation satellite systems (GNSS) shadow matching algorithm, which is based on the urban three-dimensional model, can effectively reduce the error of GNSS pseudo-range single-point positioning. However, the positioning accuracy of this algorithm is susceptible to noise, and its continuous signal-to-noise ratio (SNR) scoring method does not fully exploit the probability density and probability distribution information contained in the SNR. Therefore, this paper proposes two improvements for the local optimal shadow matching algorithm: (1) utilizing low-pass filtering to filter SNR, thereby reducing the influence of noise on the algorithm and (2) introducing a probability-based SNR scoring method to fully leverage the probability density and probability distribution information of SNR. In dynamic single-point positioning, the improved algorithm attains an absolute positioning accuracy of up to 3 m, representing a decimeter-level enhancement over the original algorithm. Experiments confirm that using the SNR statistical information of non-line of sight (NLOS) and line-of-sight (LOS) as prior information results in better positioning accuracy compared to when this information is distorted by multipath effects. Additionally, to address the issue of high time complexity in the shadow matching algorithm, especially when considering local optima, this paper presents a scheme to simplify the algorithm’s flow, reducing its time complexity by approximately 75%.
- Open Access
- 29 January 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (3) , 517
Assessment Accuracy of Standard Point Positioning Enhanced by Observation and Position Domain Filtering Utilizing a Multi-Epoch Least-Squares Integration Method
To enhance the positioning accuracy of standalone GNSS receivers in environments unable to provide precise ephemeris and clock offset, such as undeveloped forest areas that lack network communication and power supply, this study employed the Time Difference Carrier Phase (TDCP) technology to improve the positioning accuracy of Standard Point Positioning (SPP), where the Least-Squares (LS) and the extended Multi-Epoch Least Squares (MELS) method were applied in the position domain filtering for a single GNSS receiver and compare its performance with the existing observation domain filtering method. Firstly, the simulated data sets with various positioning accuracies were used to verify the effectiveness and convergence of the LS filtering methods. The results indicate that the LS filtering method produces a lower root mean square (RMS) error than the original strategy. Secondly, this study uses two kinematic GNSS data sets to evaluate the performance of the observation and position domain filtering, with an emphasis on the MELS method. The numerical experiment results show that the position domain LS filtering method outperforms the other two methods. The open environment experiments result shows that the positioning domain filtering method achieved positioning accuracies of 0.202 m, 0.843 m, and 2.036 m in the E, N, and U directions, respectively, with improvements of 68.0%, 21.6%, and 24.0%, compared to the original algorithm which achieved positioning accuracies of 0.631 m, 1.076 m, and 2.680 m. It also achieved improvements of 24.0%, 4.0%, and 18.3%, respectively, compared to the observation domain filtering method with positioning accuracies of 0.353 m, 0.886 m, and 2.526 m. The forest scenes experiments result shows that the positioning domain filtering method achieved positioning accuracies of 1.308 m, 1.375 m, and 2.133 m in the E, N, and U directions, respectively, with improvements of 42.4%, 36.2%, and 27.6%, compared to original algorithm which achieved positioning accuracies of 1.863 m, 1.873 m, and 2.722 m, and also achieved improvements of 27.0%, 19.4% and 10.6%, respectively, comparing to observation domain filtering method with positioning accuracies of 1.661 m, 1.642 m and 2.359 m. Moreover, the examination of the LS method results based on different epochs reveals that the filtering accuracy increases as more epochs are incorporated into the position domain integration and the enhancement value reaches a few millimeters.
- 29 January 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (3) , 517
Open AccessAssessment Accuracy of Standard Point Positioning Enhanced by Observation and Position Domain Filtering Utilizing a Multi-Epoch Least-Squares Integration Method
To enhance the positioning accuracy of standalone GNSS receivers in environments unable to provide precise ephemeris and clock offset, such as undeveloped forest areas that lack network communication and power supply, this study employed the Time Difference Carrier Phase (TDCP) technology to improve the positioning accuracy of Standard Point Positioning (SPP), where the Least-Squares (LS) and the extended Multi-Epoch Least Squares (MELS) method were applied in the position domain filtering for a single GNSS receiver and compare its performance with the existing observation domain filtering method. Firstly, the simulated data sets with various positioning accuracies were used to verify the effectiveness and convergence of the LS filtering methods. The results indicate that the LS filtering method produces a lower root mean square (RMS) error than the original strategy. Secondly, this study uses two kinematic GNSS data sets to evaluate the performance of the observation and position domain filtering, with an emphasis on the MELS method. The numerical experiment results show that the position domain LS filtering method outperforms the other two methods. The open environment experiments result shows that the positioning domain filtering method achieved positioning accuracies of 0.202 m, 0.843 m, and 2.036 m in the E, N, and U directions, respectively, with improvements of 68.0%, 21.6%, and 24.0%, compared to the original algorithm which achieved positioning accuracies of 0.631 m, 1.076 m, and 2.680 m. It also achieved improvements of 24.0%, 4.0%, and 18.3%, respectively, compared to the observation domain filtering method with positioning accuracies of 0.353 m, 0.886 m, and 2.526 m. The forest scenes experiments result shows that the positioning domain filtering method achieved positioning accuracies of 1.308 m, 1.375 m, and 2.133 m in the E, N, and U directions, respectively, with improvements of 42.4%, 36.2%, and 27.6%, compared to original algorithm which achieved positioning accuracies of 1.863 m, 1.873 m, and 2.722 m, and also achieved improvements of 27.0%, 19.4% and 10.6%, respectively, comparing to observation domain filtering method with positioning accuracies of 1.661 m, 1.642 m and 2.359 m. Moreover, the examination of the LS method results based on different epochs reveals that the filtering accuracy increases as more epochs are incorporated into the position domain integration and the enhancement value reaches a few millimeters.