Bin Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Bin Liu has a total of 70 co-authors. Here are the top co-authors by number of shared publications:
- Zhi Ren
Westlake University
6 shared publications Kun Dong
5 shared publicationsLan Yu
Kunming University of Science and Technology
5 shared publications- Lan Yu
Faculty of Materials Science and Engineering, Kunming University of Science and Technology, Kunming 650000, China
5 shared publications Liangwei Chen
5 shared publicationsWuzhang Yang
Westlake University
5 shared publications
Latest Publications
- 2 November 2026
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 10 (11)
Phase selection and superconductivity in compositionally similar high-entropy alloys
- 2 November 2026
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 10 (11)
Phase selection and superconductivity in compositionally similar high-entropy alloys
- 1 October 2026
- Published by Elsevier in Acta Materialia
- Vol. 321
Superconductivity and antiferromagnetism in hexagonal Cr-based high-entropy alloys
- 1 October 2026
- Published by Elsevier in Acta Materialia
- Vol. 321
Superconductivity and antiferromagnetism in hexagonal Cr-based high-entropy alloys
- 25 August 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (33) , 12268-12277
Enhancing the electrocatalytic performance of NiTe 2 single crystals by Se substitution under acidic and alkaline conditions for the hydrogen evolution reaction
Se substitution induces lattice contraction and modulates electronic structure to optimize ΔG H* . Electrochemical tests and DFT calculations verify that moderate Se substitution enhances HER activity in acidic and alkaline media.
- 25 August 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (33) , 12268-12277
Enhancing the electrocatalytic performance of NiTe 2 single crystals by Se substitution under acidic and alkaline conditions for the hydrogen evolution reaction
Se substitution induces lattice contraction and modulates electronic structure to optimize ΔG H* . Electrochemical tests and DFT calculations verify that moderate Se substitution enhances HER activity in acidic and alkaline media.
- 21 July 2026
- Published by Wiley in Laser & Photonics Reviews
- p. e71620
Unifying Efficient Blue Electroluminescence and Ultrafast Radioluminescence in a Single Hot‐Exciton Emitter
Hot‐exciton materials capable of high‐lying triplet‐to‐singlet reverse intersystem crossing offer great potential to simultaneously achieve high exciton utilization and ultrafast radiative decay. Nevertheless, the rational molecular design of dual‐functional emitters for both efficient electroluminescence and fast radioluminescence remains challenging. Here, a novel phenanthroimidazole‐anthracene‐based emitter PI‐An‐PF was designed and synthesized via a facile molecular engineering strategy. The incorporation of anthracene not only constructs a favorable high‐lying excited‐state energy landscape to activate the efficient hot‐exciton pathway, but also suppresses intermolecular aggregation and enhances x‐ray stopping power, endowing the molecule with dual optoelectronic functionalities. Systematic photophysical measurements, including temperature‐dependent and atmosphere‐dependent transient spectroscopy, corroborate the dominant hot‐exciton emission mechanism. Benefiting from the hybrid local and charge‐transfer (HLCT) feature and favorable horizontal dipole orientation, the optimized non‐doped OLEDs achieve high‐efficiency deep‐blue emission with a maximum EQE of 7.07% and negligible efficiency roll‐off. Meanwhile, PI‐An‐PF exhibits an ultrafast RL decay lifetime of 1.49 ns and a low x‐ray detection limit of 305 nGy s. This work reveals the unique advantages of anthracene‐modified phenanthroimidazole hot‐exciton materials and provides a feasible molecular design strategy for multifunctional optoelectronic materials toward display and radiation detection application.
- 21 July 2026
- Published by Wiley in Laser & Photonics Reviews
- p. e71620
Unifying Efficient Blue Electroluminescence and Ultrafast Radioluminescence in a Single Hot‐Exciton Emitter
Hot‐exciton materials capable of high‐lying triplet‐to‐singlet reverse intersystem crossing offer great potential to simultaneously achieve high exciton utilization and ultrafast radiative decay. Nevertheless, the rational molecular design of dual‐functional emitters for both efficient electroluminescence and fast radioluminescence remains challenging. Here, a novel phenanthroimidazole‐anthracene‐based emitter PI‐An‐PF was designed and synthesized via a facile molecular engineering strategy. The incorporation of anthracene not only constructs a favorable high‐lying excited‐state energy landscape to activate the efficient hot‐exciton pathway, but also suppresses intermolecular aggregation and enhances x‐ray stopping power, endowing the molecule with dual optoelectronic functionalities. Systematic photophysical measurements, including temperature‐dependent and atmosphere‐dependent transient spectroscopy, corroborate the dominant hot‐exciton emission mechanism. Benefiting from the hybrid local and charge‐transfer (HLCT) feature and favorable horizontal dipole orientation, the optimized non‐doped OLEDs achieve high‐efficiency deep‐blue emission with a maximum EQE of 7.07% and negligible efficiency roll‐off. Meanwhile, PI‐An‐PF exhibits an ultrafast RL decay lifetime of 1.49 ns and a low x‐ray detection limit of 305 nGy s. This work reveals the unique advantages of anthracene‐modified phenanthroimidazole hot‐exciton materials and provides a feasible molecular design strategy for multifunctional optoelectronic materials toward display and radiation detection application.
- 19 January 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (6) , 2564-2573
Synergistic Co-doping and Te-defects engineering in NiTe 2 single-crystals for enhanced hydrogen evolution in acidic and alkaline environments
Co doping induces lattice contraction in NiTe 2 , triggering Te vacancy formation and synergistically optimizing hydrogen adsorption free energy for enhanced bifunctional HER performance in acidic and alkaline media.
- 19 January 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (6) , 2564-2573
Synergistic Co-doping and Te-defects engineering in NiTe 2 single-crystals for enhanced hydrogen evolution in acidic and alkaline environments
Co doping induces lattice contraction in NiTe 2 , triggering Te vacancy formation and synergistically optimizing hydrogen adsorption free energy for enhanced bifunctional HER performance in acidic and alkaline media.
- 24 December 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 203
A multisite HEA catalyst with etching-induced active surface for synergistic alkaline hydrogen evolution
- 24 December 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 203
A multisite HEA catalyst with etching-induced active surface for synergistic alkaline hydrogen evolution
- 8 May 2025
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 27 (23) , 4019-4028
A, B site doping strategy enhances the structural stability as well as electrical and magnetic properties of Sr0.9Y0.1Fe1−xNixO3−δ driven by Fe(iv) ions
The introduction of 10% Y ions at the Sr site of SrFeO3−δ stabilized the cubic perovskite structure, while the doping of Ni ions at the Fe site optimized its electronic structure, electrical, and magnetic properties.
- 8 May 2025
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 27 (23) , 4019-4028
A, B site doping strategy enhances the structural stability as well as electrical and magnetic properties of Sr0.9Y0.1Fe1−xNixO3−δ driven by Fe(iv) ions
The introduction of 10% Y ions at the Sr site of SrFeO3−δ stabilized the cubic perovskite structure, while the doping of Ni ions at the Fe site optimized its electronic structure, electrical, and magnetic properties.
- 21 April 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (21) , 8452-8460
High-efficiency oxygen evolution catalysts: composite hexagonal structure SrCo1−yNiyO3−δ/Sr9Ni7O21
SrCo0.6Ni0.4O3−δ (annealed at 950 °C) with a composite hexagonal structure (SrCo1−yNiyO3−δ/Sr9Ni7O21, y = 0.1–0.2) achieved the best OER performance.
- 21 April 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (21) , 8452-8460
High-efficiency oxygen evolution catalysts: composite hexagonal structure SrCo1−yNiyO3−δ/Sr9Ni7O21
SrCo0.6Ni0.4O3−δ (annealed at 950 °C) with a composite hexagonal structure (SrCo1−yNiyO3−δ/Sr9Ni7O21, y = 0.1–0.2) achieved the best OER performance.
- Open Access
Regulation of the Thermoelectric Properties of Perovskite RECoO3 Ceramics via High-Entropy Engineering
Entropy engineering has been demonstrated to be an effective strategy to regulate the thermoelectric properties of materials. In this work, we report a series of single-phase cubic (La0.25Sr0.25Ba0.25Ca0.25)CoO3 (LSBC), (La0.25Nd0.25Sr0.25Ba0.25)CoO3 (LNSB), and (La0.2Nd0.2Sr0.2Ba0.2Ca0.2)CoO3 (LNSBC) ceramics based on high-entropy design in the Re site of perovskite RECoO3. Electron microscopy results indicate that the three samples have high crystallinity and exhibit a clear pore structure with rich lattice defects. Electrical transport measurements show that LNSB and LNSBC show metallic conductive behaviors with the lowest resistivity of only 2.25 mΩ cm at 973 K, while LSBC exhibits a semiconductor–metal transition at around 650 K due to the lower average chemical valences in the RE site. Meanwhile, the low average chemical valences also cause the increasing proportion of Co4+ due to the requirement of charge neutrality of the samples, which inhibits their Seebeck coefficients. However, compared with the reported Co-based perovskite oxides, their thermal conductivities are greatly reduced owing to high-entropy enhanced lattice scattering. LSBC in particular obtains the lowest thermal conductivity of 1.25 W·m−1·K−1 at 937 K, while LNSB and LNSBC characterized by high carrier thermal conductivity exhibit a thermal conductivity of 1.52 W·m−1·K−1 at the same temperature. These findings reveal that high-entropy design in the RE site of perovskite RECoO3 ceramics enables the effective reduction of thermal conductivity and the maintenance of the excellent electrical properties simultaneously, which provides a novel route for the development of high-performance thermoelectric materials.
Open AccessRegulation of the Thermoelectric Properties of Perovskite RECoO3 Ceramics via High-Entropy Engineering
Entropy engineering has been demonstrated to be an effective strategy to regulate the thermoelectric properties of materials. In this work, we report a series of single-phase cubic (La0.25Sr0.25Ba0.25Ca0.25)CoO3 (LSBC), (La0.25Nd0.25Sr0.25Ba0.25)CoO3 (LNSB), and (La0.2Nd0.2Sr0.2Ba0.2Ca0.2)CoO3 (LNSBC) ceramics based on high-entropy design in the Re site of perovskite RECoO3. Electron microscopy results indicate that the three samples have high crystallinity and exhibit a clear pore structure with rich lattice defects. Electrical transport measurements show that LNSB and LNSBC show metallic conductive behaviors with the lowest resistivity of only 2.25 mΩ cm at 973 K, while LSBC exhibits a semiconductor–metal transition at around 650 K due to the lower average chemical valences in the RE site. Meanwhile, the low average chemical valences also cause the increasing proportion of Co4+ due to the requirement of charge neutrality of the samples, which inhibits their Seebeck coefficients. However, compared with the reported Co-based perovskite oxides, their thermal conductivities are greatly reduced owing to high-entropy enhanced lattice scattering. LSBC in particular obtains the lowest thermal conductivity of 1.25 W·m−1·K−1 at 937 K, while LNSB and LNSBC characterized by high carrier thermal conductivity exhibit a thermal conductivity of 1.52 W·m−1·K−1 at the same temperature. These findings reveal that high-entropy design in the RE site of perovskite RECoO3 ceramics enables the effective reduction of thermal conductivity and the maintenance of the excellent electrical properties simultaneously, which provides a novel route for the development of high-performance thermoelectric materials.
- 18 November 2024
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 8 (11)
Cocktail effect on superconductivity in hexagonal high-entropy alloys
- 18 November 2024
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 8 (11)
Cocktail effect on superconductivity in hexagonal high-entropy alloys