Jingfei Bai

At present, no consensus has been reached on the generation mechanism of anisotropy in materials fabricated by laser powder bed fusion (LPBF), and most attention has been focused on crystallographic texture. In this paper, an analysis and test were carried out on the hardness, defect distribution, residual stress distribution, and microstructure of WE43 magnesium alloy fabricated by LPBF. The results indicate that LPBF WE43 exhibits obvious anisotropy—the hardness HV of X–Z surface (129.9 HV on average) and that of Y–Z surface (130.7 HV on average) are about 33.5% higher than that of X–Y surface (97.6 HV on average), and the endurable load is smaller in the stacking direction Z compared to the X and Y directions. The factors contributing more to the anisotropy are listed as follows in sequence. Firstly, the defect area of the X–Y projection surface is about 13.2% larger than that of the other two surfaces, so this surface shows greatly reduced mechanical properties due to the exponential relationship between the material strength and the number of defects. Secondly, for laser scanning in each layer/time, the residual stress accumulation in the Z direction is higher than that in the X and Y directions, which may directly reduce the mechanical properties of the material. Finally, more fine grains are distributed in X–Z and Y–Z surfaces when comparing them with those in an X–Y surface, and this fine-grain strengthening mechanism also contributes to the anisotropy. After T5 aging heat treatment (250 °C/16 h), a stronger crystallographic texture is formed in the direction, with the orientation density index increasing from 10.92 to 21.38, and the anisotropy disappearing. This is mainly caused by the enhancement effect of the texture in the direction on the mechanical properties in the Z direction cancelling out the weakening effect of the defects in the X–Y surface in the Z direction.

This paper address the performance optimization of the battery heat sink module by analyzing the lattice structure of the battery heat sink module through in-depth modeling and simulation, and combining the laser powder bed fusion (LPBF)-forming technology with mechanical and corrosion resistance experiments for a comprehensive study. It is found that the introduction of the lattice skeleton significantly improves the thermal conductivity of the phase change material (PCM), realizing the efficient distribution and fast transfer of heat in the system. At the same time, the lattice skeleton makes the heat distribution in the heat exchanger more uniform, improves the utilization rate of the PCM, and helps to maintain the stability of the cell temperature. In addition, the melting of PCM in the lattice heat exchanger is more uniform, thus maximizing its latent heat capacity. In summary, by optimizing the lattice structure and introducing the lattice skeleton, this study successfully improves the performance of the battery heat dissipation system, which provides a strong guarantee for the high efficiency and stable operation of the battery, and provides new ideas and references for the development of the battery heat dissipation technology.

Ti(C,N)-based cermet is a kind of composite material composed of a metal binder phase and a Ti(C,N)-hard phase, which is widely used in the fields of cutting machining and wear-resistant parts due to its high hardness, good toughness, wear resistance, and chemical stability. In recent years, the research on the replacement of traditional Ni, Co, and Fe binder phases by novel binder phases such as intermetallic compounds and high-entropy alloys has made remarkable progress, which significantly improves the mechanical properties, wear resistance, corrosion resistance, and high-temperature oxidation resistance of Ti(C,N)-based cermets. This paper reviews the latest research results, summarizes the mechanism of the new binder to improve the performance of metal–ceramics, and looks forward to the future research directions.