Renjiang Li

After the initial impoundment of the Baihetan Reservoir in April 2021, the water level in front of the dam rose about 200 m. The mechanical properties and effects of the bank slopes in the reservoir area changed significantly, resulting in many bank collapses. This study systematically analyzed the bank slope of the head section of the reservoir, spanning 30 km from the dam to Baihetan Bridge, through a comprehensive investigation conducted after the initial impoundment. The analysis utilized UAV flights and ground surveys to interpret the bank slope’s distribution characteristics and failure patterns. A total of 276 bank collapses were recorded, with a geohazard development density of 4.6/km. The slope gradient of 26% of the collapsed banks experienced an increase ranging from 5 to 20° after impoundment, whereas the remaining sites’ inclines remained unchanged. According to the combination of lithology and movement mode, the bank failure mode is divided into six types, which are the surface erosion type, surface collapse type, surface slide type, bedding slip type of clastic rock, toppling type of clastic rock, and cavity corrosion type of carbonate rock. It was found that the collapsed banks in the reservoir area of 85% developed in the reactivation of old landslide deposits, while 15% in the clastic and carbonate rock. This study offers guidance for the next phase of bank collapse regulations and future geohazards prevention strategies in the Baihetan Reservoir area.

The present study proposes a preliminary analysis method for rock mass joint acquisition, analysis, and slope stability assessment based on unmanned aerial vehicle (UAV) photogrammetry to extract the joint surface attitude in Geographic Information Systems (GIS). The method effectively solves the difficulties associated with the above issues. By combining terrain-following photogrammetry (TFP) and perpendicular and slope surface photogrammetry (PSSP), the three-dimensional (3D) information can be efficiently obtained along the slope characteristics’ surface, which avoids the information loss involved in traditional single-lens aerial photography and the information redundancy of the five-eye aerial photography. Then, a semi-automatic geoprocessing tool was developed within the ArcGIS Pro 3.0 environment, using Python for the extraction of joint surfaces. Multi-point fitting was used to calculate the joint surface attitude. The corresponding attitude symbols are generated at the same time. Finally, the joint surface attitude information is used to perform stereographic projection and kinematic analysis. The former can determine the dominant joint group, and the latter can obtain the probability of four types of failure, including planar sliding, wedge sliding, flexural toppling, and direct toppling. The integrated stability evaluation method studied in this paper, which combines a 3D interpretation of UAV and GIS stereographic projection statistical analysis, has the advantages of being efficient and user-friendly, and requires minimal prior knowledge. The results can aid in the geological surveys of slopes and guide engineering practices.