Abhishek Mukherjee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Abhishek Mukherjee has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Svetlana V. Boriskina
Department of Mechanical Engineering, Massachusetts Institute of Technology, Cambridge, USA
3 shared publications - Andrzej Suchocki
Institute of Physics Polish Academy of Sciences Warsaw 02‐668 Poland
2 shared publications - Damian Wlodarczyk
Institute of Physics, Polish Academy of Sciences, al. Lotników 32/46, 02-668, Warsaw, Poland
2 shared publications Ryan Siebenaller
Air Force Research Laboratory Wright‐Patterson AFBd OH 45433 USA
2 shared publicationsAjeesh K. Somakumar
Institute of Physics Polish Academy of Sciences Warsaw 02‐668 Poland
1 shared publication- Ajeesh Kumar Somakumar
Institute of Physics, Polish Academy of Sciences, Aleja Lotników 32/46, 02-668 Warsaw, Poland
1 shared publication
Latest Publications
- Open Access
- 27 June 2025
- Published by Wiley in Advanced Electronic Materials
- Vol. 11 (13)
Thermal and Dimensional Stability of Photocatalytic Material ZnPS3 Under Extreme Environmental Conditions
Zinc phosphorus trisulfide (ZnPS3), a promising material for photocatalysis and energy storage, is shown in this study to exhibit remarkable stability under extreme conditions. Its optical and structural properties are explored under high pressure and cryogenic temperatures using photoluminescence (PL) spectroscopy, Raman scattering, and density functional theory (DFT). The experimental results identify a pressure‐induced phase transition starting at 6.75 GPa and stabilizing by 12.5 GPa, after which ZnPS3 demonstrates robust stability across a broad pressure range up to 24.5 GPa. DFT calculations support these observations and further predict a semiconductor‐to‐semimetal transition at 100 GPa, while PL measurements reveal defect‐assisted emission that quench under pressure due to enhanced non‐radiative recombination. At cryogenic temperatures, PL quenching intensifies as non‐radiative processes dominate, driven by a rising Grüneisen parameter and reduced phonon population. Cryogenic X‐ray diffraction (XRD) also reveals a high mean thermal expansion coefficient (TEC) of (4.369 ± 0.393) × 10−5 K−1, among the highest reported for 2D materials. This unique combination of tunable electronic properties under low pressure and high thermal sensitivity makes ZnPS3 a strong candidate for sensing applications in extreme environments.
- 27 June 2025
- Published by Wiley in Advanced Electronic Materials
- Vol. 11 (13)
Open AccessThermal and Dimensional Stability of Photocatalytic Material ZnPS3 Under Extreme Environmental Conditions
Zinc phosphorus trisulfide (ZnPS3), a promising material for photocatalysis and energy storage, is shown in this study to exhibit remarkable stability under extreme conditions. Its optical and structural properties are explored under high pressure and cryogenic temperatures using photoluminescence (PL) spectroscopy, Raman scattering, and density functional theory (DFT). The experimental results identify a pressure‐induced phase transition starting at 6.75 GPa and stabilizing by 12.5 GPa, after which ZnPS3 demonstrates robust stability across a broad pressure range up to 24.5 GPa. DFT calculations support these observations and further predict a semiconductor‐to‐semimetal transition at 100 GPa, while PL measurements reveal defect‐assisted emission that quench under pressure due to enhanced non‐radiative recombination. At cryogenic temperatures, PL quenching intensifies as non‐radiative processes dominate, driven by a rising Grüneisen parameter and reduced phonon population. Cryogenic X‐ray diffraction (XRD) also reveals a high mean thermal expansion coefficient (TEC) of (4.369 ± 0.393) × 10−5 K−1, among the highest reported for 2D materials. This unique combination of tunable electronic properties under low pressure and high thermal sensitivity makes ZnPS3 a strong candidate for sensing applications in extreme environments.
- Open Access
- 19 September 2024
- Published by Wiley in Advanced Optical Materials
- Vol. 12 (35)
Synergistic Effects of Defects and Strain on Photoluminescence in Van der Waals Layered Crystal AgScP2S6${\rm AgScP_{2}S_{6}}$
Metal thiophosphates (MTPs) are a large family of 2D materials that exhibit large structural and chemical diversity. They also show promise for applications in energy harvesting and photodetection. Strain and defect engineering have previously been demonstrated as useful mechanisms to tune several properties of MTPs such as resistivity, magnetic state, and electronic band gap. However, the effect of these stimuli on engineering tunable light emission in MTPs remains unexplored. Here, it is experimentally demonstrated that sulfur vacancies in metal thiophosphate allow defect‐state‐to‐valence‐band transitions leading to visible light emission at sub‐bandgap energies, while structural defects in the material can enhance and modulate the photoluminescence spectrum. It is also showed that the structural‐defect‐enhanced light emission can be further tuned by temperature‐induced strain gradients.
- 19 September 2024
- Published by Wiley in Advanced Optical Materials
- Vol. 12 (35)
Open AccessSynergistic Effects of Defects and Strain on Photoluminescence in Van der Waals Layered Crystal AgScP2S6${\rm AgScP_{2}S_{6}}$
Metal thiophosphates (MTPs) are a large family of 2D materials that exhibit large structural and chemical diversity. They also show promise for applications in energy harvesting and photodetection. Strain and defect engineering have previously been demonstrated as useful mechanisms to tune several properties of MTPs such as resistivity, magnetic state, and electronic band gap. However, the effect of these stimuli on engineering tunable light emission in MTPs remains unexplored. Here, it is experimentally demonstrated that sulfur vacancies in metal thiophosphate allow defect‐state‐to‐valence‐band transitions leading to visible light emission at sub‐bandgap energies, while structural defects in the material can enhance and modulate the photoluminescence spectrum. It is also showed that the structural‐defect‐enhanced light emission can be further tuned by temperature‐induced strain gradients.
- Open Access
- 8 January 2024
- Published by Wiley in Nanophotonics
- Vol. 13 (5) , 773-792
GAGA for nonreciprocal emitters: genetic algorithm gradient ascent optimization of compact magnetophotonic crystals
Fundamental limits of thermal radiation are imposed by Kirchhoff’s law, which assumes the electromagnetic reciprocity of a material or material system. Thus, breaking reciprocity can enable breaking barriers in thermal efficiency engineering. In this work, we present a subwavelength, 1D photonic crystal composed of Weyl semimetal and dielectric layers, whose structure was optimized to maximize the nonreciprocity of infrared radiation absorptance in a planar and compact design. To engineer an ultra‐compact absorber structure that does not require gratings or prisms to couple light, we used a genetic algorithm (GA) to maximize nonreciprocity in the design globally, followed by the application of the numerical gradient ascent (GAGA) algorithm as a local optimization to further enhance the design. We chose Weyl semimetals as active layers in our design as they possess strong, intrinsic nonreciprocity, and do not require an external magnetic field. The resulting GAGA‐generated 1D magnetophotonic crystal offers high nonreciprocity (quantified by absorptance contrast) while maintaining an ultra‐compact design with much fewer layers than prior work. We account for both s‐ and p‐polarized absorptance spectra to create a final, eight‐layer design suitable for thermal applications, which simultaneously minimizes the parasitic, reciprocal absorptance of s‐polarized light.
- 8 January 2024
- Published by Wiley in Nanophotonics
- Vol. 13 (5) , 773-792
Open AccessGAGA for nonreciprocal emitters: genetic algorithm gradient ascent optimization of compact magnetophotonic crystals
Fundamental limits of thermal radiation are imposed by Kirchhoff’s law, which assumes the electromagnetic reciprocity of a material or material system. Thus, breaking reciprocity can enable breaking barriers in thermal efficiency engineering. In this work, we present a subwavelength, 1D photonic crystal composed of Weyl semimetal and dielectric layers, whose structure was optimized to maximize the nonreciprocity of infrared radiation absorptance in a planar and compact design. To engineer an ultra‐compact absorber structure that does not require gratings or prisms to couple light, we used a genetic algorithm (GA) to maximize nonreciprocity in the design globally, followed by the application of the numerical gradient ascent (GAGA) algorithm as a local optimization to further enhance the design. We chose Weyl semimetals as active layers in our design as they possess strong, intrinsic nonreciprocity, and do not require an external magnetic field. The resulting GAGA‐generated 1D magnetophotonic crystal offers high nonreciprocity (quantified by absorptance contrast) while maintaining an ultra‐compact design with much fewer layers than prior work. We account for both s‐ and p‐polarized absorptance spectra to create a final, eight‐layer design suitable for thermal applications, which simultaneously minimizes the parasitic, reciprocal absorptance of s‐polarized light.
- Open Access
- 18 November 2013
- Published by American Physical Society (APS) in Physical Review A
- Vol. 88 (5)
Configuration-interaction Monte Carlo method and its application to the trapped unitary Fermi gas
We develop a quantum Monte Carlo method to estimate the ground-state energy of a fermionic many-particle system in the configuration-interaction shell model approach. The fermionic sign problem is circumvented by using a guiding wave function in Fock space. The method provides an upper bound on the ground-state energy whose tightness depends on the choice of the guiding wave function. We argue that the antisymmetric geminal product class of wave functions is a good choice for guiding wave functions. We demonstrate our method for the trapped two-species fermionic cold atom system in the unitary regime of infinite scattering length using the particle-number projected Hartree-Fock-Bogoliubov wave function as the guiding wave function. We estimate the ground-state energy and energy-staggering pairing gap as a function of the number of particles. We compare our results with exact numerical diagonalization results and with previous fixed-node coordinate-space Monte Carlo calculations.
- 18 November 2013
- Published by American Physical Society (APS) in Physical Review A
- Vol. 88 (5)
Open AccessConfiguration-interaction Monte Carlo method and its application to the trapped unitary Fermi gas
We develop a quantum Monte Carlo method to estimate the ground-state energy of a fermionic many-particle system in the configuration-interaction shell model approach. The fermionic sign problem is circumvented by using a guiding wave function in Fock space. The method provides an upper bound on the ground-state energy whose tightness depends on the choice of the guiding wave function. We argue that the antisymmetric geminal product class of wave functions is a good choice for guiding wave functions. We demonstrate our method for the trapped two-species fermionic cold atom system in the unitary regime of infinite scattering length using the particle-number projected Hartree-Fock-Bogoliubov wave function as the guiding wave function. We estimate the ground-state energy and energy-staggering pairing gap as a function of the number of particles. We compare our results with exact numerical diagonalization results and with previous fixed-node coordinate-space Monte Carlo calculations.