Peng Tian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Peng Tian has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Hao Zhang
School of Transportation Science and Engineering Jilin Jianzhu University 130118 Changchun China
2 shared publications - Heng Zhang
School of Transportation Science and Engineering Jilin Jianzhu University 130118 Changchun China
2 shared publications - Li Li
School of Transportation Science and Engineering Jilin Jianzhu University 130118 Changchun China
2 shared publications - Hanghao Zhang
School of Transportation Science and Engineering, Jilin Jianzhu University, 130118 Changchun, China
1 shared publication - Hongshen Zhao
School of Transportation Science and Engineering Jilin Jianzhu University 130118 Changchun China
1 shared publication - Shuai Shao
School of Transportation Science and Engineering, Jilin Jianzhu University, 130118 Changchun, China
1 shared publication
Latest Publications
- Open Access
- 11 February 2025
- Published by Acadlore Publishing Services Limited in Journal of Civil and Hydraulic Engineering
- Vol. 3 (1) , 33-48
Effect of Magnesium Hydroxide Flame Retardant Treatment on the Properties of Corn Stalk Fiber
This study investigates the effect of magnesium hydroxide Mg(OH)$_2$ flame retardant treatment on corn stalk fiber and its impact on the properties of fiber asphalt when mixed at a 3% concentration with asphalt. The study examines the changes in fiber aspect ratio and microscopic morphology before and after flame retardant treatment, and explores the underlying mechanisms that influence the basic performance of fiber asphalt. The effects of flame retardant-treated corn stalk fibers on the asphalt binder were assessed using tests such as softening point, penetration, elongation, temperature scanning, and bending beam rheometer. The results indicate that as the concentration of magnesium hydroxide increases, the three main indicators of the fiber asphalt binder first increase and then decrease. The highest softening point (49.8°C) occurred at a concentration of 2%, the highest penetration (7.6mm) at 1%, and the highest elongation (12.7cm) at 1%. The high and low-temperature performance tests show that the fiber asphalt binder made with 1% magnesium hydroxide-treated corn stalk fibers achieves the best balance of both high and low-temperature properties.
- 11 February 2025
- Published by Acadlore Publishing Services Limited in Journal of Civil and Hydraulic Engineering
- Vol. 3 (1) , 33-48
Open AccessEffect of Magnesium Hydroxide Flame Retardant Treatment on the Properties of Corn Stalk Fiber
This study investigates the effect of magnesium hydroxide Mg(OH)$_2$ flame retardant treatment on corn stalk fiber and its impact on the properties of fiber asphalt when mixed at a 3% concentration with asphalt. The study examines the changes in fiber aspect ratio and microscopic morphology before and after flame retardant treatment, and explores the underlying mechanisms that influence the basic performance of fiber asphalt. The effects of flame retardant-treated corn stalk fibers on the asphalt binder were assessed using tests such as softening point, penetration, elongation, temperature scanning, and bending beam rheometer. The results indicate that as the concentration of magnesium hydroxide increases, the three main indicators of the fiber asphalt binder first increase and then decrease. The highest softening point (49.8°C) occurred at a concentration of 2%, the highest penetration (7.6mm) at 1%, and the highest elongation (12.7cm) at 1%. The high and low-temperature performance tests show that the fiber asphalt binder made with 1% magnesium hydroxide-treated corn stalk fibers achieves the best balance of both high and low-temperature properties.
- Open Access
- 31 December 2023
- Published by Acadlore Publishing Services Limited in Journal of Urban Development and Management
- Vol. 2 (4) , 181-195
An Analytical Investigation into the Water Film Dynamics at the Connection Lines of Highways and Urban Roadways
This study uses BIM software and fluid simulation finite element analysis software to investigate the impact of the water film effect on the surfaces where highways connect with urban roads. The analysis indicates that the drainage length (L), road surface slope (i), rainfall intensity (I), and road surface construction depth (T) are significant factors affecting the thickness of the water film (H) generated by the said effect. The thickness of the water film grows with an increase in drainage length and rainfall intensity; however, it decreases with an increase in road surface slope and road surface construction depth. The approximate relationship between the water film thickness and these four influencing factors is $\mathrm{H} \propto \mathrm{L}^{4.02655} \mathrm{i}^{-1.65562}(0.87 \mathrm{I}+1.26)\left(4.07-0.17 \mathrm{~T}-0.13 \mathrm{~T}^2\right)$. When the water film is thin, the area occupied by the water film in front of the car tires is small; as the thickness of the water film increases, the area it occupies gradually increases, and the tires are gradually lifted by the water film. When lifted to a certain height, the "hydroplaning" phenomenon occurs, which can lead to traffic safety issues. The results of this study are expected to provide a reference for related research on connection lines.- 31 December 2023
- Published by Acadlore Publishing Services Limited in Journal of Urban Development and Management
- Vol. 2 (4) , 181-195
Open AccessAn Analytical Investigation into the Water Film Dynamics at the Connection Lines of Highways and Urban Roadways
This study uses BIM software and fluid simulation finite element analysis software to investigate the impact of the water film effect on the surfaces where highways connect with urban roads. The analysis indicates that the drainage length (L), road surface slope (i), rainfall intensity (I), and road surface construction depth (T) are significant factors affecting the thickness of the water film (H) generated by the said effect. The thickness of the water film grows with an increase in drainage length and rainfall intensity; however, it decreases with an increase in road surface slope and road surface construction depth. The approximate relationship between the water film thickness and these four influencing factors is $\mathrm{H} \propto \mathrm{L}^{4.02655} \mathrm{i}^{-1.65562}(0.87 \mathrm{I}+1.26)\left(4.07-0.17 \mathrm{~T}-0.13 \mathrm{~T}^2\right)$. When the water film is thin, the area occupied by the water film in front of the car tires is small; as the thickness of the water film increases, the area it occupies gradually increases, and the tires are gradually lifted by the water film. When lifted to a certain height, the "hydroplaning" phenomenon occurs, which can lead to traffic safety issues. The results of this study are expected to provide a reference for related research on connection lines.