XHXiaoqian Huang

Xiaoqian Huang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiaoqian Huang has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Joint Bandwidth Limitation and Electrical Dispersion Pre-Compensation in Cost-Sensitive IM/DD Transmission Systems

    by Zhe Zhao, Aiying Yang, Xiaoqian Huang, Peng Guo, Shuhua Zhao, Tianjia Xu, Wenkai Wan, Tianwai Bo, Zhongwei Tan, Yi Dong, et al.

    The modified Gerchberg-Saxton (GS) algorithm provides an effective solution for electrical dispersion pre-compensation (pre-EDC) in short reach intensity modulation and direct detection (IM/DD) optical fiber transmission systems. To further enhance its performance under bandwidth-limited IM/DD systems, a joint bandwidth limitation and electrical dispersion pre-compensation (pre-BL-EDC) scheme is proposed. In this scheme, an equalization filter for bandwidth limitation (BL) is integrated into the modified GS pre-EDC, and a 2-tap finite impulse response (FIR) filter is introduced to improve the pre-compensation performance. In this way, simultaneous pre-compensation of BL and chromatic dispersion (CD) can be achieved at the transmitter, eliminating the need for any post-equalization at the receiver. Simulation results in a C-band 56 Gbit/s on-off keying (OOK) system demonstrate that the pre-BL-EDC can improve the bit error ratio (BER) performance and reduce device bandwidth requirements. Under back-to-back (BTB) transmission, bandwidth limitation pre-compensation (pre-BLC) improves receiver sensitivity by 2.2 dB, 1.8 dB, and 1.4 dB at the hard-decision forward error correction (HD-FEC) threshold for 24 GHz, 32 GHz, and 40 GHz bandwidths, respectively, compared to without pre-compensation. Under 80 km transmission, the receiver sensitivity of pre-BL-EDC is 3.2 dB, 2.8 dB and 1.0 dB higher than that of modified GS pre-EDC for the above corresponding bandwidths. Moreover, pre-BL-EDC allows for longer transmission distances in bandwidth-limited systems. Taking 32 GHz bandwidth as an example, for transmission distances ranging from 10 km to 100 km, the BER can be below the HD-FEC threshold using pre-BL-EDC, whereas it cannot be achieved using modified GS pre-EDC. The proposed scheme is further validated by an experimental system with 3-dB bandwidth of 9 GHz at different baud rates over a 50 km transmission. For OOK signals at 20 Gbit/s, 28 Gbit/s and 32 Gbit/s, the receiver sensitivity gains of pre-BL-EDC compared to modified GS pre-EDC are 1.0 dB, 1.0 dB and 2.0 dB at the HD-FEC threshold, respectively.


  • High-Performance Noise Whitening Filters for Linear and Nonlinear Colored Noise Suppression in IM/DD System With Bandwidth Limitation

    by Fei Xie, Xiaoqian Huang, Chenglin Bai, Hengying Xu, Yaojun Qiao

    Although the equalizer incorporated into the digital signal processing procedure of receivers can mitigate inter-symbol interference (ISI) resulting from bandwidth limitations and chromatic dispersion, it also unavoidably enhances the noise present in the decayed frequency region. This phenomenon is known as equalization-enhanced colored noise. In this paper, we propose three high-performance noise whitening filters (NWF) for linear and nonlinear colored noise, including a scale-enhanced NWF (SE-NWF), an inverse-average NWF (IA-NWF), and an inverse-average nonlinear NWF (IA-NNWF). After obtaining a traditional linear NWF based on auto-regressive modeling, the SE-NWF incorporates an amplification factor to increase the spectral range for stronger noise-whitening ability. To further improve linear and nonlinear noise-whitening ability, the novel IA-NWF and IA-NNWF are presented, which are based on the fundamental tenet that the inversion of the noise spectrum and the extrapolation of this process through the application of linear and nonlinear finite impulse response filters, respectively. The proposed schemes are evaluated in a C-band 61-GBaud intensity modulation and direct detection (IM/DD) optical on-off keying (OOK) and 4-level pulse amplitude modulation (PAM-4) systems. In the OOK transmission with a 3.7-GHz 3-dB bandwidth over an 80-km standard single-mode fiber (SSMF), the results demonstrate that the 8-tap SE-NWF and 8-tap IA-NWF exhibit comparable performance to the 19-tap and 21-tap conventional NWFs, respectively. This indicates that the number of real-valued multiplications is reduced by 52.4% and 56.5%, respectively. With the same memory length, the SE-NWF, IA-NWF, and IA-NNWF can achieve approximate improvements of 2.8 dB, 3.0 dB, and 3.2 dB on receiver sensitivity, respectively, in comparison to the conventional NWF under a 20% forward error correction threshold. In the PAM-4 transmission over a 2-km SSMF, compared to the conventional NWF of equivalent complexity, the 2-tap proposed schemes achieve approximately 1.6 dB and 4.2 dB improvements in receiver sensitivity at the 20% and 7% FEC thresholds, respectively.


  • Multi-Tap Optical Delay Line-Based Optical-Electrical Dispersion Compensation Scheme in High-Speed IM/DD Systems

    by Xiaoqian Huang, Fei Xie, Wen Zuo, Yaojun Qiao

    Digital equalizer-assisted optical signal processors based on optical delay line (ODL) offers an efficient solution for chromatic dispersion (CD) compensation in intensity-modulation/direct-detection (IM/DD) transmission systems. In this paper, a multi-tap ODL-based optical-electrical dispersion compensation scheme is proposed to enhance CD compensation effectiveness. The scheme combines a low-complexity digital equalizer with multi-tap cascaded ODL (C-ODL) and feedforward ODL (F-ODL) based on distinct optical architectures. In addition, the theoretical model derivation reveals that the frequency response of the multi-tap ODL scheme achieves a flat spectrum through the superposition of diverse frequency responses. Verified in a C-band 112 Gb/s 40-km PAM4 system, C-ODL and F-ODL schemes exhibit 3-dB and 2.9-dB received optical power (ROP) gains at 7% forward error correction (FEC) limit over the single-tap ODL scheme, and achieve the KP4-FEC limit at ROPs of −5 dBm and −5.4 dBm with 30 and 53 real-valued multiplications, respectively. Furthermore, C-ODL and F-ODL schemes with optimal parameters can reach the KP4-FEC limit at the maximum CDs of 680 ps/nm and 850 ps/nm. The research results indicate that the proposed multi-tap ODL scheme exhibits significant potential for compensating CD in high-performance and complexity-effective IM/DD optical transmission systems.


  • Deployment of Ultrasmall-Size Cluster-Assisting Lookup Tables in IM/DD Systems

    by Fei Xie, Xiaoqian Huang, Shuangyue Liu, Du Tang, Chenglin Bai, Hengying Xu, Yaojun Qiao

    In the C-band high-speed long-reach optical intensity modulation direct detection (IM/DD) communication system, severe signal distortion, including chromatic dispersion and device bandwidth limitations, making the size of lookup tables (LUTs) required by equalizers too large to be operated. In this paper, we propose a cluster-assisting lookup table (CLUT) approach to reduce the table size significantly. In addition, we also propose multiplication-free CLUT-based decision-feedback equalizer (CLUT-DFE) and CLUT-based log-maximum a posteriori estimation with a fixed number of surviving states (CLUT-FS-MAP) to effectively compensate for channel distortions. Using the k-means clustering algorithm, the proposed CLUT significantly shortens the table size by reducing the number of independent variable values input. The table size of traditional LUTs increases exponentially with the filter tap number, making it impossible for LUTs to replace filters with tap numbers greater than 20. The CLUT breaks this limitation. The proposed schemes are experimentally performed in a C-band 61-Gb/s IM/DD optical on-off keying (OOK) system featuring a 3.65-GHz 3-dB bandwidth over a 100-km standard single mode fiber (SSMF). Compared to traditional LUT, CLUT reduces table size by about 10 orders of magnitude with the same performance. To the best of our knowledge, this study represents the first deployment of ultrasmall-size CLUT in equalization.


  • Open Access

    Trellis-Coded Modulation-Enabled Probabilistic Shaping With Simplified Viterbi Decoder for Bandwidth-Limited IMDD Systems

    by Han Cui, Zhongliang Sun, Xiaoqian Huang, Du Tang, Fei Xie, Yaojun Qiao

    In this paper, trellis-coded modulation-enabled probabilistic shaping (TEPS) scheme with a simplified Viterbi decoder is proposed. Trellis-coded modulation (TCM) is embed-ded in the probabilistic shaping (PS) technique to improve the performance of PS signals in bandwidth-limited intensity modu-lation and direct detection (IMDD) systems. Further, to reduce the calculation complexity of TCM decoding, the constellation partition decision-assisted (CPDA)-Viterbi decoder is proposed which decides the received signal before decoding to reduce the branches. To verify the performance of the proposed scheme, a 32-GBaud TEPS-four-level pulse-amplitude modulation (PAM4) experimental system with 10G-class O-band directly-modulated laser (DML) is built over a 20-km standard single-mode fiber (SSMF) transmission link. The experimental results show that TEPS-PAM4 achieved up to 1.80-dB higher receiver sensitivity than PS-PAM4 at 7% forward error correction (FEC) limit with the same net rate. Moreover, with the multiplications reduced by up to 45.7% compared with the Viterbi decoder, TEPS-PAM4 with CPDA-Viterbi decoder has up to 1.50-dB higher receiver sensitivity limit than PS-PAM4 at 7% FEC.