XZXuexiang Zhang

Xuexiang Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xuexiang Zhang has a total of 52 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Comprehensive Analysis of Vertical and Lateral Gate-All-Around FETs and a Performance Comparison of the Ring Oscillators Composed of Them

    by Z. C. Wang, H. L. Zhu, Y. K. Zhang, Y. T. Zheng, X. X. Zhang, B. W. Shen, T. R. Luo, W. L. Liu, X. Y. Chen, S. S. Lu, et al.

    In this article, six structures/combinations of vertical-channel-FETs (VFETs) were optimized and performance comparison with lateral-gate-all-around (LGAA) FETs and complementary FET (CFET) was made in the advanced applications across device and circuit levels. To find the main resistive and capacitive parasitic, we introduce a novel decomposition methodology for classifying key gate capacitance components. Building on these insights, we propose two optimization strategies: an inner-spacer release technique for overlap capacitance reduction in VFETs and an additional trim-etch method to mitigate resistances. The optimal gate length is also discussed considering the unique channel arrangement of VFETs. Furthermore, we presented a standard cell layout for VFETs, which was used to make direct comparisons of performance–power–area (PPA) with lateral-channel-FETs (LFETs) for 103-ring oscillator (103RO) configurations. Compared to CFET, our simulation results demonstrate that dual-channel complementary stacked VFET (dCVFET) can increase the frequency by 4.4% in iso-power and decrease power by 12.9% in iso-frequency while reducing the area by 4.1%. Compared to LGAA, dual-channel single-layer VFET (dSLVFET) achieves a 14% speed improvement or a 30.7% reduction in power consumption while also reducing the area by 20%. When adopting wrap around contact (WAC), VFETs normally outperform LFETs by achieving nearly a 16% improvement in speed or a 40% reduction in power consumption under the same area.


  • High-Performance Two-Tier FinFETs With Low-Temperature (≤ 500 °C) Silicide Dopant Segregation Schottky S-D for M3D Circuits

    by Feixiong Wang, Yadong Zhang, Yunjiao Bao, Shuang Liu, Xuexiang Zhang, Shujuan Mao, Mingzheng Ding, Jinbiao Liu, Jiaxin Yao, Qingzhu Zhang, et al.

    In this work, 2-tier Monolithic 3-Dimentional (M3D) integrated FinFETs and circuits are fabricated based on a low-temperature (≤ 500 ℃) silicide dopant segregation Schottky Source/Drian (SDSS S-D) technology. By forming NiPt silicide followed by B/P implantation and optimizing annealing on top-tier fins, a sharpened Schottky Barrier of the silicide and a high dopant segregation concentration of the impurities are obtained in the improved silicide S-D with maximum process temperature below 500 °C. As a result, Low-T 2-tier M3D FinFETs are obtained with ION= 646.4 μA/μm for PMOS and ION = 450.6 μA/μm for NMOS at LG= 500 nm and a record ION= 1.84 mA/μm is achieved for PMOS at LG = 25 nm under normalized footprint. Furthermore, M3D inverter, ring oscillators, as well as 6T SRAM with this technique are demonstrated, which is promising to provide an effective and low-cost method to achieve low-temperature high-performance silicon circuits in M3D applications.


  • Open Access

    Performance Optimization of Fabricated Nanosheet GAA CMOS Transistors and 6T-SRAM Cells via Source/Drain Doping Engineering

    by Xuexiang Zhang, Qingkun Li, Lei Cao, Qingzhu Zhang, Renjie Jiang, Peng Wang, Jiaxin Yao, Huaxiang Yin

    As gate-all-around nanosheet transistors (GAA NSFETs) replacing current FinFETs for their superior gate control capabilities, it needs various performance optimizations for better transistor and circuit benefits. In this paper, special optimizations to source/drain (S/D) doping engineering including spacer bottom footing (SBF) and refining the lightly doped drain (LDD) implantation process are explored to enhance both fabricated complementary metal oxide semiconductor (CMOS) NSFETs and their 6T-SRAM cells. The experimental results demonstrate that the optimal SBF width increased the static noise margin (SNM) of the SRAM cells by 14.9%, while significantly reducing static power consumption for the balance performance between the NMOS and PMOS and reduced current in all leakage paths of SRAM. Moreover, the LDD optimization significantly reduced off-state leakage current (Ioff) for both NMOS and PMOS due to the reductions of peak electric field in overlap region between the S/D and the channel, leading to a 9.5% improvement in SNM and a substantial reduction in static power consumption. These results indicate that the optimization to S/D doping engineering may achieve substantial performance gains in both the GAA CMOS transistors and the SRAM cells.


  • Record 60.3 mV/dec Subthreshold Swing and >20% Performance Enhancement in Gate-All-Around Nanosheet CMOS Devices Using O₃-Based Quasi-Atomic Layer Etching Treatment Technique

    by R. J. Jiang, G. Q. Sang, L. Cao, J. X. Yao, K. Yang, Y. H. Lu, X. X. Zhang, P. Wang, J. J. Li, X. B. He, et al.

    To overcome the critical channel interface issues in gate-all-around (GAA) devices that are induced by germanium (Ge) residue on the nanosheet (NS) channels, a precise quasi-atomic layer etching (qALE) technique based on O 3 was developed in this work. This technique has a self-limited oxidation thickness of 6.1 Å and is able to remove the residual Ge atoms. The improved interface quality leads to a 99% reduction in the interface state density ( Dit ) and a reduction in the current density ( Jg ) of two orders of magnitude. Therefore, the GAA devices fabricated using this method achieve a record low subthreshold swing (SS) of 60.3 mV/dec, with the maximum reduction in the SS reaching up to 21% when compared with that of unprocessed devices after a two-cycle qALE treatment. Moreover, the treatment also results in an enhancement of more than 20% in the on-current ( Ion ) and a 66.7% reduction in the off-current ( Ioff ). These results and the proposed method provide effective technical guidance for improving the interface characteristics, leakage characteristics, and performance of future mass-produced GAA NS field-effect transistors.


  • High-Performance GAA FETs With 100 Ω Parasitic Resistance and 965 μA/μm On-State Current Using Quasi-Self-Aligned Landing Pads

    by R. J. Jiang, P. Wang, J. X. Yao, X. X. Zhang, L. Cao, J. J. Li, G. Q. Sang, X. B. He, N. Zhou, Y. D. Zhang, et al.

    To overcome the challenges posed by the high parasitic resistance and poor driving performance induced by serious epitaxy defects in gate-all-around field-effect transistors (GAA FETs), a quasi-self-aligned landing pads ( QSA LPs ) technique is proposed, and defect-free connections among the multilayer stacked channels and single-crystal SiGe/Si superlattice source/drain (SD) structures are demonstrated in GAA FETs. When compared with devices with widely spaced LPs, reductions of 98.8% and 96.3% in the parasitic SD resistance ( RSD ) are observed for N/PFETs when using the QSA LPs technique, respectively. Therefore, the corresponding on-state current ( Ion ) values are raised to 965 μA/μm and 669 μA/μm for 180 nm gate length N/PFETs, respectively. In addition, no significant changes are observed in the device subthreshold characteristics, including both the subthreshold swing and the on/off current ratios. The proposed scheme offers a new and promising approach to reduce the RSD values and enhance the performance of these advanced GAA devices.


  • Open Access

    Partially Isolated Dual Work Function Gate IGZO TFT With Obviously Reduced Leakage Current for 3D DRAMs

    by Yunjiao Bao, Gangping Yan, Lei Cao, Chuqiao Niu, Qingkun Li, Guanqiao Sang, Lianlian Li, Yanzhao Wei, Xuexiang Zhang, Jie Luo, et al.

    In this article, a partially isolated dual work function (PIDWF) gate In-Ga-Zn-O (IGZO) thin-film transistor (TFT) is proposed to reduce the off-state current (Ioff) obviously, which also provides a feasible integration method for stacking IGZO TFT on Si-based devices. It is found that compared with the general back gate IGZO TFT structure, the Ioff of the proposed IGZO TFT reduces from 2.57×10-14A/μm to 7.57×10-16 A/μm, achieving two orders of magnitude improvement. This breakthrough has the potential to increase the retention time of DRAM applications by nearly 100 times. Moreover, the pronounced novel structure has mitigated parasitic capacitance, thereby leading to a notable 47.7% reduction in write latency within dynamic-random-access-memory (DRAM) circuits. The relevant operation mechanism is carefully demonstrated and verified by the simulation of the electric field and potential barrier results by technical computer-aided design (TCAD). Furthermore, the impacts of the dual gate work function level, the length, and the type of isolation dielectric between dual work function gates are systematically investigated. The results show that the off-state leakage is further reduced by increasing the difference of the work function levels between in dual gates, the dielectric length (LD) and using the isolation layer with a lower dielectric constant. The PIDWF gate IGZO TFT exhibits scalability and is capable of achieving an 84.6% reduction in leakage current even with ultra-short channel lengths, which offers a promising application for future 3D DRAM applications with little extra cost.


  • Hybrid Integration of Gate-All-Around Stacked Si Nanosheet FET and Si/SiGe Super-Lattice FinFET to Optimize 6T-SRAM for N3 Node and Beyond

    by Xuexiang Zhang, Jiaxin Yao, Yanna Luo, Lei Cao, Yantong Zheng, Qingzhu Zhang, Zhenhua Wu, Huaxiang Yin

    The implementation of vertically stacked gate-all-around nanosheet FET (GAA NSFET) may help improve the performance of static random access memory (SRAM) for the design flexibility with variable NS widths. However, the method that often relies on the increasing of device width for higher driving current is to cause an increased SRAM cell area and degrade the scalability of transistor in advanced nodes. In this article, an innovated SRAM bitcell design with hybrid integration of Si NSFET and Si/SiGe super-lattice FinFET (SL-FinFET) in one SRAM cell is proposed for less area and improved performance in 3 nm and beyond nodes. Under the same footprint, p-type SL-FinFET delivers obviously enhanced driving current compared with NSFET and it may yield improved circuit performance for the SRAM cell with natural transistor ratio. The integration process method and the layout schemes for two kinds of typical 6T-SRAM cells, including the high-robustness cell (HI-R Cell) and the high-speed cell (HI-S Cell) with the hybrid integration method, are presented for optimizing high-density (HD) and high-performance (HP) SRAM. As compared with the HD NSFET SRAM cell, the HD HI-R Cell achieves 16.2% improvement in read static noise margin (RSNM) and the HD HI-S Cell achieves 21.6% reduction in read time and 28.6% reduction in write time. The HP hybrid integrated cell even pushes the SRAM cell performance arriving to the theoretical limits of regular NSFETs. Moreover, the hybrid integration scheme may provide another revolutionary method to optimize transistor ratio by adjusting the height of SiGe thickness in the transistors.