Jinhyung Oh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jinhyung Oh has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Jong Ho Kim
Electronics and Telecommunications Research Institute, Daejeon 34129, Republic of Korea
3 shared publications - Young-Keun Yoon
Electronics and Telecommunications Research Institute, Daejeon, Republic of Korea
2 shared publications - Ganguk Hwang
KAIST
1 shared publication - Howon Lee
Ajou University
1 shared publication - Hyun-Ho Choi
School of ICT, Robotic and Mechanical Engineering and the Research Center for Hyper-Connected Convergence Technology, Hankyong National University, Anseong, Republic of Korea
1 shared publication - Jae-Gon Lee
Department of Electrical Engineering, Kyungnam University, Changwon 51767, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 27 August 2025
- Published by MDPI AG in Electronics
- Vol. 14 (17) , 3419
Radio Propagation Characteristics in Several Application Scenarios at 285 GHz Terahertz Band
In this paper, we have derived R.M.S. delay spread characteristics and models according to the influence of antenna beam width in the mobile kiosk data download environment, the inter-rack communication environment in the data center, the intra-device communication environment, and the experimental laboratory measurement environment scenario in the 275 GHz to 295 GHz bands. The measurement system used in this paper used a vector network analyzer and a frequency expander to derive the statistical characteristics of terahertz frequency band signals, and used antennas with different beamwidths for measurement. It is confirmed that the distribution of delay spread varies depending on the beam width of the antenna used for measurement and the type of measurement scenario.
- 27 August 2025
- Published by MDPI AG in Electronics
- Vol. 14 (17) , 3419
Open AccessRadio Propagation Characteristics in Several Application Scenarios at 285 GHz Terahertz Band
In this paper, we have derived R.M.S. delay spread characteristics and models according to the influence of antenna beam width in the mobile kiosk data download environment, the inter-rack communication environment in the data center, the intra-device communication environment, and the experimental laboratory measurement environment scenario in the 275 GHz to 295 GHz bands. The measurement system used in this paper used a vector network analyzer and a frequency expander to derive the statistical characteristics of terahertz frequency band signals, and used antennas with different beamwidths for measurement. It is confirmed that the distribution of delay spread varies depending on the beam width of the antenna used for measurement and the type of measurement scenario.
- Open Access
- 19 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 9
Rain Attenuations Based on Drop Size Distribution (DSD) Model and Empirical Model at Low THz Frequencies
Rain attenuation based on the drop size distribution (DSD) with different rainfall rates (R) at low THz frequencies is investigated in this paper. The rain attenuation is calculated using the DSD measured for one year and the extinction cross-section (ECS) by the Mie scattering theory. Moreover, the obtained specific rain attenuation is verified by the empirical model using the measurement system consisting of a transmitter, a receiver, and weather measurement units. We measured the received power against the uniform transmitted power at 240, 270, and 300 GHz on the rooftop of the National Radio Research Agency (RRA) in Korea during the same period as the DSD measurement period. After curve fitting by regression analysis, we compared both rain attenuations obtained in two methods with the recommendation International Telecommunication Union Radiocommunication Sector (ITU-R) P.838-3. The root mean square errors (RMSEs) of the DSD model are 2.8977, 2.8646, and 2.8331 at 240, 270, and 300 GHz, respectively. The calculated result using the Mie scattering and the measured DSD methods shows the best fit to the data of the ITU-R recommendation for a rainfall rate of up to 5 mm/h. On the other hand, the empirical results using the T/Rx antenna system are slightly higher compared to the data of the ITU-R recommendation. As the rainfall rate increases, the difference between our results and ITU-R recommendation increases. This study will be useful for predicting rain attenuation for terrestrial wireless links operating at low THz frequencies.
- 19 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 9
Open AccessRain Attenuations Based on Drop Size Distribution (DSD) Model and Empirical Model at Low THz Frequencies
Rain attenuation based on the drop size distribution (DSD) with different rainfall rates (R) at low THz frequencies is investigated in this paper. The rain attenuation is calculated using the DSD measured for one year and the extinction cross-section (ECS) by the Mie scattering theory. Moreover, the obtained specific rain attenuation is verified by the empirical model using the measurement system consisting of a transmitter, a receiver, and weather measurement units. We measured the received power against the uniform transmitted power at 240, 270, and 300 GHz on the rooftop of the National Radio Research Agency (RRA) in Korea during the same period as the DSD measurement period. After curve fitting by regression analysis, we compared both rain attenuations obtained in two methods with the recommendation International Telecommunication Union Radiocommunication Sector (ITU-R) P.838-3. The root mean square errors (RMSEs) of the DSD model are 2.8977, 2.8646, and 2.8331 at 240, 270, and 300 GHz, respectively. The calculated result using the Mie scattering and the measured DSD methods shows the best fit to the data of the ITU-R recommendation for a rainfall rate of up to 5 mm/h. On the other hand, the empirical results using the T/Rx antenna system are slightly higher compared to the data of the ITU-R recommendation. As the rainfall rate increases, the difference between our results and ITU-R recommendation increases. This study will be useful for predicting rain attenuation for terrestrial wireless links operating at low THz frequencies.
- 6 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (2) , 568-572
Atmospheric Attenuation Model Using Gaussian Process in Sub-THz Terrestrial Wireless Communications
Atmospheric elements affect signal propagation and cause significant signal loss called atmospheric attenuation, especially in high-frequency range including sub-THz frequencies. Atmospheric attenuation mainly consists of gaseous, fog, and rain attenuation and the traditional approach considers them separately to develop good prediction models. However, the traditional models are not accurate and even unavailable for the high-frequency range such as sub-THz frequencies. In this letter, we propose a new attenuation model to predict atmospheric attenuation for terrestrial line-of-sight (LoS) propagation at high frequencies like sub-THz. The proposed model is based on Gaussian Process Regression (GPR). To train our model with a big measurement dataset, we use a scalable variant of GPR called Blockbox Matrix-Matrix Gaussian Process (BBMM-GP). We validate our model with a dataset obtained from a long-term measurement campaign at sub-THz frequencies. Our experiments show that our model significantly outperforms the existing model. We also show that our model provides reliable prediction intervals of atmospheric attenuation.
- 6 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (2) , 568-572
Atmospheric Attenuation Model Using Gaussian Process in Sub-THz Terrestrial Wireless Communications
Atmospheric elements affect signal propagation and cause significant signal loss called atmospheric attenuation, especially in high-frequency range including sub-THz frequencies. Atmospheric attenuation mainly consists of gaseous, fog, and rain attenuation and the traditional approach considers them separately to develop good prediction models. However, the traditional models are not accurate and even unavailable for the high-frequency range such as sub-THz frequencies. In this letter, we propose a new attenuation model to predict atmospheric attenuation for terrestrial line-of-sight (LoS) propagation at high frequencies like sub-THz. The proposed model is based on Gaussian Process Regression (GPR). To train our model with a big measurement dataset, we use a scalable variant of GPR called Blockbox Matrix-Matrix Gaussian Process (BBMM-GP). We validate our model with a dataset obtained from a long-term measurement campaign at sub-THz frequencies. Our experiments show that our model significantly outperforms the existing model. We also show that our model provides reliable prediction intervals of atmospheric attenuation.
- 23 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 72 (8) , 11080-11085
Idle-Less Slotted ALOHA Protocol for Drone Swarm Identification
In this paper, we modify the slotted ALOHA protocol to quickly identify a swarm of drones in unmanned aerial vehicle (UAV) communication environments. Considering the unreliable UAV channel and the fundamental tradeoff between collision and idle slots in slotted ALOHA, we propose an idle-less slotted ALOHA (ILS-ALOHA) protocol that detects and utilizes idle slots to transmit control messages to drones. In ILS-ALOHA, the ground control station recognizes the idle slot promptly at the beginning of each slot and then transmits acknowledgment (ACK) and beacon messages during the remaining period of the idle slot. Therefore, it can control the access of the drone swarm more adaptively and feed back the ACK to the drones more frequently in an error-prone UAV environment without allocating additional slots. The analysis and simulation results show that the proposed ILS-ALOHA protocol outperforms the conventional slotted ALOHA-based protocols in terms of identification time, channel throughput, and probability of successful identification.
- 23 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 72 (8) , 11080-11085
Idle-Less Slotted ALOHA Protocol for Drone Swarm Identification
In this paper, we modify the slotted ALOHA protocol to quickly identify a swarm of drones in unmanned aerial vehicle (UAV) communication environments. Considering the unreliable UAV channel and the fundamental tradeoff between collision and idle slots in slotted ALOHA, we propose an idle-less slotted ALOHA (ILS-ALOHA) protocol that detects and utilizes idle slots to transmit control messages to drones. In ILS-ALOHA, the ground control station recognizes the idle slot promptly at the beginning of each slot and then transmits acknowledgment (ACK) and beacon messages during the remaining period of the idle slot. Therefore, it can control the access of the drone swarm more adaptively and feed back the ACK to the drones more frequently in an error-prone UAV environment without allocating additional slots. The analysis and simulation results show that the proposed ILS-ALOHA protocol outperforms the conventional slotted ALOHA-based protocols in terms of identification time, channel throughput, and probability of successful identification.