Ruixuan Qi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ruixuan Qi has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Doekle Yntema
Wetsus, Leeuwarden, The Netherlands
5 shared publications - Ming Cao
University of Groningen
5 shared publications - Egge Rouwhorst
Wetsus, Leeuwarden, MA, The Netherlands
1 shared publication Guangda Lei
Wetsus, European centre of excellence for sustainable water technology, Leeuwarden, the Netherlands
1 shared publication
Latest Publications
- 6 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 75 (00189456) , 1-9
Rapid 2-D Complex Capacitance Estimation Enables Real-Time Design of Impedance-Based Sensors
Capacitance underpins a wide spectrum of impedance-based sensors, yet the usual method of using iterative finite-element modeling of frequency-dependent, fringing-field geometries is prohibitively slow. We present a rapid, fully 2-D framework that computes the complex capacitance of arbitrary, polygonal cross sections by combining conformal-mapping theory with a generalized boundary criterion based on material admittance. The method: 1) partitions multilayer structures into homogeneous subdomains; 2) assigns mixed Dirichlet–Neumann boundaries that capture both permittivity and conductivity; and 3) assembles the global capacitance through simple series-and-parallel rules applied to the conformal moduli. Benchmarking against both finite-element method (FEM) (COMSOL) and boundary-element methods (BEMs) shows excellent agreement (<3% deviation). Crucially, our method is orders of magnitude faster (5 s) than FEM (233 s) and BEM (418 s) for a representative coplanar sensor. Canonical test cases with angled or nested interfaces further confirm that the approach remains accurate when conventional partial-capacitance formulas fail. By decoupling speed from mesh density, our technique enables real-time optimization, inverse design, and uncertainty analysis for next-generation touch, flow-cytometry, and quantum-device sensors.
- 6 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 75 (00189456) , 1-9
Rapid 2-D Complex Capacitance Estimation Enables Real-Time Design of Impedance-Based Sensors
Capacitance underpins a wide spectrum of impedance-based sensors, yet the usual method of using iterative finite-element modeling of frequency-dependent, fringing-field geometries is prohibitively slow. We present a rapid, fully 2-D framework that computes the complex capacitance of arbitrary, polygonal cross sections by combining conformal-mapping theory with a generalized boundary criterion based on material admittance. The method: 1) partitions multilayer structures into homogeneous subdomains; 2) assigns mixed Dirichlet–Neumann boundaries that capture both permittivity and conductivity; and 3) assembles the global capacitance through simple series-and-parallel rules applied to the conformal moduli. Benchmarking against both finite-element method (FEM) (COMSOL) and boundary-element methods (BEMs) shows excellent agreement (<3% deviation). Crucially, our method is orders of magnitude faster (5 s) than FEM (233 s) and BEM (418 s) for a representative coplanar sensor. Canonical test cases with angled or nested interfaces further confirm that the approach remains accurate when conventional partial-capacitance formulas fail. By decoupling speed from mesh density, our technique enables real-time optimization, inverse design, and uncertainty analysis for next-generation touch, flow-cytometry, and quantum-device sensors.
- 5 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-8
An Inline Impedance-Based Leakage Detection Method for Nonconducting Buried Water Mains
The ability to detect small leakages in plastic pipes is imperative to ensure water security for the near future, yet it remains challenging. This study seeks to address this challenge by proposing an innovative in-line leakage detection and localization technique based on differences in electrical impedance. The technique is highly sensitive to small leaks, inexpensive, and relatively easy to implement. We analyzed the circuit model to explain the high sensitivity. The model shows that the sensitivity of the sensor for leaks is theoretically very high. Furthermore, a field experiment is presented, validating the detection capability for small leaks (below 0.01 L/s at 0.5 bar) and the localization method. The experiment was conducted using a plastic pipe representative of many that are currently used in the water distribution mains. Finally, the characteristics of the detection signal are shown, and sensor design recommendations are made.
- 5 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-8
An Inline Impedance-Based Leakage Detection Method for Nonconducting Buried Water Mains
The ability to detect small leakages in plastic pipes is imperative to ensure water security for the near future, yet it remains challenging. This study seeks to address this challenge by proposing an innovative in-line leakage detection and localization technique based on differences in electrical impedance. The technique is highly sensitive to small leaks, inexpensive, and relatively easy to implement. We analyzed the circuit model to explain the high sensitivity. The model shows that the sensitivity of the sensor for leaks is theoretically very high. Furthermore, a field experiment is presented, validating the detection capability for small leaks (below 0.01 L/s at 0.5 bar) and the localization method. The experiment was conducted using a plastic pipe representative of many that are currently used in the water distribution mains. Finally, the characteristics of the detection signal are shown, and sensor design recommendations are made.
- 14 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (23) , 39083-39090
Experimental Findings of Underwater Capacitive Imaging
This paper presents experimental findings that highlight the performance improvement and characteristics of capacitive imaging (CI) when used in drinking water. The paper introduced a basic modeling mechanism for CI underwater in the form of a parallel circuit. The expected responses and behavior underwater are then derived. The investigation was then carried out through two experiments. The first experiment compared the CI response in air versus those obtained in water in terms of magnitude and signal-to-noise ratio. The second experiment demonstrated how real and imaginary capacitance can be used to identify different features in a sample. Furthermore, the experimental results were compared to the expected responses using the derived analytical models. These findings can advance the underwater applications of CI sensors and lead to new underwater non-destructive testing and monitoring methods.
- 14 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (23) , 39083-39090
Experimental Findings of Underwater Capacitive Imaging
This paper presents experimental findings that highlight the performance improvement and characteristics of capacitive imaging (CI) when used in drinking water. The paper introduced a basic modeling mechanism for CI underwater in the form of a parallel circuit. The expected responses and behavior underwater are then derived. The investigation was then carried out through two experiments. The first experiment compared the CI response in air versus those obtained in water in terms of magnitude and signal-to-noise ratio. The second experiment demonstrated how real and imaginary capacitance can be used to identify different features in a sample. Furthermore, the experimental results were compared to the expected responses using the derived analytical models. These findings can advance the underwater applications of CI sensors and lead to new underwater non-destructive testing and monitoring methods.
- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Letters
- Vol. 8 (8) , 1-4
Local Maximum Capacitance at Nonzero Lift-Off for Underwater Capacitive Sensing
Despite the popularity of capacitive sensors, limited research exists on their behavior underwater, which can be significantly different than those in air. This letter aims to address this gap by exploring the relationship between capacitance and lift-off distances. Through a combination of experimental investigations and numerical modeling, we identified a novel sensor phenomenon wherein capacitance exhibits a local maximum in response to incremental changes in distance. This resulted in a region with high capacitive sensitivity to distance. We modeled this phenomenon as dielectric losses in water and provided insights into its underlying mechanisms by analyzing capacitance in terms of its real and imaginary terms. We hope our study provides useful insights for future research and engineering applications for capacitive sensors underwater.
- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Letters
- Vol. 8 (8) , 1-4
Local Maximum Capacitance at Nonzero Lift-Off for Underwater Capacitive Sensing
Despite the popularity of capacitive sensors, limited research exists on their behavior underwater, which can be significantly different than those in air. This letter aims to address this gap by exploring the relationship between capacitance and lift-off distances. Through a combination of experimental investigations and numerical modeling, we identified a novel sensor phenomenon wherein capacitance exhibits a local maximum in response to incremental changes in distance. This resulted in a region with high capacitive sensitivity to distance. We modeled this phenomenon as dielectric losses in water and provided insights into its underlying mechanisms by analyzing capacitance in terms of its real and imaginary terms. We hope our study provides useful insights for future research and engineering applications for capacitive sensors underwater.
- 1 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics & Automation Magazine
- Vol. 31 (1) , 108-118
Recent Developments of Subsurface Small-Leak Detection Techniques in Water Distribution Networks: A Review
The urban population grappling with water scarcity is projected to reach two billion people by 2050. Therefore, mitigating leaks in the water distribution networks (WDNs) becomes crucial for better future water security. This review article summarizes the present detection capabilities concerning small leaks (less than 1 L/s). The scope of the review encompasses experiments and simulations carried out using in-pipe robots as well as sensor networks that are capable of continuous monitoring. This aids future research efforts in gaining a clearer understanding of existing detection techniques’ strengths and limitations with small-leak detections.
- 1 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics & Automation Magazine
- Vol. 31 (1) , 108-118
Recent Developments of Subsurface Small-Leak Detection Techniques in Water Distribution Networks: A Review
The urban population grappling with water scarcity is projected to reach two billion people by 2050. Therefore, mitigating leaks in the water distribution networks (WDNs) becomes crucial for better future water security. This review article summarizes the present detection capabilities concerning small leaks (less than 1 L/s). The scope of the review encompasses experiments and simulations carried out using in-pipe robots as well as sensor networks that are capable of continuous monitoring. This aids future research efforts in gaining a clearer understanding of existing detection techniques’ strengths and limitations with small-leak detections.