Jianqiao Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jianqiao Wang has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Chuan Cao
Hubei University
2 shared publicationsMiaoxuan Liu
Hubei University
2 shared publicationsPeng Zhou
Hubei University
2 shared publicationsTianjin Zhang
Hubei University
2 shared publications- Yajun Qi
Ministry of Education Key Laboratory for Green Preparation and Application of Functional Materials, Hubei Provincial Key Laboratory of Polymers, Collaborative Innovation Center for Advanced Organic Chemical Materials Co-Constructed by the Province and Ministry, School of Materials Science and Engineering, Hubei University, Wuhan 430062, China
2 shared publications Bo Wen
1 shared publication
Latest Publications
- Open Access
- 6 January 2026
- Published by Elsevier in The Innovation
- Vol. 7 (5)
Quantum criticality enhanced millikelvin magnetic refrigeration in a large-spin-7/2 triangular lattice antiferromagnet
- 6 January 2026
- Published by Elsevier in The Innovation
- Vol. 7 (5)
Open AccessQuantum criticality enhanced millikelvin magnetic refrigeration in a large-spin-7/2 triangular lattice antiferromagnet
- Open Access
- 30 May 2024
- Published by Wiley
MAPbBr3/P(VDF-TrFE) 复合光纤中界面电容和界面极化的耦合用于超快速和高输出自供电压力传感器
In this work, in-situ synthesized MAPbBr3 quantum dots were introduced as nanofillers to enhance the piezoelectric properties of P(VDF-TrFE) based nanofiber composites. MAPbBr3 quantum dots increased the β-phase content in P(VDF-TrFE) nanofibers from 79 % to 86 % via electrostatic interactions of MA-F groups, which was related to the coupling between interfacial capacitance and interfacial polarization at the interface between MAPbBr3 and P(VDF-TrFE). A high-performance flexible pressure sensor with a sensitivity of up to 1.1 V/kPa and ultra-high responsibility was demonstrated, whose open-circuit voltage up to 35.2 V, a short-circuit current of 6.2 μA and an output power of 188.41 μW were achieved in the composite containing 5% MAPbBr3. The sensor could power 47 commercial LEDs, confirming its self-powered capability. Owing to the distinctive down-conversion effect of MAPbBr3 quantum dots, the UV photodetection ability has been demonstrated and the dual sensing functionality of UV photodetection and pressure detection shows the great potential applications of the sensor in wearable multifunctional devices.
- 30 May 2024
- Published by Wiley
Open AccessMAPbBr3/P(VDF-TrFE) 复合光纤中界面电容和界面极化的耦合用于超快速和高输出自供电压力传感器
In this work, in-situ synthesized MAPbBr3 quantum dots were introduced as nanofillers to enhance the piezoelectric properties of P(VDF-TrFE) based nanofiber composites. MAPbBr3 quantum dots increased the β-phase content in P(VDF-TrFE) nanofibers from 79 % to 86 % via electrostatic interactions of MA-F groups, which was related to the coupling between interfacial capacitance and interfacial polarization at the interface between MAPbBr3 and P(VDF-TrFE). A high-performance flexible pressure sensor with a sensitivity of up to 1.1 V/kPa and ultra-high responsibility was demonstrated, whose open-circuit voltage up to 35.2 V, a short-circuit current of 6.2 μA and an output power of 188.41 μW were achieved in the composite containing 5% MAPbBr3. The sensor could power 47 commercial LEDs, confirming its self-powered capability. Owing to the distinctive down-conversion effect of MAPbBr3 quantum dots, the UV photodetection ability has been demonstrated and the dual sensing functionality of UV photodetection and pressure detection shows the great potential applications of the sensor in wearable multifunctional devices.
- Open Access
- 24 December 2023
- Published by Wiley in Advanced Electronic Materials
- Vol. 10 (4)
Boosting Sensing Performance of Flexible Piezoelectric Pressure Sensors by Sb Nanosheets and BaTiO3 Nanoparticles Co‐Doping in P(VDF‐TrFE) Nanofibers Mat
Flexible piezoelectric pressure sensors (FPPS) received a lot of attention because of their prominent performance in body motion detection and energy recovery. However, it has faced a huge challenge in manufacturing FPPS with high sensitivity, low cost, and high flexibility. Herein, a ternary flexible nanofiber composite with Sb nanosheets and BaTiO3 nanoparticles as the fillers of P(VDF‐TrFE) is prepared by electrospinning. An impressive open‐circuit voltage of 17.1 V and short‐circuit current of 4.4 µA is obtained based on the composite nanofiber mat at a pressure of 128 kPa with 2 Hz frequency. The FPPS not only exhibit a high sensitivity of 96 mV kPa−1 but also an ultrafast response time of 2 ms. Excellent flexibility and reliability are demonstrated by the unchanged open‐circuit voltage after 2400 cycles. The enhanced FPPS performance is owed to the interfacial polarization effect at the inorganic filler‐organic matrix interface, which also enhances the ferroelectric and dielectric properties. The present FPPS is further confirmed to be a real‐time motion monitor and voice recognizer, which can distinguish various actions and sounds according to distinct output voltage signals and is expected to be used in virtual reality devices, robotic electronic skin, haptic simulation, artificial throat, etc.
- 24 December 2023
- Published by Wiley in Advanced Electronic Materials
- Vol. 10 (4)
Open AccessBoosting Sensing Performance of Flexible Piezoelectric Pressure Sensors by Sb Nanosheets and BaTiO3 Nanoparticles Co‐Doping in P(VDF‐TrFE) Nanofibers Mat
Flexible piezoelectric pressure sensors (FPPS) received a lot of attention because of their prominent performance in body motion detection and energy recovery. However, it has faced a huge challenge in manufacturing FPPS with high sensitivity, low cost, and high flexibility. Herein, a ternary flexible nanofiber composite with Sb nanosheets and BaTiO3 nanoparticles as the fillers of P(VDF‐TrFE) is prepared by electrospinning. An impressive open‐circuit voltage of 17.1 V and short‐circuit current of 4.4 µA is obtained based on the composite nanofiber mat at a pressure of 128 kPa with 2 Hz frequency. The FPPS not only exhibit a high sensitivity of 96 mV kPa−1 but also an ultrafast response time of 2 ms. Excellent flexibility and reliability are demonstrated by the unchanged open‐circuit voltage after 2400 cycles. The enhanced FPPS performance is owed to the interfacial polarization effect at the inorganic filler‐organic matrix interface, which also enhances the ferroelectric and dielectric properties. The present FPPS is further confirmed to be a real‐time motion monitor and voice recognizer, which can distinguish various actions and sounds according to distinct output voltage signals and is expected to be used in virtual reality devices, robotic electronic skin, haptic simulation, artificial throat, etc.
- 13 April 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 22377-22385
Enhanced energy harvesting performance via interfacial polarization in ternary piezoelectric composites for self-powered flexible pressure sensing application
- 13 April 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 22377-22385
Enhanced energy harvesting performance via interfacial polarization in ternary piezoelectric composites for self-powered flexible pressure sensing application