Seong-Hyeon Pyo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Seong-Hyeon Pyo has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Alagarsamy Santhana Krishna Kumar
Department of Chemistry, National Sun Yat-sen University, No. 70, Lien-hai Road, Gushan District, Kaohsiung 80424, Taiwan
1 shared publication - Byong-Hun Jeon
Department of Earth Resources and Environmental Engineering Hanyang University Seoul Republic of Korea
1 shared publication - Ho Bum Park
Department of Energy Engineering, Hanyang University, Seoul 04763, Republic of Korea
1 shared publication - Ji-Kwang Cheon
Department of Earth Resources and Environmental Engineering, Hanyang University, 222 Wangsimni-ro, Seongdong-gu, Seoul 04763, South Korea
1 shared publication - Jinho Jung
Division of Environmental Science and Ecological Engineering, Korea University, Seoul 02841, Republic of Korea
1 shared publication - Kalimuthu Pandi
BK21 FOUR R&E Center for Environmental Science and Ecological Engineering, Korea University, 145 Anam-ro, Seongbuk-gu, Seoul 02841, South Korea
1 shared publication
Latest Publications
- 1 May 1998
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 316 (1) , 209-214
Alignment of Liquid-Crystals on Rubbed Polyimide Films Prepared from Various Precursor Polymers
For poly(p-phenylene biphenyltetracarboximide) (BPDA-PDA) and poly(4,4′-oxydiphenylene pyromellitimide) (PMDA-ODA) in films, surface topographies and molecular in-plane orientations were very sensitive to the precursor origins as well as the softbake and imidization processes. Poly(amic diethyl ester) precursor produced higher surface roughness and lower molecular in-plane orientation in the resultant polyimide than the corresponding poly(amic acid). Rapid softbake and imidization process caused relatively high surface roughness and low molecular in-plane orientation in the resultant film. Rougher surface in the film was more favorably rubbed by rubbing process, causing higher pretilt angle in liquid-crystal molecules in contact with the rubbed film.
- 1 May 1998
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 316 (1) , 209-214
Alignment of Liquid-Crystals on Rubbed Polyimide Films Prepared from Various Precursor Polymers
For poly(p-phenylene biphenyltetracarboximide) (BPDA-PDA) and poly(4,4′-oxydiphenylene pyromellitimide) (PMDA-ODA) in films, surface topographies and molecular in-plane orientations were very sensitive to the precursor origins as well as the softbake and imidization processes. Poly(amic diethyl ester) precursor produced higher surface roughness and lower molecular in-plane orientation in the resultant polyimide than the corresponding poly(amic acid). Rapid softbake and imidization process caused relatively high surface roughness and low molecular in-plane orientation in the resultant film. Rougher surface in the film was more favorably rubbed by rubbing process, causing higher pretilt angle in liquid-crystal molecules in contact with the rubbed film.