Ameni Ragoubi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ameni Ragoubi has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Alban Agazzi
Centre Technique Industriel de la Plasturgie et des Composites, 01100 Bellignat, France
1 shared publication - Guillaume Ducloud
Centre Technique Industriel de la Plasturgie et des Composites, 01100 Bellignat, France
1 shared publication - Patrick Dewailly
Technical Center for Plastics and Composites (CT-IPC) Rue Leonard de Vinci 53810 Changé France
1 shared publication - Ronan Le Goff
Centre Technique Industriel de la Plasturgie et des Composites, 2, Rue Pierre et Marie Curie, 01100 Bellignat, France
1 shared publication
Latest Publications
- Open Access
- 8 February 2024
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 8 (1) , 33
Modeling the Thermoforming Process of a Complex Geometry Based on a Thermo-Visco-Hyperelastic Model
The thermoforming process is commonly used in industry for the manufacturing of lightweight, thin-walled products from a pre-extruded polymer sheet. Many simulations have been developed to simulate the process and optimize it with computer tools. The development of testing machines has simplified the simulation of this type of process, allowing researchers to characterize the behavior of the material at different temperatures and for large deformation to be closer to the real conditions of the process. This paper presents the results of a study on the modeling of the thermoforming process for an industrial demonstrator made from a high-impact polystyrene (HIPS) polymer. The HIPS shows a mechanical behavior that depends on the temperature and strain rate. In such conditions, a thermo-hyper-viscoelastic constitutive model is used to replicate the thermoforming process of the industrial demonstrator using ABAQUS/Explicit. Its behavior is determined via various experimental tests: uniaxial tensile tests at different temperatures and strain rates and Dynamic Mechanical Analysis (DMA). A comparison between the numerical and experimental results is carried out for the evolution of film thickness. The paper concludes with a discussion of possible improvements to be considered for future simulations of the thermoforming process using Abaqus, which presents complex challenges in terms of contact and material modeling.
- 8 February 2024
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 8 (1) , 33
Open AccessModeling the Thermoforming Process of a Complex Geometry Based on a Thermo-Visco-Hyperelastic Model
The thermoforming process is commonly used in industry for the manufacturing of lightweight, thin-walled products from a pre-extruded polymer sheet. Many simulations have been developed to simulate the process and optimize it with computer tools. The development of testing machines has simplified the simulation of this type of process, allowing researchers to characterize the behavior of the material at different temperatures and for large deformation to be closer to the real conditions of the process. This paper presents the results of a study on the modeling of the thermoforming process for an industrial demonstrator made from a high-impact polystyrene (HIPS) polymer. The HIPS shows a mechanical behavior that depends on the temperature and strain rate. In such conditions, a thermo-hyper-viscoelastic constitutive model is used to replicate the thermoforming process of the industrial demonstrator using ABAQUS/Explicit. Its behavior is determined via various experimental tests: uniaxial tensile tests at different temperatures and strain rates and Dynamic Mechanical Analysis (DMA). A comparison between the numerical and experimental results is carried out for the evolution of film thickness. The paper concludes with a discussion of possible improvements to be considered for future simulations of the thermoforming process using Abaqus, which presents complex challenges in terms of contact and material modeling.