Chuang Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chuang Zhang has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
Yun Wang
Hubei Longzhong Laboratory, Hubei Key Laboratory of Power System Design and Test for Electrical Vehicle, Hubei University of Arts and Science, Xiangyang 441000, Hubei, P. R. China
5 shared publicationsZhiyong Jia
5 shared publicationsDezheng Liu
3 shared publicationsHao Cheng
3 shared publicationsYing Liang
3 shared publicationsYakun Gao
Hubei Longzhong Laboratory, Hubei Key Laboratory of Power System Design and Test for Electrical Vehicle, Hubei University of Arts and Science, Xiangyang 441000, Hubei, China
2 shared publications
Latest Publications
- 7 October 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 14 (59) , 40825-40835
Interfacial electronic coupling in Cr 2 O 3 @PtRu/C enables highly active and durable hydrogen evolution for high performance AEM water electrolysis
Cr 2 O 3 @PtRu/C enables efficient alkaline HER via interfacial electronic modulation, requiring only 17 mV at 10 mA cm −2 and sustaining AEMWE operation for 1000 h at 1.5 A cm −2 , while suppressing catalyst dissolution.
- 7 October 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 14 (59) , 40825-40835
Interfacial electronic coupling in Cr 2 O 3 @PtRu/C enables highly active and durable hydrogen evolution for high performance AEM water electrolysis
Cr 2 O 3 @PtRu/C enables efficient alkaline HER via interfacial electronic modulation, requiring only 17 mV at 10 mA cm −2 and sustaining AEMWE operation for 1000 h at 1.5 A cm −2 , while suppressing catalyst dissolution.
- 30 May 2026
- Published by World Scientific Pub Co Pte Ltd in Nano
High-Performance Co–N–C Aerogel Catalyst for Efficient and Durable Oxygen Reduction Reactions
Developing efficient and cost-effective oxygen reduction reaction (ORR) catalysts is crucial for advancing clean energy technologies. In this study, the 3D polypyrrole aerogel was synthesized using methyl orange as a soft template. The subsequent in situ spatially confined pyrolysis ensures the atomic dispersion of Co–N[ ] active sites while effectively suppressing metal agglomeration. The optimized CoNC-150 catalyst exhibited a high surface area (298.53[ ]m 2 /g) and well-distributed cobalt-coordinated active sites (Co–N[ ], significantly enhancing ORR performance. Electrochemical evaluations demonstrated an exceptional half-wave potential of 0.886[ ]V, closely approaching that of commercial 20 wt.% Pt/C (0.892[ ]V). The catalyst followed a four-electron transfer pathway, ensuring efficient ORR kinetics. Remarkably, this robust 3D monolithic architecture endows the catalyst with exceptional stability in alkaline media. Long-term durability tests over 40 000 cycles confirmed their remarkable stability, with only a 0.008[ ]V loss in half-wave potential, significantly lower than the 0.022[ ]V loss in Pt/C under similar conditions. The degraded CoNC-150 exhibited a half-wave potential of 0.878[ ]V, significantly outperforming Pt/C (0.870[ ]V). Kinetically, CoNC-150 exhibits a Tafel slope of 146.16 mV/dec, indicating favorable ORR dynamics. These results highlight the potential of CoNC-150 as a highly active and durable nonprecious metal catalyst (NPMC) for ORR applications. This study provides valuable insights into the rational design of transition metal-based electrocatalysts, offering a promising route toward scalable and sustainable energy conversion technologies.
- 30 May 2026
- Published by World Scientific Pub Co Pte Ltd in Nano
High-Performance Co–N–C Aerogel Catalyst for Efficient and Durable Oxygen Reduction Reactions
Developing efficient and cost-effective oxygen reduction reaction (ORR) catalysts is crucial for advancing clean energy technologies. In this study, the 3D polypyrrole aerogel was synthesized using methyl orange as a soft template. The subsequent in situ spatially confined pyrolysis ensures the atomic dispersion of Co–N[ ] active sites while effectively suppressing metal agglomeration. The optimized CoNC-150 catalyst exhibited a high surface area (298.53[ ]m 2 /g) and well-distributed cobalt-coordinated active sites (Co–N[ ], significantly enhancing ORR performance. Electrochemical evaluations demonstrated an exceptional half-wave potential of 0.886[ ]V, closely approaching that of commercial 20 wt.% Pt/C (0.892[ ]V). The catalyst followed a four-electron transfer pathway, ensuring efficient ORR kinetics. Remarkably, this robust 3D monolithic architecture endows the catalyst with exceptional stability in alkaline media. Long-term durability tests over 40 000 cycles confirmed their remarkable stability, with only a 0.008[ ]V loss in half-wave potential, significantly lower than the 0.022[ ]V loss in Pt/C under similar conditions. The degraded CoNC-150 exhibited a half-wave potential of 0.878[ ]V, significantly outperforming Pt/C (0.870[ ]V). Kinetically, CoNC-150 exhibits a Tafel slope of 146.16 mV/dec, indicating favorable ORR dynamics. These results highlight the potential of CoNC-150 as a highly active and durable nonprecious metal catalyst (NPMC) for ORR applications. This study provides valuable insights into the rational design of transition metal-based electrocatalysts, offering a promising route toward scalable and sustainable energy conversion technologies.
- 15 May 2024
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 7 (10) , 11475-11486
Effect of Dual Heat Treatment on the Oxygen Reduction Performance of Nanoparticles of Pt on Carbon Catalysts Prepared by Continuous Flow Microwave Technology
- 15 May 2024
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 7 (10) , 11475-11486
Effect of Dual Heat Treatment on the Oxygen Reduction Performance of Nanoparticles of Pt on Carbon Catalysts Prepared by Continuous Flow Microwave Technology
- Open Access
- 19 January 2024
- Published by Wiley in ChemElectroChem
- Vol. 11 (5)
New Facile Continuous Microwave Pipeline Technology for the Preparation of Highly Stable and Active Carbon‐Supported Platinum Catalyst
Nowadays, the depletion of non‐renewable energy sources has become a prominent issue, and environmental concerns such as air pollution stemming from vehicle emissions have reached a critical stage. In this manuscript, we introduce a novel approach for the fabrication of Pt/C catalysts on a large scale, utilizing a simple, rapid, and continuous pipeline microwave synthesis method. Moreover, we incorporate a heating treatment process in an N2−H2 (5 % H2) environment to enhance the activity and durability of the catalyst. The synthesized Pt/C‐400 catalyst demonstrates an impressive electrochemical active surface area of 103.2 m2/gpt and a mass‐specific activity of 315 mA/mg at a half‐wave potential of 0.9 V. Following 30000 cycles of Pt attenuation testing and 30000 cycles of carrier attenuation testing, the Pt/C‐400 catalyst exhibits a remarkable retention rate of 75 %. Furthermore, based on single‐cell testing, the Pt/C‐400 catalyst achieves a voltage of 0.606 V at a current density of 2000 mA/cm2, surpassing the performance of other Pt/C catalysts discussed in this article. This study presents an efficient and practical method for large‐scale synthesis of high‐performance and durable catalysts. The findings hold significant implications for the commercialization of Proton Exchange Membrane Fuel Cells and contribute to addressing the pressing need for sustainable energy solutions.
- 19 January 2024
- Published by Wiley in ChemElectroChem
- Vol. 11 (5)
Open AccessNew Facile Continuous Microwave Pipeline Technology for the Preparation of Highly Stable and Active Carbon‐Supported Platinum Catalyst
Nowadays, the depletion of non‐renewable energy sources has become a prominent issue, and environmental concerns such as air pollution stemming from vehicle emissions have reached a critical stage. In this manuscript, we introduce a novel approach for the fabrication of Pt/C catalysts on a large scale, utilizing a simple, rapid, and continuous pipeline microwave synthesis method. Moreover, we incorporate a heating treatment process in an N2−H2 (5 % H2) environment to enhance the activity and durability of the catalyst. The synthesized Pt/C‐400 catalyst demonstrates an impressive electrochemical active surface area of 103.2 m2/gpt and a mass‐specific activity of 315 mA/mg at a half‐wave potential of 0.9 V. Following 30000 cycles of Pt attenuation testing and 30000 cycles of carrier attenuation testing, the Pt/C‐400 catalyst exhibits a remarkable retention rate of 75 %. Furthermore, based on single‐cell testing, the Pt/C‐400 catalyst achieves a voltage of 0.606 V at a current density of 2000 mA/cm2, surpassing the performance of other Pt/C catalysts discussed in this article. This study presents an efficient and practical method for large‐scale synthesis of high‐performance and durable catalysts. The findings hold significant implications for the commercialization of Proton Exchange Membrane Fuel Cells and contribute to addressing the pressing need for sustainable energy solutions.