Jinsong Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jinsong Liu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Yidong Tan
Tsinghua University
4 shared publications - Henglin Mu
Tsinghua University
2 shared publications - Xin Xu
Department of Precision Instrument, Tsinghua University, Beijing 100084, China
2 shared publications - Yifan Wang
Tsinghua University
2 shared publications - Mingkuo Hai
Tsinghua University
1 shared publication - Xiaoyang Lin
State Key Laboratory of Precision Measurement Technology and Instruments, Department of Precision Instrument, Tsinghua University, Beijing 100084, China
1 shared publication
Latest Publications
- 31 July 2026
- Published by IOP Publishing in Classical and Quantum Gravity
- Vol. 43 (15) , 155009
Six-degree-of-freedom coupling analysis for the test mass interferometer in spaceborne gravitational wave detection
In spaceborne gravitational wave detection, tilt-to-length (TTL) coupling in the test mass (TM) interferometer can compromise the measurement accuracy and thereby affect the precision of the spacecraft’s position control, ultimately impairing the system’s overall performance in displacement measurement. This paper investigates the six-degree-of-freedom (six-DoF) geometric TTL coupling in the TM interferometer. Since coupling terms involving three or more DoFs are negligible as higher-order infinitesimals, the overall six-DoF coupling can be decomposed into a superposition of single- and dual-DoF coupling components, whose analytical expressions are derived in detail. Based on the six-DoF model, simulation results demonstrate that the angular motions θ x and θ y must be precisely controlled to achieve the required displacement sensitivity, whereas the constraints on the other three non-sensitive DoFs ( Δ x , Δ y , and θ z ) can be moderately relaxed. Furthermore, the effects of non-ideal factors, including large-scale surface shape error, dihedral angle error, and laser pointing error, are also systematically examined. These results may provide a theoretical reference for future ground-based studies and in-orbit verifications of the TM interferometer.
- 31 July 2026
- Published by IOP Publishing in Classical and Quantum Gravity
- Vol. 43 (15) , 155009
Six-degree-of-freedom coupling analysis for the test mass interferometer in spaceborne gravitational wave detection
In spaceborne gravitational wave detection, tilt-to-length (TTL) coupling in the test mass (TM) interferometer can compromise the measurement accuracy and thereby affect the precision of the spacecraft’s position control, ultimately impairing the system’s overall performance in displacement measurement. This paper investigates the six-degree-of-freedom (six-DoF) geometric TTL coupling in the TM interferometer. Since coupling terms involving three or more DoFs are negligible as higher-order infinitesimals, the overall six-DoF coupling can be decomposed into a superposition of single- and dual-DoF coupling components, whose analytical expressions are derived in detail. Based on the six-DoF model, simulation results demonstrate that the angular motions θ x and θ y must be precisely controlled to achieve the required displacement sensitivity, whereas the constraints on the other three non-sensitive DoFs ( Δ x , Δ y , and θ z ) can be moderately relaxed. Furthermore, the effects of non-ideal factors, including large-scale surface shape error, dihedral angle error, and laser pointing error, are also systematically examined. These results may provide a theoretical reference for future ground-based studies and in-orbit verifications of the TM interferometer.
- 10 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (11) , 5166-5173
Laser Feedback OFDR With High Sensitivity
Optical frequency domain reflectometry (OFDR) has been widely used in many fields. Nevertheless, the echo signal in OFDR measurements is usually weak. To enhance echo wave for high signal-to-noise ratio (SNR), the emission power of the laser is typically high. To improve the sensitivity to the echo wave and spatial resolution of OFDR, a laser feedback OFDR(LF-OFDR) system is proposed in this paper. Employing the spontaneous enhancement in laser cavity, LF-OFDR provides an improved SNR of about 27 dB without extra amplifiers compared with the conventional OFDR. Consequently, targets at 1.5 km are detected utilizing only a 0.7 nW probe beam. Employing an auxiliary interferometer to suppress the spectral broadening caused by the nonlinearity of frequency modulation, the signal peaks can be effectively calculated at 1.5 km. The spatial resolution in the range of 1.5 km is 1.53 mm. Advanced in photon consumption and resolution, the proposed method promises more economical and precise development of OFDR.
- 10 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (11) , 5166-5173
Laser Feedback OFDR With High Sensitivity
Optical frequency domain reflectometry (OFDR) has been widely used in many fields. Nevertheless, the echo signal in OFDR measurements is usually weak. To enhance echo wave for high signal-to-noise ratio (SNR), the emission power of the laser is typically high. To improve the sensitivity to the echo wave and spatial resolution of OFDR, a laser feedback OFDR(LF-OFDR) system is proposed in this paper. Employing the spontaneous enhancement in laser cavity, LF-OFDR provides an improved SNR of about 27 dB without extra amplifiers compared with the conventional OFDR. Consequently, targets at 1.5 km are detected utilizing only a 0.7 nW probe beam. Employing an auxiliary interferometer to suppress the spectral broadening caused by the nonlinearity of frequency modulation, the signal peaks can be effectively calculated at 1.5 km. The spatial resolution in the range of 1.5 km is 1.53 mm. Advanced in photon consumption and resolution, the proposed method promises more economical and precise development of OFDR.
- 16 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 73 (00189456) , 1-7
Six-Degrees-of-Freedom Test Mass Readout via Optical Phase-Locking Heterodyne Interferometry
Accurate position and posture measurements of the freely-falling test mass are crucial for the success of spaceborne gravitational wave detection missions. This paper presents a novel laboratory-developed test mass motion readout that utilizes quadrant photodetectors to measure the translation and tilt of a test mass. Departing from conventional methods like Zeeman effect or AOM frequency shift modulation, the readout system employs the phase locking of two lasers to generate the dual-frequency heterodyne source. Notably, the out-of-loop sensitivity of the phase locking reaches below 30 pm/Hz1/2 within the frequency band of 1 mHz and 10 Hz. The system comprises three measurement interferometers and one reference interferometer, featuring a symmetric design that enables measurements of up to six degrees of freedom based on polarization-multiplexing and differential wavefront sensing. Ground-simulated experimental results demonstrate that the proposed system has achieved a measurement sensitivity of 4 pm/Hz1/2 and 2 nrad/Hz1/2 at 1 Hz, a resolution of 5 nm and 0.1 μrad, a range of 200 μm and 600 μrad, respectively. These findings showcase the system’s potential as an alternative method for precisely monitoring the motion of test masses in spaceborne gravitational wave detection missions and other applications requiring accurate positioning and multi-degrees-of-freedom sensing.
- 16 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 73 (00189456) , 1-7
Six-Degrees-of-Freedom Test Mass Readout via Optical Phase-Locking Heterodyne Interferometry
Accurate position and posture measurements of the freely-falling test mass are crucial for the success of spaceborne gravitational wave detection missions. This paper presents a novel laboratory-developed test mass motion readout that utilizes quadrant photodetectors to measure the translation and tilt of a test mass. Departing from conventional methods like Zeeman effect or AOM frequency shift modulation, the readout system employs the phase locking of two lasers to generate the dual-frequency heterodyne source. Notably, the out-of-loop sensitivity of the phase locking reaches below 30 pm/Hz1/2 within the frequency band of 1 mHz and 10 Hz. The system comprises three measurement interferometers and one reference interferometer, featuring a symmetric design that enables measurements of up to six degrees of freedom based on polarization-multiplexing and differential wavefront sensing. Ground-simulated experimental results demonstrate that the proposed system has achieved a measurement sensitivity of 4 pm/Hz1/2 and 2 nrad/Hz1/2 at 1 Hz, a resolution of 5 nm and 0.1 μrad, a range of 200 μm and 600 μrad, respectively. These findings showcase the system’s potential as an alternative method for precisely monitoring the motion of test masses in spaceborne gravitational wave detection missions and other applications requiring accurate positioning and multi-degrees-of-freedom sensing.
- 13 February 2024
- Published by IOP Publishing in Classical and Quantum Gravity
- Vol. 41 (6) , 065008
Tilt-to-length coupling noise suppression based on transformation of q parameters of Gaussian beams in spaceborne gravitational wave detection
Suppression of the coupling of unavoidable angular spacecraft jitter into the longitudinal displacement measurement, known as tilt-to-length (TTL) coupling, is crucial for realizing the required sensitivity of picometer / H z 1 / 2 level within the frequency range of 1 mHz–1 Hz in spaceborne gravitational wave detection. In this paper, we propose a novel method to suppress the TTL coupling between two Gaussian beams demonstrated by simulation. Our approach involves placing a set of lenses with specific focal lengths at proper locations to match the q parameters of the two interfering beams based on our design principle. The results demonstrate a significant reduction in TTL coupling and testify the effectiveness of our proposed approach. TTL coupling factors below 0.21 μ m rad−1 with ideal parameters and below 4.65 μ m rad−1 with focal length error set at 1% as well as installation error (lateral-alignment and longitudinal-alignment errors) set at 10 μ m are achieved for beam tilts within ± 300 μ rad .
- 13 February 2024
- Published by IOP Publishing in Classical and Quantum Gravity
- Vol. 41 (6) , 065008
Tilt-to-length coupling noise suppression based on transformation of q parameters of Gaussian beams in spaceborne gravitational wave detection
Suppression of the coupling of unavoidable angular spacecraft jitter into the longitudinal displacement measurement, known as tilt-to-length (TTL) coupling, is crucial for realizing the required sensitivity of picometer / H z 1 / 2 level within the frequency range of 1 mHz–1 Hz in spaceborne gravitational wave detection. In this paper, we propose a novel method to suppress the TTL coupling between two Gaussian beams demonstrated by simulation. Our approach involves placing a set of lenses with specific focal lengths at proper locations to match the q parameters of the two interfering beams based on our design principle. The results demonstrate a significant reduction in TTL coupling and testify the effectiveness of our proposed approach. TTL coupling factors below 0.21 μ m rad−1 with ideal parameters and below 4.65 μ m rad−1 with focal length error set at 1% as well as installation error (lateral-alignment and longitudinal-alignment errors) set at 10 μ m are achieved for beam tilts within ± 300 μ rad .