Delwyn G. Fredlund
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Delwyn G. Fredlund has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- D. T. Q. Tran
Thurber Engineering Ltd., 180 7330 Fisher St. SE, Calgary, AB, Canada T2H 2H8
2 shared publications AntonioGensA. Gens
School of Engineering, The University of Newcastle, NSW 2308, Australia
1 shared publicationDaichaoShengD. Sheng
School of Engineering, The University of Newcastle, NSW 2308, Australia
1 shared publication- Dave Chan
Professor, Dept. of Civil and Environmental Engineering, Univ. of Alberta, Edmonton, AB, Canada T6G 2W2
1 shared publication - Han Ke
Department of Civil Engineering, Zhejiang University, Hangzhou, China
1 shared publication - Hung Q. Pham1 shared publication
Latest Publications
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in International Journal of Geomechanics
- Vol. 16 (6)
Methodologies for the Calculation of Actual Evaporation in Geotechnical Engineering
The prediction of actual evaporation (AE) is required when calculating the net moisture flux from the ground surface to the atmosphere. The proposed Wilson-Penman equation appeared to yield reasonable predictions of AE from saturated clayey soils but overpredicted AE from coarse-grained soils in arid regions. In recent years, two distinct approaches have emerged for the prediction of AE from unsaturated soil surfaces. Both approaches are based on the realization that evaporation tends to “shut off” as the natural water content approaches residual water content conditions. The first approach to calculate AE from an unsaturated soil involves the adjustment of the total suction at the ground surface. The second approach to calculate AE involves the determination of the “evaporation-rate reduction point” from the drying soil-water characteristic curve. A vapor pressure reduction factor is then applied to calculate AE. Both approaches are attempts to take the effects of “surface resistance” into consid...
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in International Journal of Geomechanics
- Vol. 16 (6)
Methodologies for the Calculation of Actual Evaporation in Geotechnical Engineering
The prediction of actual evaporation (AE) is required when calculating the net moisture flux from the ground surface to the atmosphere. The proposed Wilson-Penman equation appeared to yield reasonable predictions of AE from saturated clayey soils but overpredicted AE from coarse-grained soils in arid regions. In recent years, two distinct approaches have emerged for the prediction of AE from unsaturated soil surfaces. Both approaches are based on the realization that evaporation tends to “shut off” as the natural water content approaches residual water content conditions. The first approach to calculate AE from an unsaturated soil involves the adjustment of the total suction at the ground surface. The second approach to calculate AE involves the determination of the “evaporation-rate reduction point” from the drying soil-water characteristic curve. A vapor pressure reduction factor is then applied to calculate AE. Both approaches are attempts to take the effects of “surface resistance” into consid...
- 24 February 2014
- Published by American Society of Civil Engineers (ASCE)
- p. 4084-4096
Reassessment of Soil Suction at the Evaporation Rate Reduction Point for Saturated-Unsaturated Soil Surfaces
Potential Evaporation, PE, from soils is defined as the water loss through evaporation from a saturated soil surface with ample water. The calculation of actual evaporation, AE, is required when calculating water balance for near-ground-surface engineered situations. AE can be less than PE for a number of reasons. It has been noted that the rate of evaporation begins to depart from the potential rate of evaporation during drying process at distinct soil suction values that are related to the soil-water characteristic curve, SWCC. This paper mainly focuses on reassessment of soil suction and the corresponding water content at which the actual rate of evaporation begins to depart from potential rate of evaporation during drying process using a series of the laboratory data collected from the research literature. It is found that the value of suction at evaporation-rate reduction point appears to be approximately 3,000 kPa for thin soil sections regardless of the soil texture. However, the soil suction appears to be between the air-entry value and residual soil suction for evaporation from soil columns. An empirical equation has been proposed for the determination of the soil suction at the evaporation-rate reduction point in soil columns. Equations are also proposed to calculate the coefficient of surface moisture availability, the vapor pressure, and surface resistance at the soil surface.
- 24 February 2014
- Published by American Society of Civil Engineers (ASCE)
- p. 4084-4096
Reassessment of Soil Suction at the Evaporation Rate Reduction Point for Saturated-Unsaturated Soil Surfaces
Potential Evaporation, PE, from soils is defined as the water loss through evaporation from a saturated soil surface with ample water. The calculation of actual evaporation, AE, is required when calculating water balance for near-ground-surface engineered situations. AE can be less than PE for a number of reasons. It has been noted that the rate of evaporation begins to depart from the potential rate of evaporation during drying process at distinct soil suction values that are related to the soil-water characteristic curve, SWCC. This paper mainly focuses on reassessment of soil suction and the corresponding water content at which the actual rate of evaporation begins to depart from potential rate of evaporation during drying process using a series of the laboratory data collected from the research literature. It is found that the value of suction at evaporation-rate reduction point appears to be approximately 3,000 kPa for thin soil sections regardless of the soil texture. However, the soil suction appears to be between the air-entry value and residual soil suction for evaporation from soil columns. An empirical equation has been proposed for the determination of the soil suction at the evaporation-rate reduction point in soil columns. Equations are also proposed to calculate the coefficient of surface moisture availability, the vapor pressure, and surface resistance at the soil surface.
- 1 May 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 136 (5) , 706-717
Secondary Compression of Municipal Solid Wastes and a Compression Model for Predicting Settlement of Municipal Solid Waste Landfills
The estimation of the capacity and settlement of landfills is critical to successful site operation and future development of a landfill. This paper reports the results of a study on biodegradation behavior and the compression of municipal solid wastes. An experimental apparatus was developed which had a temperature-control system, a leachate recycling system, a loading system, and a gas and liquid collection system. Experiments were performed both with and without optimal biodegradation for comparative purposes. Test results indicated that settlement resulting from creep was relatively insignificant when the biodegradation process was inhibited. Compression due to decomposition under optimal biodegradation conditions was found to be much larger than compression associated with creep. The biodegradation process was significantly influenced by the operational temperature. A one-dimensional model is proposed for calculating settlement and estimating the capacity of the landfill under relatively optimal biod...
- 1 May 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 136 (5) , 706-717
Secondary Compression of Municipal Solid Wastes and a Compression Model for Predicting Settlement of Municipal Solid Waste Landfills
The estimation of the capacity and settlement of landfills is critical to successful site operation and future development of a landfill. This paper reports the results of a study on biodegradation behavior and the compression of municipal solid wastes. An experimental apparatus was developed which had a temperature-control system, a leachate recycling system, a loading system, and a gas and liquid collection system. Experiments were performed both with and without optimal biodegradation for comparative purposes. Test results indicated that settlement resulting from creep was relatively insignificant when the biodegradation process was inhibited. Compression due to decomposition under optimal biodegradation conditions was found to be much larger than compression associated with creep. The biodegradation process was significantly influenced by the operational temperature. A one-dimensional model is proposed for calculating settlement and estimating the capacity of the landfill under relatively optimal biod...
- Top Cited Papers
- 1 April 2008
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 45 (4) , 511-534
A new modelling approach for unsaturated soils using independent stress variables
Although a number of constitutive models for unsaturated soils exist in the literature, some fundamental questions have not been fully answered. There are questions related to (i) the change of the yield stress with soil suction, (ii) modelling slurry soils, and (iii) the smooth transition between saturated and unsaturated soil states. This paper addresses these questions by proposing an alternative modelling approach. The paper first presents a volumetric model for unsaturated soils. This volumetric model is then used to derive the yield surface in the suction – mean stress space. Hysteresis associated with soil-water characteristic curves is then formulated in the same framework of elastoplasticity. It is shown that volume collapse during wetting and plastic shrinkage during initial drying are both direct results of a suction-dependent hardening law. The proposed model seems to be more flexible in modelling different types of unsaturated soils than most models in the literature. The model can be applied to soils that are dried or loaded from initially slurry conditions, for soils that have low to high air-entry values, and for compacted soils as well.
- 1 April 2008
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 45 (4) , 511-534
Top Cited PapersA new modelling approach for unsaturated soils using independent stress variables
Although a number of constitutive models for unsaturated soils exist in the literature, some fundamental questions have not been fully answered. There are questions related to (i) the change of the yield stress with soil suction, (ii) modelling slurry soils, and (iii) the smooth transition between saturated and unsaturated soil states. This paper addresses these questions by proposing an alternative modelling approach. The paper first presents a volumetric model for unsaturated soils. This volumetric model is then used to derive the yield surface in the suction – mean stress space. Hysteresis associated with soil-water characteristic curves is then formulated in the same framework of elastoplasticity. It is shown that volume collapse during wetting and plastic shrinkage during initial drying are both direct results of a suction-dependent hardening law. The proposed model seems to be more flexible in modelling different types of unsaturated soils than most models in the literature. The model can be applied to soils that are dried or loaded from initially slurry conditions, for soils that have low to high air-entry values, and for compacted soils as well.
- 23 May 2007
- Published by Springer Nature
- p. 37-44
Independent Roles of the Stress State Variables on Volume–Mass Constitutive Relations
- 23 May 2007
- Published by Springer Nature
- p. 37-44
Independent Roles of the Stress State Variables on Volume–Mass Constitutive Relations