Rathanawan Magaraphan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rathanawan Magaraphan has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Brian Patrick Grady
University of Oklahoma
1 shared publication - Edgar A. O' Rear
School of Sustainable Chemical, Biological and Materials Engineering, University of Oklahoma, Norman, OK 73019, USA
1 shared publication Hatsuo Ishida
Department of Macromolecular Science, Case Western Reserve University, Cleveland, Ohio 44106, USA
1 shared publication- Johannes Schwank
Department of Chemical Engineering
1 shared publication Kanchana Bunsomsit
The Petroleum and Petrochemical College, Chulalongkorn University, Phthumwan, Bangkok 10330, Thailand
1 shared publicationOrasa Khayankarn
Petroleum and Petrochemical College, Chulalongkorn University, Bangkok 10330, Thailand
1 shared publication
Latest Publications
- 26 June 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (11) , 2875-2881
Adhesion and permeability of polyimide–clay nanocomposite films for protective coatings
A polyimide (PI)–clay nanocomposite was prepared from a solution of poly(amic acid), a precursor of 2,2‐bis[4‐(3,4‐dicarboxyphenoxy)phenyl]propane dianhydride and p‐phenylenediamine, and dodecylamine–montmorillonite. Fourier transform infrared spectroscopy, thermogravimetric analysis, X‐ray diffraction, and atomic absorption spectroscopy were used to verify the incorporation of the modifying agents into the clay structure and the intercalation of the modified clay into the PI matrix. Both PI and PI–clay films were subsequently prepared by solution casting. The gas permeability, resistivity, and adhesion properties were determined. In the case of gas permeability, only a 3 wt % addition of clay reduced oxygen permeability to less than half that of unfilled PI. Furthermore, this hybrid showed an improvement in electrical resistivity because of the prevention of electrical tree growth by clay particles. More importantly, adhesion between the films and silicon increased with increasing clay content. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 2875–2881, 2003
- 26 June 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (11) , 2875-2881
Adhesion and permeability of polyimide–clay nanocomposite films for protective coatings
A polyimide (PI)–clay nanocomposite was prepared from a solution of poly(amic acid), a precursor of 2,2‐bis[4‐(3,4‐dicarboxyphenoxy)phenyl]propane dianhydride and p‐phenylenediamine, and dodecylamine–montmorillonite. Fourier transform infrared spectroscopy, thermogravimetric analysis, X‐ray diffraction, and atomic absorption spectroscopy were used to verify the incorporation of the modifying agents into the clay structure and the intercalation of the modified clay into the PI matrix. Both PI and PI–clay films were subsequently prepared by solution casting. The gas permeability, resistivity, and adhesion properties were determined. In the case of gas permeability, only a 3 wt % addition of clay reduced oxygen permeability to less than half that of unfilled PI. Furthermore, this hybrid showed an improvement in electrical resistivity because of the prevention of electrical tree growth by clay particles. More importantly, adhesion between the films and silicon increased with increasing clay content. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 2875–2881, 2003
- 1 June 2002
- Published by Springer Nature in Colloid and Polymer Science
- Vol. 280 (6) , 509-516
Polypyrrole-coated natural rubber latex by admicellar polymerization
- 1 June 2002
- Published by Springer Nature in Colloid and Polymer Science
- Vol. 280 (6) , 509-516
Polypyrrole-coated natural rubber latex by admicellar polymerization
- 1 January 2001
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 4 (2-3) , 187-196
Preparation and characterization of polybenzoxazine-clay immiscible nanocomposite
An immiscible polymer-clay nanocomposite has been synthesized consisting of dispersed layers of organically modified montmorillonite (OMOM) in a polybenzoxazine matrix as shown by thermogravimetry, wide angle x-ray diffraction (WAXD), and transmission electron microscopy. Five small protonated amines showed high ion-exchangeability. The spacing of the silicate layers is strongly dependent on the size or molecular weight of the amine derivative and the solvent type. Binary solvents (5% mehthanol in toluene) exhibited superior ability to swell OMOM. Finally, WAXD results revealed that the silicate layer expansion of all polybenzoxazine-OMOM nanocomposites prepared from either melt or solution methods were similar, about 4 Å increment. This was correlated with TEM results showing the aggregation of silicate layers indicating that all prepared OMOM are immiscible with the polymer matrix. These results suggested that the compatibility between amine modifying agents and benzoxazine played the most important role for the characteristics of the nanocomposite.
- 1 January 2001
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 4 (2-3) , 187-196
Preparation and characterization of polybenzoxazine-clay immiscible nanocomposite
An immiscible polymer-clay nanocomposite has been synthesized consisting of dispersed layers of organically modified montmorillonite (OMOM) in a polybenzoxazine matrix as shown by thermogravimetry, wide angle x-ray diffraction (WAXD), and transmission electron microscopy. Five small protonated amines showed high ion-exchangeability. The spacing of the silicate layers is strongly dependent on the size or molecular weight of the amine derivative and the solvent type. Binary solvents (5% mehthanol in toluene) exhibited superior ability to swell OMOM. Finally, WAXD results revealed that the silicate layer expansion of all polybenzoxazine-OMOM nanocomposites prepared from either melt or solution methods were similar, about 4 Å increment. This was correlated with TEM results showing the aggregation of silicate layers indicating that all prepared OMOM are immiscible with the polymer matrix. These results suggested that the compatibility between amine modifying agents and benzoxazine played the most important role for the characteristics of the nanocomposite.