Patrick Hanisch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Patrick Hanisch has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Robert Huber
Department of Engineering and Management, Munich University of Applied Sciences HM, Munich, Germany
2 shared publications Andrea Kustermann
Department of Civil Engineering, Munich University of Applied Sciences HM, Munich, Germany
1 shared publicationBrigitte Nagy
Department of Civil Engineering, Munich University of Applied Sciences HM, Munich, Germany
1 shared publicationConstanze Eulenkamp
Department of Applied Sciences and Mechatronics, Munich University of Applied Sciences HM, Munich, Germany
1 shared publication- Franziska Ersoy
Institute of Food Chemistry, Leibniz University Hannover, 30167 Hannover, Germany
1 shared publication Franziska Maier
Geosystems Spezialbaustoffe GmbH, Rohrdorf, Germany
1 shared publication
Latest Publications
- Open Access
- 11 November 2024
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 83 (22) , 1-17
The effect of different additives on bacteria adsorption, compressive strength and ammonia removal for MICP
Microbial induced calcite precipitation is a commonly used technique for the application of biocementation. The metabolism of urea by ureolytic active bacteria leads, among other metabolic products such as ammonium, to carbonate ions. In the presence of calcium ions, calcium carbonate formation occurs. It was investigated whether the addition of different additives (Ca-bentonite, Na-bentonite, clinoptilolite, natrolite, limestone, marl clay, concresol, secursol, and activated carbon powder) can optimize this process. First, the influence of these additives on the adsorption rates and distribution of the ureolytic active organism Sporosarcina pasteurii in quartz sand columns was tested. Moreover, an investigation was conducted on the impact of various additives on ammonium immobilization to mitigate its leaching from soils subjected to the biocementation process. For eight additives uniaxial compressive strength tests in quartz sand columns and a storage method according to DIN EN 12390–2 were carried out. Each additive showed a characteristic adsorption and localisation progression. Furthermore, each additive was able to enhance the immobilization behavior of the present ammonium, with a maximum immobilization capacity of 10.76 $$\frac{mg (NH^+_4)}{g (additive)}$$ . The uniaxial compressive strength of biocemented columns out of quartz sand could sectionally be increased by the addition of each additive. However, the storage methodology shows a much greater influence on column strength. Overall, the best results were achieved with the two additives, Ca-bentonite and clinoptilolite, resulting in strength increases in sand columns of up to 4.64 and 3.22 $$\frac{N}{mm^2}$$ , respectively.- 11 November 2024
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 83 (22) , 1-17
Open AccessThe effect of different additives on bacteria adsorption, compressive strength and ammonia removal for MICP
Microbial induced calcite precipitation is a commonly used technique for the application of biocementation. The metabolism of urea by ureolytic active bacteria leads, among other metabolic products such as ammonium, to carbonate ions. In the presence of calcium ions, calcium carbonate formation occurs. It was investigated whether the addition of different additives (Ca-bentonite, Na-bentonite, clinoptilolite, natrolite, limestone, marl clay, concresol, secursol, and activated carbon powder) can optimize this process. First, the influence of these additives on the adsorption rates and distribution of the ureolytic active organism Sporosarcina pasteurii in quartz sand columns was tested. Moreover, an investigation was conducted on the impact of various additives on ammonium immobilization to mitigate its leaching from soils subjected to the biocementation process. For eight additives uniaxial compressive strength tests in quartz sand columns and a storage method according to DIN EN 12390–2 were carried out. Each additive showed a characteristic adsorption and localisation progression. Furthermore, each additive was able to enhance the immobilization behavior of the present ammonium, with a maximum immobilization capacity of 10.76 $$\frac{mg (NH^+_4)}{g (additive)}$$ . The uniaxial compressive strength of biocemented columns out of quartz sand could sectionally be increased by the addition of each additive. However, the storage methodology shows a much greater influence on column strength. Overall, the best results were achieved with the two additives, Ca-bentonite and clinoptilolite, resulting in strength increases in sand columns of up to 4.64 and 3.22 $$\frac{N}{mm^2}$$ , respectively. - Open Access
- 13 February 2024
- Published by Springer Nature in Applied Microbiology and Biotechnology
- Vol. 108 (1) , 1-12
Squalene production under oxygen limitation by Schizochytrium sp. S31 in different cultivation systems
The triterpene squalene is widely used in the food, cosmetics and pharmaceutical industries due to its antioxidant, antistatic and anti-carcinogenic properties. It is usually obtained from the liver of deep sea sharks, which are facing extinction. Alternative production organisms are marine protists from the family Thraustochytriaceae, which produce and store large quantities of various lipids. Squalene accumulation in thraustochytrids is complex, as it is an intermediate in sterol biosynthesis. Its conversion to squalene 2,3-epoxide is the first step in sterol synthesis and is heavily oxygen dependent. Hence, the oxygen supply during cultivation was investigated in our study. In shake flask cultivations, a reduced oxygen supply led to increased squalene and decreased sterol contents and yields. Oxygen-limited conditions were applied to bioreactor scale, where squalene accumulation and growth of Schizochytrium sp. S31 was determined in batch, fed-batch and continuous cultivation. The highest dry matter (32.03 g/L) was obtained during fed-batch cultivation, whereas batch cultivation yielded the highest biomass productivity (0.2 g/L*h−1). Squalene accumulation benefited from keeping the microorganisms in the growth phase. Therefore, the highest squalene content of 39.67 ± 1.34 mg/g was achieved by continuous cultivation (D = 0.025 h−1) and the highest squalene yield of 1131 mg/L during fed-batch cultivation. Volumetric and specific squalene productivity both reached maxima in the continuous cultivation at D = 0.025 h−1 (6.94 ± 0.27 mg/L*h−1 and 1.00 ± 0.03 mg/g*h−1, respectively). Thus, the choice of a suitable cultivation method under oxygen-limiting conditions depends heavily on the process requirements. Key points: • Measurements of respiratory activity and backscatter light of thraustochytrids • Oxygen limitation increased squalene accumulation in Schizochytrium sp. S31 • Comparison of different cultivation methods under oxygen-limiting conditions
- 13 February 2024
- Published by Springer Nature in Applied Microbiology and Biotechnology
- Vol. 108 (1) , 1-12
Open AccessSqualene production under oxygen limitation by Schizochytrium sp. S31 in different cultivation systems
The triterpene squalene is widely used in the food, cosmetics and pharmaceutical industries due to its antioxidant, antistatic and anti-carcinogenic properties. It is usually obtained from the liver of deep sea sharks, which are facing extinction. Alternative production organisms are marine protists from the family Thraustochytriaceae, which produce and store large quantities of various lipids. Squalene accumulation in thraustochytrids is complex, as it is an intermediate in sterol biosynthesis. Its conversion to squalene 2,3-epoxide is the first step in sterol synthesis and is heavily oxygen dependent. Hence, the oxygen supply during cultivation was investigated in our study. In shake flask cultivations, a reduced oxygen supply led to increased squalene and decreased sterol contents and yields. Oxygen-limited conditions were applied to bioreactor scale, where squalene accumulation and growth of Schizochytrium sp. S31 was determined in batch, fed-batch and continuous cultivation. The highest dry matter (32.03 g/L) was obtained during fed-batch cultivation, whereas batch cultivation yielded the highest biomass productivity (0.2 g/L*h−1). Squalene accumulation benefited from keeping the microorganisms in the growth phase. Therefore, the highest squalene content of 39.67 ± 1.34 mg/g was achieved by continuous cultivation (D = 0.025 h−1) and the highest squalene yield of 1131 mg/L during fed-batch cultivation. Volumetric and specific squalene productivity both reached maxima in the continuous cultivation at D = 0.025 h−1 (6.94 ± 0.27 mg/L*h−1 and 1.00 ± 0.03 mg/g*h−1, respectively). Thus, the choice of a suitable cultivation method under oxygen-limiting conditions depends heavily on the process requirements. Key points: • Measurements of respiratory activity and backscatter light of thraustochytrids • Oxygen limitation increased squalene accumulation in Schizochytrium sp. S31 • Comparison of different cultivation methods under oxygen-limiting conditions