BLBingchang Liu

Bingchang Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bingchang Liu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Hui Zheng

    Shandong Provincial University Laboratory for Protected Horticulture, Weifang University of Science and Technology, Weifang 262700, China

    1 shared publication
  • Qiang Li

    Shandong Engineering Research Center of Green and High-Value Marine Fine Chemical, Weifang University of Science and Technology, Shouguang, People’s Republic of China

    1 shared publication
  • Shuming Guo

    Shandong Provincial University Laboratory for Protected Horticulture, Weifang University of Science and Technology, Weifang 262700, China

    1 shared publication
  • Xiaojing Fu

    School of Mechanical and Electrical Engineering, Weifang University of Science and Technology, Weifang 262700, China

    1 shared publication
  • Yong Wan

    School of Mechanical Engineering Qilu University of Technology (Shandong Academy of Sciences) Jinan P. R. China

    1 shared publication

Latest Publications

  • Open Access

    Influence of the Nitrogen Flux Ratio on the Structural, Morphological and Tribological Properties of TiN Coatings

    by Xiaojing Fu, Shuming Guo, Yong Wan, Qiang Li, Bingchang Liu, Hui Zheng

    In this study, the structural characteristics of TiN coatings deposited by DC magnetron sputtering on the surface of AISI 304 stainless steel were modulated by performing deposition at four different nitrogen flux ratios. The XRD results indicated that the coatings mainly contained face-centered cubic TiN phase. The experimental results showed that the nitrogen flux ratio played a major role in determining the microstructure and the mechanical and tribological properties of the TiN coatings. SEM images revealed that the thickness of the TiN coatings decreased linearly as the nitrogen flux ratio increased from 0.25 to 0.55. However, the grain size had a nonlinear relationship with the nitrogen flux ratio. When the nitrogen flux ratio was 0.45, the grain size was only 5.3 nm. Theoretical and experimental analysis showed that the TiN coating deposited at a nitrogen flux ratio of 0.45 had the best mechanical properties, which due to its minimum grain size and (111) orientation, and the best tribological performance under unlubricated conditions, may have been due to its higher fracture toughness and plastic deformation resistance among the four TiN coatings.