Christina N. Pierson
Christina N. Pierson has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- John Frederick Hartwig
Lawrence Berkeley National Laboratory
3 shared publications - Guodong Rao
University of California
2 shared publications - R. David Britt
University of California
2 shared publications - Serena Fantasia
Pharmaceutical Division, Synthetic Molecules Technical Development, Process Chemistry and Catalysis
2 shared publications Stephan M. Rummelt
Pharmaceutical Division, Synthetic Molecules Technical Development, Process Chemistry and Catalysis
2 shared publications- Willi M. Amberg
Department of Chemistry
2 shared publications
Latest Publications
- Open Access
- 16 February 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (7) , 7505-7514
Mechanism-Inspired Ligand Design for Efficient Copper-Catalyzed C–N Coupling of Aryl and Heteroaryl Chlorides
Cross-coupling reactions to form C-N bonds catalyzed by copper are becoming sustainable and cost-effective alternatives to those catalyzed by palladium. An array of ligand classes has been reported over the past two decades to create copper catalysts that couple aryl iodides and bromides. However, these systems typically require higher catalyst loadings than are required for palladium, and the couplings of aryl chlorides catalyzed by copper complexes require particularly high loadings, high temperatures, or both. We report a catalytic system designed to destabilize the bis-ligated copper(II) oxalamide complexes that are the major species in reactions of aryl bromides catalyzed by complexes of oxalamide ligands. A sterically hindered oxalamide ligand in combination with Cu(I) or Cu(II) leads to the coupling of aryl and heteroaryl chlorides with a set of primary amines, as well as aqueous ammonia, under mild conditions at low catalyst loadings (0.03-1 mol %) with turnover numbers up to 2300. Mechanistic studies reveal that increased steric bulk on the amide causes a monoligated copper species with a Cu(I) oxidation state to be the major copper complex in the reactions of aryl chlorides. Both Cu(I) and Cu(II) amine complexes containing this oxalamide have been isolated, structurally characterized, and observed in the catalytic systems by EPR and NMR spectroscopy. Initial kinetic studies indicate that oxidative addition to the amine complex is rate limiting, and the identity of the halide on the aryl halide (Cl vs Br) changes the oxidation state of the major copper species in solution.
- 16 February 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (7) , 7505-7514
Open AccessMechanism-Inspired Ligand Design for Efficient Copper-Catalyzed C–N Coupling of Aryl and Heteroaryl Chlorides
Cross-coupling reactions to form C-N bonds catalyzed by copper are becoming sustainable and cost-effective alternatives to those catalyzed by palladium. An array of ligand classes has been reported over the past two decades to create copper catalysts that couple aryl iodides and bromides. However, these systems typically require higher catalyst loadings than are required for palladium, and the couplings of aryl chlorides catalyzed by copper complexes require particularly high loadings, high temperatures, or both. We report a catalytic system designed to destabilize the bis-ligated copper(II) oxalamide complexes that are the major species in reactions of aryl bromides catalyzed by complexes of oxalamide ligands. A sterically hindered oxalamide ligand in combination with Cu(I) or Cu(II) leads to the coupling of aryl and heteroaryl chlorides with a set of primary amines, as well as aqueous ammonia, under mild conditions at low catalyst loadings (0.03-1 mol %) with turnover numbers up to 2300. Mechanistic studies reveal that increased steric bulk on the amide causes a monoligated copper species with a Cu(I) oxidation state to be the major copper complex in the reactions of aryl chlorides. Both Cu(I) and Cu(II) amine complexes containing this oxalamide have been isolated, structurally characterized, and observed in the catalytic systems by EPR and NMR spectroscopy. Initial kinetic studies indicate that oxidative addition to the amine complex is rate limiting, and the identity of the halide on the aryl halide (Cl vs Br) changes the oxidation state of the major copper species in solution.
- 9 June 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 147 (24) , 20939-20946
Efficient Aminations of Aryl Halides by a Cu(II) Catalyst
Aminations of aryl halides catalyzed by copper complexes with ancillary ligands have become valuable for the formation of anilines, and the mechanisms for these reactions have been shown to occur by a Cu(I)/(III) cycle. We show that the coupling of aryl and heteroaryl bromides with a range of nitrogen nucleophiles, including hydrazine hydrate and complex amines, occurs with copper and a simple dianionic, dimethylpyrrole-based oxalohydrazido ligand by a cycle in which Cu(II) complexes of this ligand are the resting state and an active, low-valent, catalytic intermediate. These couplings involving Cu(II) occur in many cases with just 0.1-0.2 mol % catalyst and take place under air, due to the absence of Cu(I) that is less stable to disproportionation and to air. Kinetic profiles and EPR spectroscopy of reactions initiated with Cu(I) and Cu(II) precursors provide strong evidence that both systems react through an active Cu(II) complex, thereby indicating that a recently uncovered mechanistic manifold for copper-catalyzed couplings of phenoxides with oxalamide ligands is also followed for the coupling of nitrogen nucleophiles catalyzed by copper complexes of oxalohydrazido ligands.
- 9 June 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 147 (24) , 20939-20946
Efficient Aminations of Aryl Halides by a Cu(II) Catalyst
Aminations of aryl halides catalyzed by copper complexes with ancillary ligands have become valuable for the formation of anilines, and the mechanisms for these reactions have been shown to occur by a Cu(I)/(III) cycle. We show that the coupling of aryl and heteroaryl bromides with a range of nitrogen nucleophiles, including hydrazine hydrate and complex amines, occurs with copper and a simple dianionic, dimethylpyrrole-based oxalohydrazido ligand by a cycle in which Cu(II) complexes of this ligand are the resting state and an active, low-valent, catalytic intermediate. These couplings involving Cu(II) occur in many cases with just 0.1-0.2 mol % catalyst and take place under air, due to the absence of Cu(I) that is less stable to disproportionation and to air. Kinetic profiles and EPR spectroscopy of reactions initiated with Cu(I) and Cu(II) precursors provide strong evidence that both systems react through an active Cu(II) complex, thereby indicating that a recently uncovered mechanistic manifold for copper-catalyzed couplings of phenoxides with oxalamide ligands is also followed for the coupling of nitrogen nucleophiles catalyzed by copper complexes of oxalohydrazido ligands.
- 14 February 2024
- Published by Springer Nature in Nature Chemistry
- Vol. 16 (6) , 930-937
Mapping the mechanisms of oxidative addition in cross-coupling reactions catalysed by phosphine-ligated Ni(0)
The complexes of first-row transition metals can undergo elementary reactions by multiple pathways due to their propensity to undergo both one- and two-electron redox steps. Classic and recent studies of the oxidative addition of aryl halides to Ni(0)—a common step in widely practised cross-coupling processes—have yielded contradictory conclusions about stepwise, radical versus concerted mechanisms, but such information is crucial to the design of catalysts based on earth-abundant metals. Here we show that the oxidative addition of aryl halides to Ni(0) ligated by monophosphines occurs by both mechanisms and delineate how the branching of radical and non-radical pathways depends on the electronic properties of both the ligand and reactant arene as well as the identity of the halide. The one-electron pathway occurs by outer-sphere electron transfer to form an aryl radical rather than the often-proposed halogen atom transfer.
- 14 February 2024
- Published by Springer Nature in Nature Chemistry
- Vol. 16 (6) , 930-937
Mapping the mechanisms of oxidative addition in cross-coupling reactions catalysed by phosphine-ligated Ni(0)
The complexes of first-row transition metals can undergo elementary reactions by multiple pathways due to their propensity to undergo both one- and two-electron redox steps. Classic and recent studies of the oxidative addition of aryl halides to Ni(0)—a common step in widely practised cross-coupling processes—have yielded contradictory conclusions about stepwise, radical versus concerted mechanisms, but such information is crucial to the design of catalysts based on earth-abundant metals. Here we show that the oxidative addition of aryl halides to Ni(0) ligated by monophosphines occurs by both mechanisms and delineate how the branching of radical and non-radical pathways depends on the electronic properties of both the ligand and reactant arene as well as the identity of the halide. The one-electron pathway occurs by outer-sphere electron transfer to form an aryl radical rather than the often-proposed halogen atom transfer.