Leoš Petržílka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Leoš Petržílka has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jana Olivová
Department of Communication Technologies, Electronic Warfare and Radars, University of Defence in Brno, 66210 Brno, Czech Republic
1 shared publication - Michaela Krchova
Department of Mechanical Engineering, University of Defence, Brno, Czech Republic
1 shared publication - Miroslav Popela
Brno University of Technology,Department of Radio Electronics,Brno,Czech Republic
1 shared publication - Premysl Janu
Department of Radar Technology, Faculty of Military Technology, University of Defence, Brno, Czech Republic
1 shared publication - Zdenek Joska
Department of Mechanical Engineering, Faculty of Military Technology, University of Defence, 662 10 Brno, Czech Republic
1 shared publication - Zdenek Pliva
Institute of Information Technology and Electronics, Faculty of Mechatronics, Informatics and Interdisciplinary Studies, Technical University of Liberec, Studentska 2/1402, Czech Republic
1 shared publication
Latest Publications
- Open Access
- 15 February 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (4) , 1556
A Novel Approach to the Production of Printed Patch Antennas
This paper presents the manufacturing of a patch antenna using an advanced 3D printing technology called lights-out digital additive manufacturing (LDM). This 3D LDM printing technology is mainly used for printing circuit boards (PCBs); however, it has also been used to print a patch antenna from conductive (CI) and dielectric ink (DI). This 3D LDM-printed antenna was compared with antennas on different dielectric substrates (Arlon 25N and FR4). The obtained results are compared and analyzed in this paper.
- 15 February 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (4) , 1556
Open AccessA Novel Approach to the Production of Printed Patch Antennas
This paper presents the manufacturing of a patch antenna using an advanced 3D printing technology called lights-out digital additive manufacturing (LDM). This 3D LDM printing technology is mainly used for printing circuit boards (PCBs); however, it has also been used to print a patch antenna from conductive (CI) and dielectric ink (DI). This 3D LDM-printed antenna was compared with antennas on different dielectric substrates (Arlon 25N and FR4). The obtained results are compared and analyzed in this paper.