Igor Danilov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Igor Danilov has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
A Khodyakov
Peoples' Friendship University of Russia (RUDN University), Moscow, Russia
2 shared publicationsS Khlopkov
Peoples' Friendship University of Russia (RUDN University), Moscow, Russia
2 shared publicationsYu Danilov
Peoples' Friendship University of Russia (RUDN University), Moscow, Russia
2 shared publicationsA Teplinsky
Peoples' Friendship University of Russia (RUDN University), Moscow, Russia
1 shared publicationE Abdulina
Samara State University of Railway Transport, Saratov, Russia
1 shared publication- Erfan Maleki
Mechanical Engineering Department, Politecnico di Milano, 20156 Milan, Italy
1 shared publication
Latest Publications
- Open Access
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 3009 (1)
Comparing urban street performance in and after Covid-19 in Karbala city
The religious and economic importance of Karbala city motivated comparison research to examine the traffic performance of the urban city roads network during the Covid-19 and after period, therefore it was necessary to comprehend the urban city roads network. The research region consists of four major urban streets separated into many segments, with the average travel time for all segments serving as performance indicators. The aim of this study is to investigate the impact of the Corona pandemic on the performance of traffic in urban streets of Karbala city and investigate the traffic performance after the pandemic. The roads were evaluated after being classified according to the Highway Capacity Manual (HCM) 2000, 2010 based on the observed Free-Flow Speed (FFS). The level of service (LOS) for each segment is then determined based on the specified average travel speed. The findings demonstrate that during the Corona epidemic, most nations implemented obligatory quarantine at home and restricted or curtailed people and traffic movement on several highways, resulting in less travel time during Covid-19 than after Covid-19. However, the authors discovered that the average travel time during Covid-19 increased only in Al-Abbas Street (Sections 1, 2 and 5) and Fatima Al-Zahra Street (Sections 3, 4 and 5). The average travel speed was found to be lower on several road segments during the Covid-19 period, including Al-Abbas Street (Segments 1, 2, 3, and 5), and Fatima Al-Zahra Street (Sections 1, and 5). In Al-Abbas Street (Segment 6), Fatima Al-Zahraa Street (Segments 2 and 4), Al-Iskan Street (Segment 2), and Ramadan Street (Segment 1), the level of service (LOS) improved compared to the post-Covid-19 period.
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 3009 (1)
Open AccessComparing urban street performance in and after Covid-19 in Karbala city
The religious and economic importance of Karbala city motivated comparison research to examine the traffic performance of the urban city roads network during the Covid-19 and after period, therefore it was necessary to comprehend the urban city roads network. The research region consists of four major urban streets separated into many segments, with the average travel time for all segments serving as performance indicators. The aim of this study is to investigate the impact of the Corona pandemic on the performance of traffic in urban streets of Karbala city and investigate the traffic performance after the pandemic. The roads were evaluated after being classified according to the Highway Capacity Manual (HCM) 2000, 2010 based on the observed Free-Flow Speed (FFS). The level of service (LOS) for each segment is then determined based on the specified average travel speed. The findings demonstrate that during the Corona epidemic, most nations implemented obligatory quarantine at home and restricted or curtailed people and traffic movement on several highways, resulting in less travel time during Covid-19 than after Covid-19. However, the authors discovered that the average travel time during Covid-19 increased only in Al-Abbas Street (Sections 1, 2 and 5) and Fatima Al-Zahra Street (Sections 3, 4 and 5). The average travel speed was found to be lower on several road segments during the Covid-19 period, including Al-Abbas Street (Segments 1, 2, 3, and 5), and Fatima Al-Zahra Street (Sections 1, and 5). In Al-Abbas Street (Segment 6), Fatima Al-Zahraa Street (Segments 2 and 4), Al-Iskan Street (Segment 2), and Ramadan Street (Segment 1), the level of service (LOS) improved compared to the post-Covid-19 period.
- Open Access
- 19 January 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (2) , 128
Application of Deep Neural Network to Predict the High-Cycle Fatigue Life of AISI 1045 Steel Coated by Industrial Coatings
In this study, deep learning approach was utilized for fatigue behavior prediction, analysis, and optimization of the coated AISI 1045 mild carbon steel with galvanization, hardened chromium, and nickel materials with different thicknesses of 13 and 19 µm were used for coatings and afterward fatigue behavior of related specimens were achieved via rotating bending fatigue test. Experimental results revealed fatigue life improvement up to 60% after applying galvanization coat on untreated material. Obtained experimental data were used for developing a Deep Neural Network (DNN) modelling and accuracy of more than 99%.was achieved. Predicted results have a fine agreement with experiments. In addition, parametric analysis was carried out for optimization which indicated that coating thickness of 10–15 µm had the highest effects on fatigue life improvement.
- 19 January 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (2) , 128
Open AccessApplication of Deep Neural Network to Predict the High-Cycle Fatigue Life of AISI 1045 Steel Coated by Industrial Coatings
In this study, deep learning approach was utilized for fatigue behavior prediction, analysis, and optimization of the coated AISI 1045 mild carbon steel with galvanization, hardened chromium, and nickel materials with different thicknesses of 13 and 19 µm were used for coatings and afterward fatigue behavior of related specimens were achieved via rotating bending fatigue test. Experimental results revealed fatigue life improvement up to 60% after applying galvanization coat on untreated material. Obtained experimental data were used for developing a Deep Neural Network (DNN) modelling and accuracy of more than 99%.was achieved. Predicted results have a fine agreement with experiments. In addition, parametric analysis was carried out for optimization which indicated that coating thickness of 10–15 µm had the highest effects on fatigue life improvement.
- Open Access
- 1 November 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1687 (1) , 012021
Influence of electromagnetic atomizers’ technical condition on power and ecological indicators of gasoline I.C.E. in operation
Productivity of electromagnetic atomizers (EMA) of gasoline engines has been defined. It is established that EMA productivity removed from engine with an operating time of 30-60 thousand km, as well as new atomizers after their washing by ultrasound can change both productivity growth and its decrease. It is shown that the content of PCO and CH in the exhaust gases of car GAZ-27040 V (run of 30 thousand km) at engine work (on idling turns) with washed MA is below concentration of the specified toxic components in exhaust gases of the motor completed by unwashed ultrasound EMA It is established that the difference in compared values of capacity and a torque, obtained in testing on dynamometric stand (subroutine Pmax, for the EMA engine before processing by ultrasound) is not significant. In the tests conducted in subroutine Vconst, the gain of capacity of the EMA engine washed out by ultrasound has been 0.04 MJ·km−1 (1.71 %).
- 1 November 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1687 (1) , 012021
Open AccessInfluence of electromagnetic atomizers’ technical condition on power and ecological indicators of gasoline I.C.E. in operation
Productivity of electromagnetic atomizers (EMA) of gasoline engines has been defined. It is established that EMA productivity removed from engine with an operating time of 30-60 thousand km, as well as new atomizers after their washing by ultrasound can change both productivity growth and its decrease. It is shown that the content of PCO and CH in the exhaust gases of car GAZ-27040 V (run of 30 thousand km) at engine work (on idling turns) with washed MA is below concentration of the specified toxic components in exhaust gases of the motor completed by unwashed ultrasound EMA It is established that the difference in compared values of capacity and a torque, obtained in testing on dynamometric stand (subroutine Pmax, for the EMA engine before processing by ultrasound) is not significant. In the tests conducted in subroutine Vconst, the gain of capacity of the EMA engine washed out by ultrasound has been 0.04 MJ·km−1 (1.71 %).
- Open Access
- 1 November 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1687 (1) , 012022
Pressurization influence on power and ecological indication of the petrol engine
Indicated on dynamometric stand LPS 2510 dependences of the engine power and a torque on the crankshaft frequency have been presented in the article. The car VAZ 2123 “Chevrolet Niva” (without catalytic converter) and the engine VAZ 21214 with the mechanical supercharger (compressor) PK-23 have been tested. It is established that configuration of the engine with the compressor has allowed not only to restore the lost power of the motor as a result of extended operation, but also to increase it. It is shown that the content of carbon monoxide and products of incomplete combustion of hydrocarbons in the exhaust gases does not exceed standard values of volume fractions of CO and CH. It is established that registered by the indicator of OKTAN values of gasoline are identical to those declared by the manufacturer.
- 1 November 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1687 (1) , 012022
Open AccessPressurization influence on power and ecological indication of the petrol engine
Indicated on dynamometric stand LPS 2510 dependences of the engine power and a torque on the crankshaft frequency have been presented in the article. The car VAZ 2123 “Chevrolet Niva” (without catalytic converter) and the engine VAZ 21214 with the mechanical supercharger (compressor) PK-23 have been tested. It is established that configuration of the engine with the compressor has allowed not only to restore the lost power of the motor as a result of extended operation, but also to increase it. It is shown that the content of carbon monoxide and products of incomplete combustion of hydrocarbons in the exhaust gases does not exceed standard values of volume fractions of CO and CH. It is established that registered by the indicator of OKTAN values of gasoline are identical to those declared by the manufacturer.
- Open Access
- 1 November 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 675 (1) , 012047
Optimization of work of urban passenger transport
Recommendations for improving the organization of the logistics system of urban passenger traffic based on the formation of adaptive properties proposed. Definitions of organization and lack of organization of the system, target entropy, orderliness, disorder are considered. The calculation of these indicators allows us to conclude how the company is adapted to the external environment. An important feature of all production systems is the focus of their functioning. If such a system is functioning, it means, first of all, that it solves a finite set of tasks to ensure the adaptability of the urban passenger traffic management system to the flow of passengers and with a certain accuracy the goals of organization and management, of which there is also a finite set. The authors come to a fair conclusion that the lack of organization of functioning is a consequence of the influence of the external environment on the control object, while organization is a quantitative measure of the ability of the system to adapt to the effects of environmental factors. The indicator of organization can be proposed as a criterion that assesses the efficiency of the urban passenger transport system. The worse the internal structures are organized, the less efficiently the control system works and the more mobile and uncertain the external environment, the greater the discrepancy between the goal and the final result.
- 1 November 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 675 (1) , 012047
Open AccessOptimization of work of urban passenger transport
Recommendations for improving the organization of the logistics system of urban passenger traffic based on the formation of adaptive properties proposed. Definitions of organization and lack of organization of the system, target entropy, orderliness, disorder are considered. The calculation of these indicators allows us to conclude how the company is adapted to the external environment. An important feature of all production systems is the focus of their functioning. If such a system is functioning, it means, first of all, that it solves a finite set of tasks to ensure the adaptability of the urban passenger traffic management system to the flow of passengers and with a certain accuracy the goals of organization and management, of which there is also a finite set. The authors come to a fair conclusion that the lack of organization of functioning is a consequence of the influence of the external environment on the control object, while organization is a quantitative measure of the ability of the system to adapt to the effects of environmental factors. The indicator of organization can be proposed as a criterion that assesses the efficiency of the urban passenger transport system. The worse the internal structures are organized, the less efficiently the control system works and the more mobile and uncertain the external environment, the greater the discrepancy between the goal and the final result.