Maria Fernanda Villa-Bracamonte
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Maria Fernanda Villa-Bracamonte has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Jose Raul Montes-Bojorquez
University of Texas at San Antonio
4 shared publications Arturo A. Ayon
2 shared publicationsAlan Lopez-Becerra
The University of Texas at San Antonio,San Antonio,TX,United States
1 shared publicationArturo A Ayon
Department of Physics and Astronomy, University of Texas at San Antonio, San Antonio, United States of America
1 shared publication- Arturo A. Ayon
University of Texas at San Antonio
1 shared publication - Kevin J Knebel
Department of Physics and Astronomy, University of Texas at San Antonio, San Antonio, United States of America
1 shared publication
Latest Publications
- Open Access
- 11 March 2026
- Published by IOP Publishing in Materials Research Express
- Vol. 13 (5) , 056401
CuInS 2 quantum dots for the performance enhancement in commercial Si solar cells
Silicon-based solar cells dominate the photovoltaic market but face efficiency limits from incomplete use of the solar spectrum. This study explores CuInS 2 quantum-dot (QD) thin films, applied by spin-coating as spectral conversion layers to boost device performance. We systematically investigated how spin speed, varied between 2000 and 6000 rpm, determines film thickness (78 −54 nm) and power conversion efficiency. QD-only coatings delivered efficiency gains ranging from 0.9%–2.2%, while PMMA–QD composite films produced 1.1%–3.7% improvements, with the most consistent results observed for thinner films produced at higher spin speeds. The CuInS 2 QDs displayed strong ultraviolet absorption, while their broad visible photoluminescence centered near 660 nm aligns with the silicon spectral response. Incorporating QDs into a PMMA matrix enhanced coating reproducibility while preserving efficiency benefits, confirming the QDs as the primary source of performance gains. These findings demonstrate that spin-coated CuInS 2 QD layers, either standalone or embedded in a polymer matrix, offer a scalable, eco-friendly strategy for improving commercial silicon solar cell efficiency.
- 11 March 2026
- Published by IOP Publishing in Materials Research Express
- Vol. 13 (5) , 056401
Open AccessCuInS 2 quantum dots for the performance enhancement in commercial Si solar cells
Silicon-based solar cells dominate the photovoltaic market but face efficiency limits from incomplete use of the solar spectrum. This study explores CuInS 2 quantum-dot (QD) thin films, applied by spin-coating as spectral conversion layers to boost device performance. We systematically investigated how spin speed, varied between 2000 and 6000 rpm, determines film thickness (78 −54 nm) and power conversion efficiency. QD-only coatings delivered efficiency gains ranging from 0.9%–2.2%, while PMMA–QD composite films produced 1.1%–3.7% improvements, with the most consistent results observed for thinner films produced at higher spin speeds. The CuInS 2 QDs displayed strong ultraviolet absorption, while their broad visible photoluminescence centered near 660 nm aligns with the silicon spectral response. Incorporating QDs into a PMMA matrix enhanced coating reproducibility while preserving efficiency benefits, confirming the QDs as the primary source of performance gains. These findings demonstrate that spin-coated CuInS 2 QD layers, either standalone or embedded in a polymer matrix, offer a scalable, eco-friendly strategy for improving commercial silicon solar cell efficiency.
- Open Access
- 16 March 2024
- Published by Elsevier in Results in Optics
- Vol. 15
Silicon solar cell efficiency improvement employing electrostatically assembled polyelectrolyte–quantum dot multilayers
- 16 March 2024
- Published by Elsevier in Results in Optics
- Vol. 15
Open AccessSilicon solar cell efficiency improvement employing electrostatically assembled polyelectrolyte–quantum dot multilayers
- Open Access
- 12 February 2024
- Published by Elsevier in Results in Optics
- Vol. 15
Optical properties study of a perovskite solar cell film stack by spectroscopic ellipsometry and spectrophotometry
- 12 February 2024
- Published by Elsevier in Results in Optics
- Vol. 15
Open AccessOptical properties study of a perovskite solar cell film stack by spectroscopic ellipsometry and spectrophotometry
- 11 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Carbon Quantum Dots and their Possible Application in Perovskites Passivation
High-quality perovskite films are the key factor in manufacturing high performance devices along with outstanding optoelectronic properties. However, methylammonium Lead Iodide (MAPbI3) perovskites are prone to defect formation during the iodide and methylamine ion defect migration. To achieve stable passivation in the perovskite film, additive engineering with nanoparticles can be used as an effective method to passivate the crystal defects. The carboxylic, hydroxyl and amino groups of Carbon Quantum Dots (CQDs) can bond the uncoordinated Pb atoms of the perovskite film creating strong and stable interactions inducing a low trap-state density improving the optoelectronic properties of the perovskite film. Therefore, we study the different functional groups in CQDs by Raman, FTIR, absorbance and photoluminice spectra and propose the addition of CQDs in the perovskite film to reduce the crystal defects and passivate the grain boundaries.
- 11 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Carbon Quantum Dots and their Possible Application in Perovskites Passivation
High-quality perovskite films are the key factor in manufacturing high performance devices along with outstanding optoelectronic properties. However, methylammonium Lead Iodide (MAPbI3) perovskites are prone to defect formation during the iodide and methylamine ion defect migration. To achieve stable passivation in the perovskite film, additive engineering with nanoparticles can be used as an effective method to passivate the crystal defects. The carboxylic, hydroxyl and amino groups of Carbon Quantum Dots (CQDs) can bond the uncoordinated Pb atoms of the perovskite film creating strong and stable interactions inducing a low trap-state density improving the optoelectronic properties of the perovskite film. Therefore, we study the different functional groups in CQDs by Raman, FTIR, absorbance and photoluminice spectra and propose the addition of CQDs in the perovskite film to reduce the crystal defects and passivate the grain boundaries.