Rodrigo Adolfo Benitez Mendes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rodrigo Adolfo Benitez Mendes has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Andrey Pereira Acosta
Postgraduate Program in Materials Science and Engineering (PIPE), Federal University of Paraná, Curitiba, Brazil
2 shared publications - Rafael de Avila Delucis
Post-Graduate Program in Materials Science and Engineering, Federal University of Pelotas, Pelotas 96010-610, Brazil
2 shared publications - Darci Alberto Gatto
Graduate Program in Materials Science and Engineering (PPGCEM), Federal University of Pelotas (UFPel), Pelotas 96010-610, RS, Brazil
1 shared publication - Hüseyin Emre Ilgın
Tampere University
1 shared publication - Inácio Benvegnu Morsch
Universidade Federal do Rio Grande do Sul, Brasil
1 shared publication - Jean Marie Désir
Department of Civil Engineering, Universidade Federal do Rio Grande do Sul, Porto Alegre, Brazil
1 shared publication
Latest Publications
- 2 April 2025
- Published by Springer Nature in Journal of the Indian Academy of Wood Science
- Vol. 22 (1) , 190-197
Termite resistance of a pine wood-based cross-laminated timber impregnated treated with raw pine resin
- 2 April 2025
- Published by Springer Nature in Journal of the Indian Academy of Wood Science
- Vol. 22 (1) , 190-197
Termite resistance of a pine wood-based cross-laminated timber impregnated treated with raw pine resin
- Open Access
Cross-Laminated Timber (CLT) in Compression Perpendicular to the Plane: Experimental Analysis on the Column below the Wall Load Configuration
This study investigates the load-bearing properties of cross-laminated timber (CLT) under compression perpendicular to the grain. Different series of CLT panels with varying layups, layer thicknesses, and overall depths were tested. Also, the compression perpendicular to the grain properties of CLT plate specimens is compared against clear wood and cubic CLT specimens. The results show a 30% reduction in modulus perpendicular to the grain for cubic samples compared to clear specimens. Increasing the number of layers from three to five leads to a 21% higher modulus, while increasing the overall depth from 105 to 175 mm results (with the same number of layers) in a 17% reduction. The overall depth significantly affects the CLT’s modulus and strength under compression perpendicular to the grain. The study also compares two analytical models for determining the transversal compression factor, kc,90. Although the models showed satisfactory results for thinner CLTs, their accuracy decreased with greater panel depth. These findings enhance the understanding of CLT panels for structural applications.
Open AccessCross-Laminated Timber (CLT) in Compression Perpendicular to the Plane: Experimental Analysis on the Column below the Wall Load Configuration
This study investigates the load-bearing properties of cross-laminated timber (CLT) under compression perpendicular to the grain. Different series of CLT panels with varying layups, layer thicknesses, and overall depths were tested. Also, the compression perpendicular to the grain properties of CLT plate specimens is compared against clear wood and cubic CLT specimens. The results show a 30% reduction in modulus perpendicular to the grain for cubic samples compared to clear specimens. Increasing the number of layers from three to five leads to a 21% higher modulus, while increasing the overall depth from 105 to 175 mm results (with the same number of layers) in a 17% reduction. The overall depth significantly affects the CLT’s modulus and strength under compression perpendicular to the grain. The study also compares two analytical models for determining the transversal compression factor, kc,90. Although the models showed satisfactory results for thinner CLTs, their accuracy decreased with greater panel depth. These findings enhance the understanding of CLT panels for structural applications.