Fouzia Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Fouzia Khan has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Barid Baran Lahiri
IGCAR
3 shared publications - John Philip
Indira Gandhi Centre for Atomic Research
2 shared publications - Surojit Ranoo
Institute of Physical Chemistry, Department of Chemistry, University of Cologne 2 , D-50939 Cologne
2 shared publications - A. T. Sathyanarayana
Condensed Matter Physics Division, Materials Science Group, Indira Gandhi Centre for Atomic Research, A CI of Homi Bhabha National Institute, Kalpakkam, Tamil Nadu 603102, India
1 shared publication - Anish Kumar
Indira Gandhi Centre for Atomic Research
1 shared publication - Arup Dasgupta
Indira Gandhi Centre for Atomic Research, Kalpakkam, India
1 shared publication
Latest Publications
- 21 September 2025
- Published by Wiley in Physica Status Solidi (a)
- Vol. 222 (22)
Induction Heating Efficiency of Water‐Dispersible Polyethylene Glycol‐Coated Cobalt Ferrite Nanoparticles Prepared Using Microwave‐Assisted Coprecipitation Technique
Controllable preparation of biocompatible magnetic nanoparticles (MNPs) with high saturation magnetization is essential for the rapid adaptation of magnetic fluid hyperthermia (MFH)‐based cancer therapy. With this objective, this work reports a microwave‐assisted synthesis of polyethylene glycol (PEG)‐coated CoFe 2 O 4 MNPs of average crystallite size of ≈13.3 ± 1.2 nm, and saturation magnetization of ≈66.6 emu g −1 . The synthesis scheme is optimized to tune the size of the MNPs to enable room temperature ferrimagnetism, which enabled hysteresis hysteresis‐mediated heating, in addition to the Brownian relaxation, when exposed to alternating magnetic field (AMF). This results in the augmentation of the MFH efficiency, sans significant agglomeration in aqueous dispersions. Fourier transform infrared spectroscopy, and dynamic light scattering confirm the presence of PEG moieties, which imparted electrostatic stabilization (zeta potential ≈−26 ± 3 mV) in aqueous medium, thereby ensuring long‐term colloidal stability, even after repeated exposures to the AMF. In vitro cytotoxicity studies indicate that the PEG‐coated MNPs are biocompatible in nature. Systematic MFH studies further reveal that the PEG‐coated CoFe 2 O 4 MNPs cause a temperature rise beyond the hyperthermia threshold of ≈42 °C within ≈120 s of bio‐medically safe AMF exposure (amplitude‐frequency product ≤ 4.2 × 10 9 Am −1 s −1 ). The highest specific absorption rate is found to be ≈326.16 ± 15.07 W g Fe −1 . These findings highlight the suitability of the of PEG‐coated CoFe 2 O 4 MNPs for MFH.
- 21 September 2025
- Published by Wiley in Physica Status Solidi (a)
- Vol. 222 (22)
Induction Heating Efficiency of Water‐Dispersible Polyethylene Glycol‐Coated Cobalt Ferrite Nanoparticles Prepared Using Microwave‐Assisted Coprecipitation Technique
Controllable preparation of biocompatible magnetic nanoparticles (MNPs) with high saturation magnetization is essential for the rapid adaptation of magnetic fluid hyperthermia (MFH)‐based cancer therapy. With this objective, this work reports a microwave‐assisted synthesis of polyethylene glycol (PEG)‐coated CoFe 2 O 4 MNPs of average crystallite size of ≈13.3 ± 1.2 nm, and saturation magnetization of ≈66.6 emu g −1 . The synthesis scheme is optimized to tune the size of the MNPs to enable room temperature ferrimagnetism, which enabled hysteresis hysteresis‐mediated heating, in addition to the Brownian relaxation, when exposed to alternating magnetic field (AMF). This results in the augmentation of the MFH efficiency, sans significant agglomeration in aqueous dispersions. Fourier transform infrared spectroscopy, and dynamic light scattering confirm the presence of PEG moieties, which imparted electrostatic stabilization (zeta potential ≈−26 ± 3 mV) in aqueous medium, thereby ensuring long‐term colloidal stability, even after repeated exposures to the AMF. In vitro cytotoxicity studies indicate that the PEG‐coated MNPs are biocompatible in nature. Systematic MFH studies further reveal that the PEG‐coated CoFe 2 O 4 MNPs cause a temperature rise beyond the hyperthermia threshold of ≈42 °C within ≈120 s of bio‐medically safe AMF exposure (amplitude‐frequency product ≤ 4.2 × 10 9 Am −1 s −1 ). The highest specific absorption rate is found to be ≈326.16 ± 15.07 W g Fe −1 . These findings highlight the suitability of the of PEG‐coated CoFe 2 O 4 MNPs for MFH.
- Open Access
- 26 February 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 135 (8)
Magnetic hyperthermia in tissue-like media: Finite element simulation, experimental validation, parametric variations, and calibration studies
We report the experimental characterization and finite element modeling of magnetic fluid hyperthermia (MFH) in tissue-like media using tetramethyl ammonium hydroxide coated superparamagnetic iron oxide magnetic nanoparticles (MNPs) of size ∼19.6 ± 1.2 nm, prepared using a co-precipitation technique. MFH properties are probed for the MNPs in ∼1 wt. % agar, resembling the tumor and surrounding normal tissues. The field-induced temperature rise (ΔT) is experimentally measured in real-time utilizing an infrared camera. A finite element model (FEM) is utilized to simulate the spatiotemporal variations in the thermal profiles, which are found to be in good agreement with the experimental data. FEM-based parametric studies reveal that the thermal conductivity of the medium is the most significant parameter influencing the thermal profiles. The spatiotemporal variations in the thermal profiles are numerically studied for seven different tissues, and the obtained results indicate the highest ΔT for the breast tissue in the tumor and the surrounding regions, which is due to the lowest volumetric specific heat and the highest thermal conductivity of the breast tissue, respectively. Numerical studies on the thermal profiles for sub-surface tumors with parametrically varying depths indicate a strong exponential correlation between the surface and tumor temperature, where the regression coefficients are found to be correlated with the thermo-physical properties of the tissues. The obtained findings are beneficial for developing a simplistic and easily deployable framework for a priori generation of the thermal profiles for various tissues during MFH, which is useful for appropriate planning and parameter selection for MFH-based therapy.
- 26 February 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 135 (8)
Open AccessMagnetic hyperthermia in tissue-like media: Finite element simulation, experimental validation, parametric variations, and calibration studies
We report the experimental characterization and finite element modeling of magnetic fluid hyperthermia (MFH) in tissue-like media using tetramethyl ammonium hydroxide coated superparamagnetic iron oxide magnetic nanoparticles (MNPs) of size ∼19.6 ± 1.2 nm, prepared using a co-precipitation technique. MFH properties are probed for the MNPs in ∼1 wt. % agar, resembling the tumor and surrounding normal tissues. The field-induced temperature rise (ΔT) is experimentally measured in real-time utilizing an infrared camera. A finite element model (FEM) is utilized to simulate the spatiotemporal variations in the thermal profiles, which are found to be in good agreement with the experimental data. FEM-based parametric studies reveal that the thermal conductivity of the medium is the most significant parameter influencing the thermal profiles. The spatiotemporal variations in the thermal profiles are numerically studied for seven different tissues, and the obtained results indicate the highest ΔT for the breast tissue in the tumor and the surrounding regions, which is due to the lowest volumetric specific heat and the highest thermal conductivity of the breast tissue, respectively. Numerical studies on the thermal profiles for sub-surface tumors with parametrically varying depths indicate a strong exponential correlation between the surface and tumor temperature, where the regression coefficients are found to be correlated with the thermo-physical properties of the tissues. The obtained findings are beneficial for developing a simplistic and easily deployable framework for a priori generation of the thermal profiles for various tissues during MFH, which is useful for appropriate planning and parameter selection for MFH-based therapy.
- 30 August 2021
- Published by Wiley
- p. 250-271
Improving Magneto‐thermal Energy Conversion Efficiency of Magnetic Fluids Through External DC Magnetic Field Induced Orientational Ordering
- 30 August 2021
- Published by Wiley
- p. 250-271
Improving Magneto‐thermal Energy Conversion Efficiency of Magnetic Fluids Through External DC Magnetic Field Induced Orientational Ordering