JLJulian Lopez-Uricoechea

Julian Lopez-Uricoechea

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Julian Lopez-Uricoechea has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Effect of body bias on near-field electron behavior in a magnetically shielded Hall thruster

    by Naia I. Butler-Craig, Julian Lopez-Uricoechea, Richeek Dutta, Mitchell L. R. Walker

    This work investigates the influence of thruster body bias on near-field electron behavior in a magnetically shielded Hall effect thruster (HET) through spatially resolved laser Thomson scattering diagnostics. Experiments were conducted on the 9 kW class H9 magnetically shielded HET operating at 40 A discharge current and 150 V discharge voltage on krypton propellant in the Georgia Tech Vacuum Test Facility 2. Three electrical configurations were examined: floating (body electrically isolated), cathode-tied (body at cathode potential, approximately −10.3 V relative to facility ground), and +2 V bias (body biased +2 V relative to ground). Spatially resolved measurements of electron density, electron temperature, and radial electron bulk velocity were obtained at up to 23 locations (a 15-point radial grid and up to eight axial stations along the cathode centerline) spanning the cathode near-field from the cathode centerline to the discharge channel centerline. A configuration-dependent spatial density inversion reveals distinct circuit topologies: at z/r0 = 0.029, cathode-tied elevates ne at the cathode centerline (4.4 × 1019 m−3) while exhibiting the lowest channel-centerline density (6.6 × 1017 m−3), whereas the +2 V configuration shows the opposite pattern (3.4 × 1019 and 9.0 × 1017 m−3, respectively). The +2 V configuration exhibits the lowest Te at the inner front pole cover, consistent with magnetization-limited, energy-selective electron collection. Electron pressure does not serve as a reliable proxy for electrostatic potential in this near-field region due to unmeasured anomalous transport terms.

  • Open Access

    Statistical inference of higher-order moments of electron velocity distribution functions from incoherent Thomson scattering spectra

    by Julian Lopez-Uricoechea, Mitchell L. R. Walker

    Noninvasive direct measurements of higher-order moments of the electron velocity distribution function (EVDF) are needed to improve the understanding of non-Maxwellian electron behavior in various plasmas. This work presents a Bayesian inference method with Monte Carlo sampling to infer the electron heat flux and excess kurtosis from ILTS spectra, which also improves the inferences of the lower-order moments. The method assumes that the EVDFs are described by the sum of at most four super-Gaussians and is tested against synthetic spectra that are representative of ITLS measurements in low-temperature plasmas. Fifteen synthetic spectra are considered that include Maxwellian, Druyvesteyn, and Kappa distributions and their skewed counterparts. For all synthetic spectra considered, the true value of the heat flux is within the uncertainty bounds of the inference. Regarding the excess kurtosis, the true value of the excess kurtosis is within the uncertainty bounds of the inference for all cases except for the Kappa distributions with no or low skewness. At the signal-to-noise ratio of the synthetic spectra, the minimum detectable skewness and excess kurtosis are around ±0.006 and ±0.07, respectively. When the heat flux and excess kurtosis are significantly above their minimum detectable values, relative uncertainties range between 40% and 5%. Finally, in terms of symmetric or low-skewness EVDFs, we find that ILTS is best suited for EVDFs with negative excess kurtosis, suggesting that ILTS can accurately and precisely measure nonequilibrium electron properties in many low-temperature plasmas.


  • Open Access

    Laser Thomson scattering measurements indicate non-isothermal magnetic field lines in magnetically shielded Hall effect thrusters

    by Jean Luis Suazo Betancourt, Naia Butler-Craig, Julian Lopez-Uricoechea, Adam M. Steinberg, Mitchell L. R. Walker

    Expected high electron mobility and low resistivity along magnetic field lines—as compared to across magnetic field lines—have led to the assumption, or the reproduction through a solution to the electron energy equation, that magnetic field lines are isothermal in typical plasma simulations for Hall effect thrusters (HETs). However, the inaccessibility of the near-field plasma region and perturbative nature of electrostatic probes have prevented validation of these assumptions in HETs. This manuscript presents non-intrusive measurements of the electron number density and electron temperature along two distinct magnetic field lines in the near-field discharge of a magnetically shielded HET operating at 150 V and 40 A on krypton based on incoherent laser Thomson scattering. The resulting electron temperature and density profiles indicate that the magnetic field lines are not isothermal or isopotential, with percent changes exceeding 100% of the channel centerline electron temperature along each magnetic field line. This observation brings into question the current state of electron models in simulations and what physics are included, or neglected, to produce isothermal magnetic field lines in certain regions.


  • Open Access

    Bayesian-inverted laser Thomson scattering measurements indicate electrostatic erosion pathways in magnetically-shielded Hall effect thrusters

    by Jean Luis Suazo Betancourt, Julian Lopez-Uricoechea, Naia Butler-Craig, Adam M. Steinberg, Mitchell L. R. Walker

    Magnetically shielded Hall effect thrusters suffer from pole erosion as their life-limiting mechanism. However, the dominant physical mechanism causing this erosion remains unclear, limiting the ability create designs that mitigate erosion and the predictive accuracy of simulations used to aid in design. This paper provides spatially resolved laser Thomson scattering measurements of electron temperature and density in the near field plume of a magnetically shielded Hall effect thruster, traversing the front pole region from the discharge channel centerline to the cathode centerline. The signals are inverted in a Bayesian framework, and the data are compared qualitatively and quantitatively to simulations of the same Hall effect thruster. Based on the electron momentum equation, electron pressure gradient is used as a proxy for the electron-predicted electrostatic potential gradient. To within the accuracy of this approximation, the electron pressure has a minimum immediately in front of the front pole. Hence, ions have an electrostatic potential avenue from the discharge region to the front pole, validating this mechanism of pole erosion.


  • Open Access

    Spatially resolved Thomson scattering measurements of electron properties across the acceleration region of a high-power magnetically shielded Hall effect thruster

    by Julian Lopez-Uricoechea, Jean Luis Suazo Betancourt, Naia Butler-Craig, Mitchell L. R. Walker

    Noninvasive measurements of electron properties in a Hall effect thruster (HET) are needed to understand the physical processes in the acceleration region and to validate simulations. This paper presents spatially resolved laser Thomson scattering (LTS) measurements across the entire acceleration region of a HET. The test article is the H9, a 9 kW class magnetically shielded HET. The H9 is operated on krypton at a facility pressure of 1.2 × 10−5 Torr Kr (1.6 mPa). The thruster is operated at three discharge conditions: 171 V, 35 A, an inner coil current (Iic) of 4.11 A, and an outer coil current (Ioc) of 2.27 A as the baseline 6 kW condition; 154 V, 34.8 A, an Iic of 4.11 A, and an Ioc of 2.27 A to vary the discharge voltage; and 171 V, 34.4 A, an Iic of 4.52 A, and an Ioc of 2.5 A to vary the magnetic field strength. At each discharge condition, we measured axial profiles of electron density and electron temperature along the channel centerline from 5% to 95% of a channel length downstream of the channel exit plane. At the baseline condition, we also measure the axial profile of the azimuthal electron drift velocity. We measure a minimum electron density of 1.3 × 1017 m−3, peak electron temperatures around 40 eV, and a peak azimuthal electron drift velocity around 680 km/s. The results suggest the presence of anomalous electron heating and demonstrate that low discharge voltages allow LTS to access the entire acceleration region of a HET.


  • Open Access

    An incoherent Thomson scattering system for measurements near plasma boundaries

    by Jean Luis Suazo Betancourt, Julian Lopez-Uricoechea, Naia Butler-Craig, Adam M. Steinberg, Mitchell L. R. Walker

    Laser Thomson scattering (LTS) is a minimally invasive measurement technique used for determining electron properties in plasma systems. Sheath model closure validation requires minimally invasive measurements of the electron properties that traverse the boundaries between the bulk plasma, the presheath, and the plasma sheath. Several studies have probed the radial properties along the surface of discharge electrodes with laser-based diagnostics and electrostatic probes. These measurements provide valuable insight into the electron properties in this dynamic region. However, sheath model calibration requires plasma property measurements perpendicular to plasma bounding surfaces, in this case, along the electrode normal vector between discharge electrodes. This work presents the development of a discharge plasma cell and laser Thomson scattering system with a measurement volume step of 1 mm normal to plasma bounding surfaces. The laser Thomson scattering measurements are made between a set of discharge electrodes separated by ∼25 mm that are used to generate a pulsed argon plasma. The spatial distribution of electron temperature and density is measured at several discharge voltages between 8 and 20 kV at a pressure of 8 Torr-Ar. It is determined that the system is statistically stationary and resembles a classic DC discharge plasma. The results are some of the first laser diagnostic-based “between electrode” measurements made along the plasma bounding electrode normal vector. A one-dimensional sheath model is applied to determine the near cathode electron properties, and it is determined that the edge of the presheath is probed in the high-voltage cases. As the lengths of the presheath and sheath decrease with decreasing voltage, the region recedes below the closest probed point to the cathode. To improve the performance of the diagnostic, the step size of the interrogation volume should decrease by an order of magnitude from 1 mm to less than 100 μm, and the data acquisition strategy should be revised to increase the signal-to-noise ratio.


  • Open Access

    Spatially resolved laser Thomson scattering measurements in a negative glow and cathode presheath to investigate a 1D sheath model

    by Julian Lopez-Uricoechea, Jean Luis Suazo Betancourt, Naia Butler-Craig, Mitchell L. R. Walker

    This paper presents spatially resolved laser Thomson scattering measurements in a cathode presheath and describes a new approximation for the electric field at the plasma-sheath boundary that accounts for collisional and ionization effects. The approximation is derived from a 1D sheath model using asymptotic theory, and the approximation is validated against the exact solution of the 1D model. The approximation of the electric field at the plasma-sheath boundary is examined with experimentally measured profiles of electron properties in the cathode presheath and negative glow of a glow discharge. The measurements are made with a noninvasive laser Thomson scattering system applied to a 20 kV pulsed plasma with an electrode gap of 26.53 mm at neutral pressures of 2, 2.5, and 25 Torr for argon, krypton, and helium, respectively. Peak electron densities for the He, Ar, and Kr plasmas are around 9 × 1018, 2.4 × 1019, and 7.5 × 1019 m−3, respectively. For all the gases, the electrons in the negative glow are approximately isothermal at electron temperatures between 1 and 2 eV, and for He and Ar, the electrons were not isothermal in the cathode presheath. The electron density profile in the cathode presheath was nonmonotonic, and calculations of the ionization rate indicate that a sharp increase in the ionization rate may produce a nonmonotonic density profile in the cathode presheath. The insights gained from spatially-resolved noninvasive measurements of electron properties in a cathode sheath reveal the need for more detailed cathode sheath models.


  • Open Access

    Thomson scattering measurements in the krypton plume of a lanthanum hexaboride hollow cathode in a large vacuum test facility

    by Jean Luis Suazo Betancourt, Naia Butler-Craig, Julian Lopez-Uricoechea, Junhwi Bak, Dongho Lee, Adam M. Steinberg, Mitchell L. R. Walker

    Laser Thomson scattering is a minimally intrusive diagnostic technique for determining electron temperature, density, and bulk velocity in plasma systems. Advances in technology have made possible the application of Thomson scattering to electric propulsion-relevant plasma systems, with reported electron number-density detection limits as low as 1×1016 m−3, and electron temperatures from one-to-tens eV. However, the implementation of laser Thomson scattering in large vacuum testing facilities, wherein electric propulsion devices are tested, remains a challenge. This work presents the implementation of a laser Thomson scattering system in a large vacuum test facility at the Georgia Tech High Power Electric Propulsion Laboratory. The diagnostic was optimized for maximum light-collection efficiency and ease of re-alignment while the facility is at vacuum. The high light-collection efficiency allowed reduced accumulation times to achieve the target detection limit of 1×1017 m−3. The diagnostic is used to measure axial electron property profiles in the near-field plume of a lanthanum hexaboride hollow cathode operating at 25 A on krypton at a background pressure of 1.3×10−6 Torr—Kr. The diagnostic is quantitatively compared to similar systems in the literature. The resulting axial points, collected from 2 to 8 mm downstream of the cathode keeper orifice, are qualitatively and quantitatively compared with simulations and experimental measurements made with electrostatic probes and laser-induced fluorescence. The main quantitative difference between measured values and results is the one to two order of magnitude difference in the peak electron density, being attributed to the relative size and location of the external anode with respect to the cathode keeper.


  • Open Access

    0-D composition and performance analysis of an air-breathing radiofrequency ion thruster

    by Julian Lopez-Uricoechea, Dan Lev, Mitchell L. R. Walker

    This paper presents a physics-based 0-D steady-state model of a radiofrequency ion thruster (RIT) that is valid for any propellant blend, and hence, any plasma mixture, and the model is used to predict the drag compensation capability and plasma composition of an air-breathing RIT operating in very-low Earth orbit (VLEO). This study fills a gap in the modeling of air-breathing electric propulsion with an air-breathing RIT model that is validated with experimental data of a RIT operating with an $${\mathrm{N}}_{2}$$ N 2 / $${\mathrm{O}}_{2}$$ O 2 mixture. The model expands upon current 0-D RIT models by accounting for the dissociation of neutral molecules and molecular ions and by applying particle conservation for each ion and neutral species. Atomic oxygen in the atmosphere is assumed to completely recombine into $${\mathrm{O}}_{2}$$ O 2 in the collector, and the model is used to calculate an air-breathing RIT’s thrust, discharge efficiency, mass utilization efficiency, and discharge plasma composition at altitudes between 80 and 150 km. At 1 kW of total input power and an optimal flow rate of 0.17 mg/s, the net thrust was limited to 3 mN at all altitudes considered. At these same operating conditions, the mass utilization efficiency and discharge efficiency were approximately 0.15 and 870 eV/ion, respectively. To increase the performance of the thruster, the magnetic field should be increased in order to increase the beam current. The mole fraction of atomic oxygen in the discharge chamber was found to be between 0.19 and 0.27 depending on the altitude, indicating that grid erosion should be a focus of future studies.