Mamadsho Ilolov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mamadsho Ilolov has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Jamshed Rahmatov
Center of Innovative Development of Science and New Technologies of NAST, Tajik National University
2 shared publications Ahmadsho Ilolov
Osimi Tajik Technical University
1 shared publication- Binkai Zhang
Xinjiang University
1 shared publication - Fumiaki Inagaki
Graduate School of International Resource Sciences, Akita University, Akita 0108502, Japan
1 shared publication Jiao Ji
Xinjiang University
1 shared publicationJie Hou
Chongqing University of Posts and Telecommunications
1 shared publication
Latest Publications
- 1 November 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (21) , 215340
Bi-level optimal configuration of high-mountain photovoltaic storage systems based on adaptive deviation compensation
To address frequent, large-amplitude fluctuations in photovoltaic (PV) output in high-altitude regions, this study proposes a bi-level multi-objective energy storage capacity optimization method that balances deviation compensation and battery lifespan protection. A dynamic target range based on forecast PV power fluctuations is combined with state-of-charge (SOC) partitioning and tiered response to adjust the compensation range and limit charging and discharging actions that drive SOC toward its limits within the flexible regulation zone. Capacity configurations are evaluated through annual operational simulations, with annual total cost and annual deviation rate as the optimization objectives, and the model is solved using an improved multi-objective slime mold algorithm (IMOSMA). Simulation results show that, at the respective recommended capacities, the complete strategy reduces annual total cost by 14.05% compared with the fixed-target-range strategy with SOC partitioning, while maintaining a similar annual deviation rate. Compared with the strategy using only a dynamic target range, charging and discharging throughput toward the SOC limits is reduced by 45.11%. Rainflow cycle analysis further shows fewer deep cycles relative to the latter strategy, suggesting a lower risk of battery degradation associated with deep cycling. ZDT benchmark tests show that IMOSMA improves convergence performance, consistency across runs, and computational efficiency compared with multi-objective particle swarm optimization and the standard multi-objective slime mold algorithm, supporting its use in solving the capacity configuration model.
- 1 November 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (21) , 215340
Bi-level optimal configuration of high-mountain photovoltaic storage systems based on adaptive deviation compensation
To address frequent, large-amplitude fluctuations in photovoltaic (PV) output in high-altitude regions, this study proposes a bi-level multi-objective energy storage capacity optimization method that balances deviation compensation and battery lifespan protection. A dynamic target range based on forecast PV power fluctuations is combined with state-of-charge (SOC) partitioning and tiered response to adjust the compensation range and limit charging and discharging actions that drive SOC toward its limits within the flexible regulation zone. Capacity configurations are evaluated through annual operational simulations, with annual total cost and annual deviation rate as the optimization objectives, and the model is solved using an improved multi-objective slime mold algorithm (IMOSMA). Simulation results show that, at the respective recommended capacities, the complete strategy reduces annual total cost by 14.05% compared with the fixed-target-range strategy with SOC partitioning, while maintaining a similar annual deviation rate. Compared with the strategy using only a dynamic target range, charging and discharging throughput toward the SOC limits is reduced by 45.11%. Rainflow cycle analysis further shows fewer deep cycles relative to the latter strategy, suggesting a lower risk of battery degradation associated with deep cycling. ZDT benchmark tests show that IMOSMA improves convergence performance, consistency across runs, and computational efficiency compared with multi-objective particle swarm optimization and the standard multi-objective slime mold algorithm, supporting its use in solving the capacity configuration model.
- 28 August 2024
- Published by Springer Nature
- p. 241-250
A Regularization Method for an Inverse Problem Represented by a First-Kind Integral Equation
- 28 August 2024
- Published by Springer Nature
- p. 241-250
A Regularization Method for an Inverse Problem Represented by a First-Kind Integral Equation
- Open Access
- 29 February 2024
- Published by TIB Open Publishing in SiliconPV Conference Proceedings
- Vol. 1
Tracking Photovoltaics Systems at Mountain Heights
The expansion of the use of solar energy in most cases depends on the energy capabilities of each specific country. In Tajikistan, where 93% of the territory is mountains, it is necessary to build solar power plants high in the mountains. At mountain heights, the performance of panels increases in winter, in addition, the snow cover that reflects the sun's rays also contributes to an increase in the efficiency of solar panels. Experts note that solar panels receive less radiation in valleys, as clouds and fogs often prevent the passage of sunlight. At the heights of the mountains, there is no air pollution and, as a result, a longer operating time of the solar power plant. In the conditions of Tajikistan, one more drawback of solar stations in the valleys should be added - this is the rapid pollution of the panels due to dust storms in the summer-autumn period. The Chinese company Sun Tech Power Holdings will build a 10 MW power plant in Tibet at an altitude of 4000 meters above sea level.
- 29 February 2024
- Published by TIB Open Publishing in SiliconPV Conference Proceedings
- Vol. 1
Open AccessTracking Photovoltaics Systems at Mountain Heights
The expansion of the use of solar energy in most cases depends on the energy capabilities of each specific country. In Tajikistan, where 93% of the territory is mountains, it is necessary to build solar power plants high in the mountains. At mountain heights, the performance of panels increases in winter, in addition, the snow cover that reflects the sun's rays also contributes to an increase in the efficiency of solar panels. Experts note that solar panels receive less radiation in valleys, as clouds and fogs often prevent the passage of sunlight. At the heights of the mountains, there is no air pollution and, as a result, a longer operating time of the solar power plant. In the conditions of Tajikistan, one more drawback of solar stations in the valleys should be added - this is the rapid pollution of the panels due to dust storms in the summer-autumn period. The Chinese company Sun Tech Power Holdings will build a 10 MW power plant in Tibet at an altitude of 4000 meters above sea level.