Aldino Javier Saviola
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Aldino Javier Saviola has a total of 109 co-authors. Here are the top co-authors by number of shared publications:
- Karna Wijaya
Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Yogyakarta 55281, Indonesia
19 shared publications - Amalia Kurnia Amin
Research Center for Catalysis, National Research and Innovation Agency (BRIN), The B. J. Habibie Science and Technology Area, South Tangerang, Banten 15314, Indonesia
11 shared publications Won-Chun Oh
11 shared publicationsAkhmad Syoufian
7 shared publicationsKarna Wijaya
7 shared publicationsLatifah Hauli
7 shared publications
Latest Publications
- Open Access
- 15 October 2026
- Published by Elsevier in Sustainable Chemistry for the Environment
- Vol. 16
Geopolymer-based materials for CO₂/CH₄ separation and H₂S capture: Current evidence, limitations, and research needs
- 15 October 2026
- Published by Elsevier in Sustainable Chemistry for the Environment
- Vol. 16
Open AccessGeopolymer-based materials for CO₂/CH₄ separation and H₂S capture: Current evidence, limitations, and research needs
- Open Access
- 24 September 2026
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (4) , 989-1006
Potential Application of Plant-Mediated Zirconia by Hydrothermal Method for Microwave-Assisted Bio-Jet Fuel Production
Waste and biomass valorization provide promising routes for biofuel production while addressing environmental challenges associated with conventional feedstocks and energy-intensive processing. In this study, plant-mediated zirconia (ZrO₂) was hydrothermally prepared using Sapindus rarak extract (SPE) and evaluated as a catalyst for microwave-assisted hydroprocessing of used cooking oil (UCO) and Calophyllum inophyllum L. oil (CIO). Phenolic compounds and saponins were the predominant constituents of SPE, while the prepared ZrO₂ exhibited a predominantly tetragonal crystalline structure, nanoscale particles, and mesoporous characteristics associated with interparticle voids. Under microwave irradiation at 550 °C, with an H₂ flow rate of 20 mL min⁻¹, a catalyst-to-oil mass ratio of 1:100 (w/w), and a reaction time of 30 min, the prepared ZrO₂ promoted the formation of C₈–C₁₆ hydrocarbons with a higher paraffin fraction compared with commercial monoclinic ZrO₂ and catalyst-free treatment. Bio-jet fuel selectivity and yield reached 56.03% and 19.51 wt% for UCO and 48.90% and 15.72 wt% for CIO, respectively. Three consecutive reuse cycles with UCO resulted in a gradual decline in bio-jet fuel yield, accompanied by changes in product distribution and the retention of organic species on the catalyst. Altogether, these findings indicate the potential of plant-mediated ZrO₂ for microwave-assisted hydroprocessing of waste-derived and non-edible oils, while further catalyst development is needed to improve catalytic performance and product quality. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- 24 September 2026
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (4) , 989-1006
Open AccessPotential Application of Plant-Mediated Zirconia by Hydrothermal Method for Microwave-Assisted Bio-Jet Fuel Production
Waste and biomass valorization provide promising routes for biofuel production while addressing environmental challenges associated with conventional feedstocks and energy-intensive processing. In this study, plant-mediated zirconia (ZrO₂) was hydrothermally prepared using Sapindus rarak extract (SPE) and evaluated as a catalyst for microwave-assisted hydroprocessing of used cooking oil (UCO) and Calophyllum inophyllum L. oil (CIO). Phenolic compounds and saponins were the predominant constituents of SPE, while the prepared ZrO₂ exhibited a predominantly tetragonal crystalline structure, nanoscale particles, and mesoporous characteristics associated with interparticle voids. Under microwave irradiation at 550 °C, with an H₂ flow rate of 20 mL min⁻¹, a catalyst-to-oil mass ratio of 1:100 (w/w), and a reaction time of 30 min, the prepared ZrO₂ promoted the formation of C₈–C₁₆ hydrocarbons with a higher paraffin fraction compared with commercial monoclinic ZrO₂ and catalyst-free treatment. Bio-jet fuel selectivity and yield reached 56.03% and 19.51 wt% for UCO and 48.90% and 15.72 wt% for CIO, respectively. Three consecutive reuse cycles with UCO resulted in a gradual decline in bio-jet fuel yield, accompanied by changes in product distribution and the retention of organic species on the catalyst. Altogether, these findings indicate the potential of plant-mediated ZrO₂ for microwave-assisted hydroprocessing of waste-derived and non-edible oils, while further catalyst development is needed to improve catalytic performance and product quality. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- Open Access
- 16 June 2026
- Published by Elsevier in Sustainable Chemistry for the Environment
- Vol. 15
Waste-to-fuel innovation: Microwave-assisted catalytic conversion of laboratory latex glove waste into gasoline-range hydrocarbons over NiMo/ZSM-5
- 16 June 2026
- Published by Elsevier in Sustainable Chemistry for the Environment
- Vol. 15
Open AccessWaste-to-fuel innovation: Microwave-assisted catalytic conversion of laboratory latex glove waste into gasoline-range hydrocarbons over NiMo/ZSM-5
- Open Access
- 18 February 2026
- Published by Elsevier in Industrial Crops and Products
- Vol. 242
Pyrolytic wood vinegar from industrial crop residues as a bio-based fungicide for Fusarium control in banana cultivation
- 18 February 2026
- Published by Elsevier in Industrial Crops and Products
- Vol. 242
Open AccessPyrolytic wood vinegar from industrial crop residues as a bio-based fungicide for Fusarium control in banana cultivation
- Open Access
- 5 February 2026
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (2) , 349-361
Effect of Nickel Incorporation on Nitrogen-Doped Titania/Zirconia Nanocomposites for Enhanced Visible-Light Photocatalytic Degradation of Phenol
The rapid expansion of industrial activities has resulted in the discharge of persistent organic pollutants, such as phenol, into aquatic environments. Nowadays, developing visible-light-responsive photocatalysts for the efficient degradation of such pollutants remains a major environmental challenge. In this study, nickel–nitrogen co-doped titania immobilized on zirconia (Ni,N–TiO₂/ZrO₂) nanocomposites with varying nickel loadings were synthesized and evaluated for phenol photodegradation under visible-light irradiation. Nickel incorporation significantly modified the optical and photocatalytic properties of the materials. The 5% Ni,N–TiO₂/ZrO₂ catalyst exhibited the lowest band gap energy (2.69 eV) compared with N–TiO₂/ZrO₂ (3.03 eV), leading to improved visible-light absorption and enhanced charge transfer. Under the experimental conditions (initial phenol concentration = 10 mg.L⁻¹, catalyst dosage = 100 mg, irradiation time = 120 min), it achieved a phenol removal efficiency of 85.36% with an apparent rate constant of 0.0229 min⁻¹, outperforming N–TiO₂/ZrO₂ (40.72%, 0.0042 min⁻¹). These results confirm that a 5 wt% nickel loading provides the most effective modification, demonstrating a strong synergistic interaction between nickel and nitrogen that enhances photocatalytic activity. The developed Ni,N–TiO₂/ZrO₂ catalyst, therefore, holds significant promise for future applications in water purification and environmental remediation. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- 5 February 2026
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (2) , 349-361
Open AccessEffect of Nickel Incorporation on Nitrogen-Doped Titania/Zirconia Nanocomposites for Enhanced Visible-Light Photocatalytic Degradation of Phenol
The rapid expansion of industrial activities has resulted in the discharge of persistent organic pollutants, such as phenol, into aquatic environments. Nowadays, developing visible-light-responsive photocatalysts for the efficient degradation of such pollutants remains a major environmental challenge. In this study, nickel–nitrogen co-doped titania immobilized on zirconia (Ni,N–TiO₂/ZrO₂) nanocomposites with varying nickel loadings were synthesized and evaluated for phenol photodegradation under visible-light irradiation. Nickel incorporation significantly modified the optical and photocatalytic properties of the materials. The 5% Ni,N–TiO₂/ZrO₂ catalyst exhibited the lowest band gap energy (2.69 eV) compared with N–TiO₂/ZrO₂ (3.03 eV), leading to improved visible-light absorption and enhanced charge transfer. Under the experimental conditions (initial phenol concentration = 10 mg.L⁻¹, catalyst dosage = 100 mg, irradiation time = 120 min), it achieved a phenol removal efficiency of 85.36% with an apparent rate constant of 0.0229 min⁻¹, outperforming N–TiO₂/ZrO₂ (40.72%, 0.0042 min⁻¹). These results confirm that a 5 wt% nickel loading provides the most effective modification, demonstrating a strong synergistic interaction between nickel and nitrogen that enhances photocatalytic activity. The developed Ni,N–TiO₂/ZrO₂ catalyst, therefore, holds significant promise for future applications in water purification and environmental remediation. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- Open Access
- 26 December 2025
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (1) , 149-167
NaHCO₃-Assisted Synthesis of Ni-Promoted Sulfated Mesoporous Silica for the Hydrocracking of Used Cooking Oil into Biogasoline
Biofuel production from biomass sources remains a key area of research, aimed at reducing reliance on fossil fuels and promoting environmental sustainability. This study investigates the conversion of used cooking oil (UCO) into biogasoline via catalytic hydrocracking, employing sulfated mesoporous silica dispersed with nickel as the catalyst. Mesoporous silica was synthesized using tetraethyl orthosilicate (TEOS) and NaHCO₃ as the template, followed by a hydrothermal method to introduce sulfate groups and nickel metal. Among the synthesized catalysts, SMS-2 exhibited the highest acidity across varying sulfuric acid concentrations, while 1 Ni/SMS-2 demonstrated superior acidity compared to other nickel loadings. The SiO₂, SMS-2, and 1 Ni/SMS-2 catalysts were evaluated for UCO hydrocracking in a semi-batch double-furnace reactor operated at an optimum temperature of 550 °C for 2 h, with a hydrogen flow rate of 20 mL min⁻¹ under atmospheric pressure. Modifying mesoporous silica with sulfuric acid and nickel significantly enhanced its catalytic performance, with the 1 Ni/SMS-2 catalyst achieving the highest liquid product yield (66.10%) and gasoline fraction (35.47%) at an optimum catalyst-to-feed ratio of 1:100 (w/w). Notably, the resulting biogasoline exhibited a calorific value comparable to commercial gasoline and was free of aromatic hydrocarbons, indicating the potential for cleaner combustion. This study provides valuable insights into the effectiveness of mesoporous silica-based catalysts, highlighting their acid site modulation capabilities for efficiently transforming waste into high-value fuels. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
- 26 December 2025
- Published by BCREC Publishing Group in Bulletin of Chemical Reaction Engineering & Catalysis
- Vol. 21 (1) , 149-167
Open AccessNaHCO₃-Assisted Synthesis of Ni-Promoted Sulfated Mesoporous Silica for the Hydrocracking of Used Cooking Oil into Biogasoline
Biofuel production from biomass sources remains a key area of research, aimed at reducing reliance on fossil fuels and promoting environmental sustainability. This study investigates the conversion of used cooking oil (UCO) into biogasoline via catalytic hydrocracking, employing sulfated mesoporous silica dispersed with nickel as the catalyst. Mesoporous silica was synthesized using tetraethyl orthosilicate (TEOS) and NaHCO₃ as the template, followed by a hydrothermal method to introduce sulfate groups and nickel metal. Among the synthesized catalysts, SMS-2 exhibited the highest acidity across varying sulfuric acid concentrations, while 1 Ni/SMS-2 demonstrated superior acidity compared to other nickel loadings. The SiO₂, SMS-2, and 1 Ni/SMS-2 catalysts were evaluated for UCO hydrocracking in a semi-batch double-furnace reactor operated at an optimum temperature of 550 °C for 2 h, with a hydrogen flow rate of 20 mL min⁻¹ under atmospheric pressure. Modifying mesoporous silica with sulfuric acid and nickel significantly enhanced its catalytic performance, with the 1 Ni/SMS-2 catalyst achieving the highest liquid product yield (66.10%) and gasoline fraction (35.47%) at an optimum catalyst-to-feed ratio of 1:100 (w/w). Notably, the resulting biogasoline exhibited a calorific value comparable to commercial gasoline and was free of aromatic hydrocarbons, indicating the potential for cleaner combustion. This study provides valuable insights into the effectiveness of mesoporous silica-based catalysts, highlighting their acid site modulation capabilities for efficiently transforming waste into high-value fuels. Copyright © 2026 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).