Hao Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hao Li has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Maojun Fang
CNOOC Research Institute Co., Ltd., Beijing 100028, China
4 shared publications - Weipeng Fan
CNOOC Research Institute Ltd., Beijing 100028, China
2 shared publications - Bo Wang
CNOOC Research Institute Co., Ltd., Beijing 100028, China
1 shared publication - Daye Wang
CNOOC Research Institute Co., Ltd
1 shared publication - Guangsheng Cao
Key Laboratory of Enhanced Oil Recovery, Ministry of Education, College of Petroleum Engineering, Northeast Petroleum University, Daqing 163318, China
1 shared publication - Guanlin Li
CNOOC Research Institute Co., Ltd., Beijing 100028, China
1 shared publication
Latest Publications
- Open Access
Numerical Simulation Study on the Mechanisms of Enhanced Gas Recovery and CO2 Storage Performance in Tight Gas Reservoirs Considering Time-Dependent Reservoir Effects
Tight sandstone gas reservoirs are characterized by low single-well productivity, rapid natural decline, and generally low recovery rates, which limit the effectiveness of conventional development strategies. The injection of CO2 into tight gas reservoirs offers broad prospects for both enhanced gas recovery (EGR) and integrated CO2 capture, utilization, and storage (CCUS). However, during the depletion and CO2 injection processes, fracture conductivity, reservoir fluid distribution, and gas–water relative permeability evolve continuously, exhibiting pronounced time-varying behavior. Conventional models have certain limitations in characterizing these time-varying mechanisms, often resulting in significant discrepancies between predicted performance and actual conditions. To address this, we develop a robust and generic model that explicitly incorporates the time-varying mechanisms and stress sensitivity. This model also accounts for the non-equilibrium flash (NEF) behavior of the gas–liquid mixture during CO2 injection into tight gas reservoirs. The successive substitution iteration method is adopted for non-equilibrium flash calculation, and the Newton–Raphson iteration (NRI) method is used for obtaining a fully implicit solution of the reservoir flow equations. The accuracy and reliability of the proposed model are verified through comparisons with commercial simulator results, and a quantitative comparison with traditional models highlights the key discrepancies caused by neglecting time-varying mechanisms. Parametric analyses further clarify the impacts of time-varying behavior and stress sensitivity on CO2-EGR performance and CO2 sequestration efficiency. The results show that the displacement process of CO2 in tight gas reservoirs can be divided into four characteristic stages. The results also indicate that if the time-varying effects and the stress sensitivity of the reservoir permeability are ignored, the calculations tend to overestimate the true gas production capacity of the reservoir and underestimate the CO2 sequestration performance.
Open AccessNumerical Simulation Study on the Mechanisms of Enhanced Gas Recovery and CO2 Storage Performance in Tight Gas Reservoirs Considering Time-Dependent Reservoir Effects
Tight sandstone gas reservoirs are characterized by low single-well productivity, rapid natural decline, and generally low recovery rates, which limit the effectiveness of conventional development strategies. The injection of CO2 into tight gas reservoirs offers broad prospects for both enhanced gas recovery (EGR) and integrated CO2 capture, utilization, and storage (CCUS). However, during the depletion and CO2 injection processes, fracture conductivity, reservoir fluid distribution, and gas–water relative permeability evolve continuously, exhibiting pronounced time-varying behavior. Conventional models have certain limitations in characterizing these time-varying mechanisms, often resulting in significant discrepancies between predicted performance and actual conditions. To address this, we develop a robust and generic model that explicitly incorporates the time-varying mechanisms and stress sensitivity. This model also accounts for the non-equilibrium flash (NEF) behavior of the gas–liquid mixture during CO2 injection into tight gas reservoirs. The successive substitution iteration method is adopted for non-equilibrium flash calculation, and the Newton–Raphson iteration (NRI) method is used for obtaining a fully implicit solution of the reservoir flow equations. The accuracy and reliability of the proposed model are verified through comparisons with commercial simulator results, and a quantitative comparison with traditional models highlights the key discrepancies caused by neglecting time-varying mechanisms. Parametric analyses further clarify the impacts of time-varying behavior and stress sensitivity on CO2-EGR performance and CO2 sequestration efficiency. The results show that the displacement process of CO2 in tight gas reservoirs can be divided into four characteristic stages. The results also indicate that if the time-varying effects and the stress sensitivity of the reservoir permeability are ignored, the calculations tend to overestimate the true gas production capacity of the reservoir and underestimate the CO2 sequestration performance.
- Open Access
Transient Pressure Performance Analysis of Hydraulically Fractured Horizontal Well in Tight Oil Reservoir
Utilizing the discrete fracture model (DFM), a transient flow model is established for fractured horizontal wells in tight oil reservoirs, accounting for threshold pressure gradient (TPG), stress sensitivity effect, hydraulic fracture parameters, and fracture distribution pattern. This model is solved using the finite-volume method (FVM), and an important sensitivity analysis is conducted. The findings reveal that the models incorporated by the threshold pressure gradient result in an upward trend in the pressure-derivative curve. As the threshold pressure gradient increases, this upward trend becomes more pronounced, rendering the distinction between flow regimes more challenging. The stress sensitivity effect predominantly impacts the pressure-derivative curve during the later flow period. Additionally, as the fracture half-length increases, the pressure performance of both fracture radial flow and formation radial flow becomes more difficult. Fracture conductivity has a significant influence during the early flow period, facilitating the identification of flow regimes with the trend of increasing fracture conductivity.
Open AccessTransient Pressure Performance Analysis of Hydraulically Fractured Horizontal Well in Tight Oil Reservoir
Utilizing the discrete fracture model (DFM), a transient flow model is established for fractured horizontal wells in tight oil reservoirs, accounting for threshold pressure gradient (TPG), stress sensitivity effect, hydraulic fracture parameters, and fracture distribution pattern. This model is solved using the finite-volume method (FVM), and an important sensitivity analysis is conducted. The findings reveal that the models incorporated by the threshold pressure gradient result in an upward trend in the pressure-derivative curve. As the threshold pressure gradient increases, this upward trend becomes more pronounced, rendering the distinction between flow regimes more challenging. The stress sensitivity effect predominantly impacts the pressure-derivative curve during the later flow period. Additionally, as the fracture half-length increases, the pressure performance of both fracture radial flow and formation radial flow becomes more difficult. Fracture conductivity has a significant influence during the early flow period, facilitating the identification of flow regimes with the trend of increasing fracture conductivity.
- Open Access
Application of Machine Learning for Productivity Prediction in Tight Gas Reservoirs
Accurate well productivity prediction plays a significant role in formulating reservoir development plans. However, traditional well productivity prediction methods lack accuracy in tight gas reservoirs; therefore, this paper quantitatively evaluates the correlations between absolute open flow and the critical parameters for Linxing tight gas reservoirs through statistical analysis. Dominant control factors are obtained by considering reservoir engineering theories, and a novel machine learning-based well productivity prediction method is proposed for tight gas reservoirs. The adaptability of the productivity prediction model is assessed through machine learning and field data analysis. Combined with the typical decline curve analysis, the estimated ultimate recovery (EUR) of a single well in the tight gas reservoir is forecasted in an appropriate range. The results of the study include 10 parameters (such as gas saturation) identified as the dominant controlling factors for well productivity and geological factors that impact the productivity in this area compared to fracturing parameters. According to the prediction results of the three models, the R2 of Support Vector Regression (SVR), Back Propagation (BP), and Random Forest (RF) models are 0.72, 0.87, and 0.91, respectively. The results indicate that RF has a more accurate prediction. In addition, the RF model is more suitable for medium and high-production wells based on the actual field data. Based on this model, it is verified that the productivity of low-producing wells is affected by water production. This study confirms the model’s reliability and application value by predicting recoverable reserves for a single well.
Open AccessApplication of Machine Learning for Productivity Prediction in Tight Gas Reservoirs
Accurate well productivity prediction plays a significant role in formulating reservoir development plans. However, traditional well productivity prediction methods lack accuracy in tight gas reservoirs; therefore, this paper quantitatively evaluates the correlations between absolute open flow and the critical parameters for Linxing tight gas reservoirs through statistical analysis. Dominant control factors are obtained by considering reservoir engineering theories, and a novel machine learning-based well productivity prediction method is proposed for tight gas reservoirs. The adaptability of the productivity prediction model is assessed through machine learning and field data analysis. Combined with the typical decline curve analysis, the estimated ultimate recovery (EUR) of a single well in the tight gas reservoir is forecasted in an appropriate range. The results of the study include 10 parameters (such as gas saturation) identified as the dominant controlling factors for well productivity and geological factors that impact the productivity in this area compared to fracturing parameters. According to the prediction results of the three models, the R2 of Support Vector Regression (SVR), Back Propagation (BP), and Random Forest (RF) models are 0.72, 0.87, and 0.91, respectively. The results indicate that RF has a more accurate prediction. In addition, the RF model is more suitable for medium and high-production wells based on the actual field data. Based on this model, it is verified that the productivity of low-producing wells is affected by water production. This study confirms the model’s reliability and application value by predicting recoverable reserves for a single well.
- Open Access
A New Method for Determining Economic Well Pattern Density and Infilling Time of Tight Gas Reservoirs
Well pattern infilling optimization is a crucial measure to enhance gas recovery, especially in tight gas reservoirs with low permeability and small-scale sand bodies. Traditional methods of determining well pattern density rely on qualitative analysis from the perspective of gas blocks. However, these methods are challenging to apply to sand bodies with different properties, and there have been no studies conducted on infilling time, which significantly impacts production increment. In response to this situation, this paper establishes a series of evaluation indexes and proposes a numerical simulation of economic well pattern density and infilling time based on real parameters obtained from the Linxing–Shenfu gas field. To quantitatively determine the economic well pattern density and infilling time based on fine characterization of sand bodies, a sensitivity analysis is conducted, considering various permeability levels and reserve abundance. Two intersection charts of economic well pattern density and infilling time, relating to reserve abundance and permeability, are then drawn. Furthermore, a real well site is selected as an example, and the infilling effect analysis confirms the reliability of the charts. The new method of determining economic well pattern density and infilling time presented in this article can provide theoretical support for the economic and efficient development of the Linxing–Shenfu gas field, serving as a useful reference for the beneficial development of similar gas reservoirs.
Open AccessA New Method for Determining Economic Well Pattern Density and Infilling Time of Tight Gas Reservoirs
Well pattern infilling optimization is a crucial measure to enhance gas recovery, especially in tight gas reservoirs with low permeability and small-scale sand bodies. Traditional methods of determining well pattern density rely on qualitative analysis from the perspective of gas blocks. However, these methods are challenging to apply to sand bodies with different properties, and there have been no studies conducted on infilling time, which significantly impacts production increment. In response to this situation, this paper establishes a series of evaluation indexes and proposes a numerical simulation of economic well pattern density and infilling time based on real parameters obtained from the Linxing–Shenfu gas field. To quantitatively determine the economic well pattern density and infilling time based on fine characterization of sand bodies, a sensitivity analysis is conducted, considering various permeability levels and reserve abundance. Two intersection charts of economic well pattern density and infilling time, relating to reserve abundance and permeability, are then drawn. Furthermore, a real well site is selected as an example, and the infilling effect analysis confirms the reliability of the charts. The new method of determining economic well pattern density and infilling time presented in this article can provide theoretical support for the economic and efficient development of the Linxing–Shenfu gas field, serving as a useful reference for the beneficial development of similar gas reservoirs.