Ahmad Ebrahimi
Research Subjects
Ahmad Ebrahimi has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Corina Dota
Cardiovascular Safety Center of Excellence and SKGs, Global Patient Safety, Oncology R&D AstraZeneca Gothenburg Sweden
2 shared publications- Dinko Rekić
Clinical Pharmacology and Quantitative Pharmacology, Clinical Pharmacology and Safety Sciences AstraZeneca AB R&D Gothenburg Sweden
2 shared publications - Jesper Sundell
Department of Automatic Control, Lund University, Lund, Sweden
2 shared publications - Joanna Parkinson
Clinical Pharmacology and Quantitative Pharmacology, Clinical Pharmacology and Safety Sciences, BioPharmaceuticals R&D AstraZeneca Gothenburg Sweden
2 shared publications - Hans Ericsson
Clinical Pharmacology and Quantitative Pharmacology, Clinical Pharmacology and Safety Sciences, BioPharmaceuticals R&D AstraZeneca Gothenburg Sweden
1 shared publication - Johanna Melin
Clinical Pharmacology and Quantitative Pharmacology, Clinical Pharmacology and Safety Sciences, BioPharmaceuticals R&D AstraZeneca Gothenburg Sweden
1 shared publication
Latest Publications
- Open Access
- 5 November 2024
- Published by Wiley in CPT: Pharmacometrics & Systems Pharmacology
- Vol. 14 (2) , 292-301
Concentration–QT modeling demonstrates that the selective mineralocorticoid receptor modulator, balcinrenone (AZD9977), does not prolong QT interval
Balcinrenone (AZD9977) is a selective mineralocorticoid receptor modulator in development in combination with dapagliflozin for treatment of heart failure with impaired kidney function and chronic kidney disease. A prespecified concentration–QT analysis was performed based on data from a phase I single ascending dose study prospectively designed as a thorough QT study substitute. Oral single doses of balcinrenone of 5–800 mg, plus fractionated doses of 800 and 1200 mg, were evaluated in 62 healthy male participants. Time‐matched 12‐lead digital electrocardiogram and plasma concentrations were measured pre‐dose and up to 48 h postdose in the participants. Analysis was performed using a linear mixed‐effect model, where baseline‐adjusted Fridericia‐corrected QT interval (ΔQTcF) was a dependent variable and time‐matched balcinrenone concentration an independent variable. The model fit was deemed adequate by evaluation of goodness‐of‐fit plots, and the slope of the concentration–ΔQTcF relationship was nonsignificant (−0.003 ms/μmol/L; 95% confidence interval [CI]: −0.181, 0.176). The high clinical exposure scenario was defined as the maximum concentration (2.156 μmol/L) following the highest expected therapeutic dose (40 mg once daily) under fed conditions and in presence of a strong cytochrome P450 3A4 inhibitor. Estimated baseline‐adjusted and placebo‐corrected QTcF interval (ΔΔQTcF) at this concentration was 0.35 ms (90% CI: −1.29, 2.00). Furthermore, the upper 90% ΔΔQTcF CI was estimated to be below the threshold of regulatory concern of 10 ms at all observed concentrations (up to 16.7 μmol/L). Hence, it can be concluded that balcinrenone does not induce QTcF prolongation at the high clinical exposure scenario.
- 5 November 2024
- Published by Wiley in CPT: Pharmacometrics & Systems Pharmacology
- Vol. 14 (2) , 292-301
Open AccessConcentration–QT modeling demonstrates that the selective mineralocorticoid receptor modulator, balcinrenone (AZD9977), does not prolong QT interval
Balcinrenone (AZD9977) is a selective mineralocorticoid receptor modulator in development in combination with dapagliflozin for treatment of heart failure with impaired kidney function and chronic kidney disease. A prespecified concentration–QT analysis was performed based on data from a phase I single ascending dose study prospectively designed as a thorough QT study substitute. Oral single doses of balcinrenone of 5–800 mg, plus fractionated doses of 800 and 1200 mg, were evaluated in 62 healthy male participants. Time‐matched 12‐lead digital electrocardiogram and plasma concentrations were measured pre‐dose and up to 48 h postdose in the participants. Analysis was performed using a linear mixed‐effect model, where baseline‐adjusted Fridericia‐corrected QT interval (ΔQTcF) was a dependent variable and time‐matched balcinrenone concentration an independent variable. The model fit was deemed adequate by evaluation of goodness‐of‐fit plots, and the slope of the concentration–ΔQTcF relationship was nonsignificant (−0.003 ms/μmol/L; 95% confidence interval [CI]: −0.181, 0.176). The high clinical exposure scenario was defined as the maximum concentration (2.156 μmol/L) following the highest expected therapeutic dose (40 mg once daily) under fed conditions and in presence of a strong cytochrome P450 3A4 inhibitor. Estimated baseline‐adjusted and placebo‐corrected QTcF interval (ΔΔQTcF) at this concentration was 0.35 ms (90% CI: −1.29, 2.00). Furthermore, the upper 90% ΔΔQTcF CI was estimated to be below the threshold of regulatory concern of 10 ms at all observed concentrations (up to 16.7 μmol/L). Hence, it can be concluded that balcinrenone does not induce QTcF prolongation at the high clinical exposure scenario.
- Open Access
- 6 March 2024
- Published by Wiley in Pharmacology Research & Perspectives
- Vol. 12 (2) , e1184
The myeloperoxidase inhibitor mitiperstat (AZD4831) does not prolong the QT interval at expected therapeutic doses
Mitiperstat is a myeloperoxidase inhibitor in clinical development for treatment of patients with heart failure and preserved or mildly reduced ejection fraction, non‐alcoholic steatohepatits and chronic obstructive pulmonary disease. We aimed to assess the risk of QT‐interval prolongation with mitiperstat using concentration–QT (C‐QT) modeling. Healthy male volunteers were randomized to receive single oral doses of mitiperstat 5, 15, 45, 135, or 405 mg (n = 6 per dose) or matching placebo (n = 10) in a phase 1 study (NCT02712372). Time‐matched pharmacokinetic and digital electrocardiogram data were collected at the baseline (pre‐dose) and at 11 time‐points up to 48 h post‐dose. C‐QT analysis was prespecified as an exploratory objective. The prespecified linear mixed effects model used baseline‐adjusted QT interval corrected for the heart rate by Fridericia's formula (ΔQTcF) as a dependent variable and plasma mitiperstat concentration as an independent variable. Initial exploratory analyses indicated that all model assumptions were met (no effect on heart rate; appropriate use of QTcF; no hysteresis; linear concentration–response relationship). Model‐predicted mean baseline‐corrected and placebo‐adjusted ΔΔQTcF was +0.73 ms (90% confidence interval [CI]: −1.73, +3.19) at the highest anticipated clinical exposure (0.093 μmol/L) during treatment with mitiperstat 5 mg once daily. The upper 90% CI was below the established threshold of regulatory concern. The 16‐fold margin to the highest observed exposure was high enough to mean that a positive control was not needed. Mitiperstat is not associated with risk of QT‐interval prolongation at expected therapeutic concentrations.
- 6 March 2024
- Published by Wiley in Pharmacology Research & Perspectives
- Vol. 12 (2) , e1184
Open AccessThe myeloperoxidase inhibitor mitiperstat (AZD4831) does not prolong the QT interval at expected therapeutic doses
Mitiperstat is a myeloperoxidase inhibitor in clinical development for treatment of patients with heart failure and preserved or mildly reduced ejection fraction, non‐alcoholic steatohepatits and chronic obstructive pulmonary disease. We aimed to assess the risk of QT‐interval prolongation with mitiperstat using concentration–QT (C‐QT) modeling. Healthy male volunteers were randomized to receive single oral doses of mitiperstat 5, 15, 45, 135, or 405 mg (n = 6 per dose) or matching placebo (n = 10) in a phase 1 study (NCT02712372). Time‐matched pharmacokinetic and digital electrocardiogram data were collected at the baseline (pre‐dose) and at 11 time‐points up to 48 h post‐dose. C‐QT analysis was prespecified as an exploratory objective. The prespecified linear mixed effects model used baseline‐adjusted QT interval corrected for the heart rate by Fridericia's formula (ΔQTcF) as a dependent variable and plasma mitiperstat concentration as an independent variable. Initial exploratory analyses indicated that all model assumptions were met (no effect on heart rate; appropriate use of QTcF; no hysteresis; linear concentration–response relationship). Model‐predicted mean baseline‐corrected and placebo‐adjusted ΔΔQTcF was +0.73 ms (90% confidence interval [CI]: −1.73, +3.19) at the highest anticipated clinical exposure (0.093 μmol/L) during treatment with mitiperstat 5 mg once daily. The upper 90% CI was below the established threshold of regulatory concern. The 16‐fold margin to the highest observed exposure was high enough to mean that a positive control was not needed. Mitiperstat is not associated with risk of QT‐interval prolongation at expected therapeutic concentrations.