AOAlexandru Onea

Alexandru Onea

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alexandru Onea has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Experimental and Numerical Investigations of a 3D-Printed Monolithic Inconel Channel in Hot Sodium up to 500°C

    by Alexandru Onea, Joachim Fuchs, Alfons Weisenburger, Steffen Antusch, Sebastian Ruck

    At KIT a 3D-printed test monolithic channel with meandering inner and outer channels and a rectangular cross-section has been developed using the Selective Laser Melting method and proposed as candidate material for a high temperature receiver. The prototype material has been manufactured from Inconel 718 powder using the Cold Spray metal powder deposition. The prototype was integrated in the high temperature SOLTEC-2 sodium facility and heated only on one side, deemed as the side that receives the solar irradiation. Experimental investigations have been performed up to 500°C. Besides the experimental investigations performed the present study presents also the numerical simulations of the 3D-printed prototype material and a comparison is made between the experimental and numerical results.

  • Open Access

    CFD Study of a Sodium High-Flux Receiver Designed for Additive Manufacturing

    by Joachim Fuchs, Alexandru Onea, Michael Böttcher

    It has been demonstrated that heat fluxes greater than 4 MW/m2 can occur at high-flux concentrated solar power (CSP) receivers. In the present paper, a receiver design for additive manufacturing processing is proposed using sodium as heat transfer medium. The proposed design incorporates helical structures within the ducts, which facilitate the swirling motion of the sodium and promote the transportation of the colder coolant towards the heated wall. The objective of this configuration is twofold: first, to enhance heat transfer, and second, to mitigate local overheating at the liquid-solid interface of the receiver. The effectiveness of design variations is substantiated by CFD (Computational Fluid Dynamics) investigations.

  • Open Access

    Experimental Investigations and Qualification of Innovative Flow Sensors in the 1000 K SOLTEC-2 Sodium Loop

    by Alexandru Onea, Nico Krauter, Wolfgang Hering, Stephan Lenk, Sebastian Ruck, Robert Stieglitz, Gunter Gerbeth

    Liquid metals, such as sodium, have been already successfully used as heat transfer fluids (HTF) in concentrating solar power (CSP) plants up to ~550 °C. Even higher temperatures can be achieved and are envisioned for future CSP plants. The lack of measuring flow rate devices at high temperatures for liquid metals motivated this study. The present paper presents the experimental mock-up and the experimental results obtained with the SOLTEC-2 facility for two test flow sensors, one innovative eddy current flow sensor (ECFM) developed at HZDR, Germany and a built-in permanent magnet fly-wheel sensor for runs up to a sodium temperature of 700 °C. The signals of the sensors are compared also against the power level of the sodium pump.