Yi Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yi Liu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Ming Chen
School of Physics and Electronics, Hunan Normal University, Changsha, China
2 shared publications - Yun Cheng
College of Information, Hunan University of Humanities, Science and Technology, Loudi 417000, China
2 shared publications - Haimiao Long
School of Physics and Electronics, Hunan Normal University, Changsha 410081, China
1 shared publication - Hanwei Li
School of Physics and Electronics, Hunan Normal University, Changsha, China
1 shared publication - Jiaqiang Xu
School of Physics and Electronics, Hunan Normal University, Changsha, China
1 shared publication - Jie Zhou
School of Physics and Electronics, Hunan Normal University, Changsha, China
1 shared publication
Latest Publications
- 8 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (6) , 1861-1869
Real-Time 30-GSa/s Precoded and Partial Pre-Emphasized DMT Transceiver for Short-Reach IMDD Transmission
The precoding technique has been widely studied in multi-carrier modulation systems such as discrete multi-tone (DMT), due to its ability to equalize subcarrier signal-to-noise (SNR) and reduce signal peak-to-average power ratio. In this work, we implement a low-complexity real-time 30-GSa/s DMT transceiver on a single field programmable gate array chip, enabled by simplified fast Fourier transform (FFT) algorithms and timing synchronization, block precoding (BP) and partial pre-emphasis (PPE) techniques. Four software-selectable BP techniques, i.e., the traditional concatenated BP (CBP) and the interleaved BP (IBP) based on FFT or fast Walsh–Hadamard transform (FWHT), and complete pre-emphasis (CPE) or PPE schemes are implemented in the transceiver. FWHT-CBP/IBP saves 60% on-chip registers and 67% look-up tables and 100% multipliers compared to FFT-CBP/IBP. Besides, more than 35% multipliers for the transceiver are reduced with the simplified FFTs in comparison with Spiral FFTs. The real-time transceiver is investigated in a short-reach intensity modulation and direct detection transmission system. The results exhibit that IBP can afford better SNR equalization and outperform CBP ones, and FWHT-IBP has a similar bit error rate (BER) performance to FFT-IBP. With the help of FWHT-IBP and PPE, the real-time 40-Gbit/s 16-QAM-DMT signals are successfully transmitted over 20-km standard single-mode fiber link with the BER below 3.8e-3 during 5-hour continuous measurements.
- 8 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (6) , 1861-1869
Real-Time 30-GSa/s Precoded and Partial Pre-Emphasized DMT Transceiver for Short-Reach IMDD Transmission
The precoding technique has been widely studied in multi-carrier modulation systems such as discrete multi-tone (DMT), due to its ability to equalize subcarrier signal-to-noise (SNR) and reduce signal peak-to-average power ratio. In this work, we implement a low-complexity real-time 30-GSa/s DMT transceiver on a single field programmable gate array chip, enabled by simplified fast Fourier transform (FFT) algorithms and timing synchronization, block precoding (BP) and partial pre-emphasis (PPE) techniques. Four software-selectable BP techniques, i.e., the traditional concatenated BP (CBP) and the interleaved BP (IBP) based on FFT or fast Walsh–Hadamard transform (FWHT), and complete pre-emphasis (CPE) or PPE schemes are implemented in the transceiver. FWHT-CBP/IBP saves 60% on-chip registers and 67% look-up tables and 100% multipliers compared to FFT-CBP/IBP. Besides, more than 35% multipliers for the transceiver are reduced with the simplified FFTs in comparison with Spiral FFTs. The real-time transceiver is investigated in a short-reach intensity modulation and direct detection transmission system. The results exhibit that IBP can afford better SNR equalization and outperform CBP ones, and FWHT-IBP has a similar bit error rate (BER) performance to FFT-IBP. With the help of FWHT-IBP and PPE, the real-time 40-Gbit/s 16-QAM-DMT signals are successfully transmitted over 20-km standard single-mode fiber link with the BER below 3.8e-3 during 5-hour continuous measurements.
- Open Access
Probabilistically-Shaped DMT for IM-DD Systems with Low-Complexity Fast WHT-Based PDSP
Transmission capacity and receiver sensitivity of an intensity-modulation direct detection (IM-DD) optical discrete multi-tone (DMT) system can be improved by using the probabilistically shaping (PS) technique. However, different probabilistic distributions will be required owing to the unbalanced signal-to-noise ratio (SNR) among data-carrying subcarriers (SCs) induced by the imperfect frequency response of optical/electrical devices, which can increase the implementation complexity of the PS-DMT transceiver. In this work, different signal pre-processing schemes including pre-equalization, Walsh–Hadamard transform (WHT)-based full data-carrying SCs precoding (FDSP) and fast WHT-based partial data-carrying SCs precoding (PDSP) are investigated for SNR equalization in a short-reach PS-DMT transmission system. After transmission over 50 km single-mode fiber, the experimental results indicated that three pre-processed signals have almost the same generalized mutual information (GMI) performance and receiver sensitivity improvements. The proposed fast WHT-based PDSP scheme may be a good option for the implementation of the PS-DMT transmission systems with a large SC SNR fluctuation regarding computational complexity.
Open AccessProbabilistically-Shaped DMT for IM-DD Systems with Low-Complexity Fast WHT-Based PDSP
Transmission capacity and receiver sensitivity of an intensity-modulation direct detection (IM-DD) optical discrete multi-tone (DMT) system can be improved by using the probabilistically shaping (PS) technique. However, different probabilistic distributions will be required owing to the unbalanced signal-to-noise ratio (SNR) among data-carrying subcarriers (SCs) induced by the imperfect frequency response of optical/electrical devices, which can increase the implementation complexity of the PS-DMT transceiver. In this work, different signal pre-processing schemes including pre-equalization, Walsh–Hadamard transform (WHT)-based full data-carrying SCs precoding (FDSP) and fast WHT-based partial data-carrying SCs precoding (PDSP) are investigated for SNR equalization in a short-reach PS-DMT transmission system. After transmission over 50 km single-mode fiber, the experimental results indicated that three pre-processed signals have almost the same generalized mutual information (GMI) performance and receiver sensitivity improvements. The proposed fast WHT-based PDSP scheme may be a good option for the implementation of the PS-DMT transmission systems with a large SC SNR fluctuation regarding computational complexity.
- Open Access
- 29 June 2021
- Published by Wiley in Concurrency and Computation: Practice and Experience
- Vol. 33 (17) , e6278
Research on Indoor UWB Positioning Based on Expectation Maximization in NLOS Environment
Summary: Ultra‐wide band (UWB) technology is especially suitable for indoor positioning because of its strong anti‐interference ability, it can achieve centimeter‐level positioning accuracy in the line of sight (LOS) environment, but it is challenging to construct a robust and high‐precision algorithm in indoor complex and changeable environments. Therefore, it establishes an improved standard Kalman filter (SKF) based on expectation maximization (SKF‐EM), which models the prediction error covariance and measurement noise using the maximum likelihood criterion, estimates the filter parameters online through the expectation maximum theory, and updates the Kalman filter gain according to the Kalman filter based on dropped measurements method (SKF‐DMM). Experimental results show that: in case of serious occlusion, the maximum positioning error of SKF‐EM algorithm is 1.03 m, 39% lower than that of SKF and 60.2% lower than that of UWB.
- 29 June 2021
- Published by Wiley in Concurrency and Computation: Practice and Experience
- Vol. 33 (17) , e6278
Open AccessResearch on Indoor UWB Positioning Based on Expectation Maximization in NLOS Environment
Summary: Ultra‐wide band (UWB) technology is especially suitable for indoor positioning because of its strong anti‐interference ability, it can achieve centimeter‐level positioning accuracy in the line of sight (LOS) environment, but it is challenging to construct a robust and high‐precision algorithm in indoor complex and changeable environments. Therefore, it establishes an improved standard Kalman filter (SKF) based on expectation maximization (SKF‐EM), which models the prediction error covariance and measurement noise using the maximum likelihood criterion, estimates the filter parameters online through the expectation maximum theory, and updates the Kalman filter gain according to the Kalman filter based on dropped measurements method (SKF‐DMM). Experimental results show that: in case of serious occlusion, the maximum positioning error of SKF‐EM algorithm is 1.03 m, 39% lower than that of SKF and 60.2% lower than that of UWB.