EHElnaz Hosseinzadeh

Elnaz Hosseinzadeh

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Elnaz Hosseinzadeh has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fabrication of Soft Transparent Patient‐Specific Vascular Models with Stereolithographic 3D printing and Thiol‐Based Photopolymerizable Coatings

    by Elnaz Hosseinzadeh, Beatriz Bosques‐Palomo, Francisco Carmona‐Arriaga, Mario Alejandro Fabiani, Alan Aguirre‐Soto

    An ideal vascular phantom should be anatomically accurate, have mechanical properties as close as possible to the tissue, and be sufficiently transparent for ease of visualization. However, materials that enable the convergence of these characteristics have remained elusive. The fabrication of patient‐specific vascular phantoms with high anatomical fidelity, optical transparency, and mechanical properties close to those of vascular tissue is reported. These final properties are achieved by 3D printing patient‐specific vascular models with commercial elastomeric acrylic‐based resins before coating them with thiol‐based photopolymerizable resins. Ternary thiol‐ene‐acrylate chemistry is found optimal. A PETMP/allyl glycerol ether (AGE)/polyethylene glycol diacrylate (PEGDA) coating with a 30/70% AGE/PEGDA ratio applied on a flexible resin yielded elastic modulus, UTS, and elongation of 3.41 MPa, 1.76 MPa, and 63.2%, respectively, in range with the human aortic wall. The PETMP/AGE/PEGDA coating doubled the optical transmission from 40% to 80%, approaching 88% of the benchmark silicone‐based elastomer. Higher transparency correlates with a decrease in surface roughness from 2000 to 90 nm after coating. Coated 3D‐printed anatomical replicas are showcased for pre‐procedural planning and medical training with good radio‐opacity and echogenicity. Thiol‐click chemistry coatings, as a surface treatment for elastomeric stereolithographic 3D‐printed objects, address inherent limitations of photopolymer‐based additive manufacturing.