Alexandr Bolshakov
Research Subjects
Research Interests
Alexandr Bolshakov has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Alexey Vasiliev
Dubna State University, Dubna, Russia
1 shared publication - Andrey Nikitin
LLC “C-Component”, Tushinskaya Strt., 17, 125362 Moscow, Russia
1 shared publication - Anna Dmitrieva
LLC “C-Component”, Tushinskaya Strt., 17, 125362 Moscow, Russia
1 shared publication - Oleg Kul
LLC “C-Component”, Tushinskaya Strt., 17, 125362 Moscow, Russia
1 shared publication
Latest Publications
- Open Access
- 1 April 2024
- Published by MDPI AG in Proceedings
- Vol. 97 (1) , 128
Screen-Printed Ceramic MEMS for Metal Oxide Gas Sensor
We developed a new approach to the fabrication of MEMS (Microelectromechanical system) substrates for gas sensors. This full screen-printing approach consists in the application of sacrificial material, which is solid at the near-room temperature of printing and becomes powder after firing of the elements of the sensor and, therefore, can be removed from under the suspended elements of the MEMS structure in an ultrasonic bath. The glass–ceramic MEMS is a cantilever structure equipped with a Pt-based microheater on the end edge with the sensing layer. Screen-printing provides cheap fabrication, robustness, and low power (~120 mW at 450 °C) for the sensing element.
- 1 April 2024
- Published by MDPI AG in Proceedings
- Vol. 97 (1) , 128
Open AccessScreen-Printed Ceramic MEMS for Metal Oxide Gas Sensor
We developed a new approach to the fabrication of MEMS (Microelectromechanical system) substrates for gas sensors. This full screen-printing approach consists in the application of sacrificial material, which is solid at the near-room temperature of printing and becomes powder after firing of the elements of the sensor and, therefore, can be removed from under the suspended elements of the MEMS structure in an ultrasonic bath. The glass–ceramic MEMS is a cantilever structure equipped with a Pt-based microheater on the end edge with the sensing layer. Screen-printing provides cheap fabrication, robustness, and low power (~120 mW at 450 °C) for the sensing element.