Qian Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Qian Wang has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Zhengzhong Zhou
National‐Local Joint Engineering Research Center of Biomass Refining and High‐Quality Utilization, Institute of Urban and Rural Mining, Changzhou Key Laboratory of Biomass Green, Safe & High Value Utilization Changzhou University Changzhou China
7 shared publications Taoli Huhe
4 shared publicationsTian-Dan Lu
3 shared publicationsXiaoshan Meng
3 shared publicationsQigang Wu
2 shared publications- Taoli Huhe
Changzhou Key Laboratory of Biomass Green, Safe & High Value Utilization Technology, Institute of Urban and Rural Mining, Changzhou University, Changzhou, China
2 shared publications
Latest Publications
- 16 May 2026
- Published by Elsevier in Journal of Membrane Science
- Vol. 753
Sustainable all-aqueous assembly of nanofiltration membranes via silicate-mediated kinetic regulation
- 16 May 2026
- Published by Elsevier in Journal of Membrane Science
- Vol. 753
Sustainable all-aqueous assembly of nanofiltration membranes via silicate-mediated kinetic regulation
- Open Access
Effects of Latent Solvent Content on Tuning the Nanofiltration Performance of Nanofibrous Composite Membranes
This study aims to optimize the application of electrospun nanofibrous substrates in thin-film composite (TFC) nanofiltration (NF) membranes for enhanced liquid separation efficiency by employing a method of effective welding between fibers using latent solvents. Polyacrylonitrile (PAN) nanofiber substrates were fabricated via electrospinning, and a dense polyamide selective layer was formed on their surface through interfacial polymerization (IP). The investigation focused on the effects of different solvent systems, particularly the role of dimethyl sulfoxide (DMSO) as a latent solvent, on the nanostructure and final membrane performance. The results indicate that increasing the DMSO content can enhance the greenness of the fabrication process, the substrate hydrophilicity, and the mechanical strength, while also influencing the thickness and morphology of the polyamide layer. At a DMSO rate of 30%, the composite membrane achieves optimal pure water permeability and high rejection rates; when the DMSO content exceeds 40%, structural inhomogeneity in the substrate membrane leads to an increase in defects, significantly deteriorating membrane performance. These findings provide theoretical insights and technical guidance for the application of electrospinning technology in designing efficient and stable NF membranes.
Open AccessEffects of Latent Solvent Content on Tuning the Nanofiltration Performance of Nanofibrous Composite Membranes
This study aims to optimize the application of electrospun nanofibrous substrates in thin-film composite (TFC) nanofiltration (NF) membranes for enhanced liquid separation efficiency by employing a method of effective welding between fibers using latent solvents. Polyacrylonitrile (PAN) nanofiber substrates were fabricated via electrospinning, and a dense polyamide selective layer was formed on their surface through interfacial polymerization (IP). The investigation focused on the effects of different solvent systems, particularly the role of dimethyl sulfoxide (DMSO) as a latent solvent, on the nanostructure and final membrane performance. The results indicate that increasing the DMSO content can enhance the greenness of the fabrication process, the substrate hydrophilicity, and the mechanical strength, while also influencing the thickness and morphology of the polyamide layer. At a DMSO rate of 30%, the composite membrane achieves optimal pure water permeability and high rejection rates; when the DMSO content exceeds 40%, structural inhomogeneity in the substrate membrane leads to an increase in defects, significantly deteriorating membrane performance. These findings provide theoretical insights and technical guidance for the application of electrospinning technology in designing efficient and stable NF membranes.
- 27 January 2025
- Published by Elsevier in Journal of Membrane Science
- Vol. 720
Alkali-assisted metal-phenolic network assembly for structural regulation of nanofiltration membranes
- 27 January 2025
- Published by Elsevier in Journal of Membrane Science
- Vol. 720
Alkali-assisted metal-phenolic network assembly for structural regulation of nanofiltration membranes
- 24 March 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 344
The improvement of nanofiltration membrane performance with lignin Cu complex as interlayer
- 24 March 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 344
The improvement of nanofiltration membrane performance with lignin Cu complex as interlayer
- Open Access
- 22 February 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (5) , 1788
Research on Life Cycle Assessment and Performance Comparison of Bioethanol Production from Various Biomass Feedstocks
Bioethanol, as a renewable energy source, has been widely used in the energy sector, particularly in replacing traditional petroleum energy, and holds great potential. This study involves a whole life cycle assessment of bioethanol production and the co-production of high-value by-products—xylose, lignin, and steam—using three types of waste biomass: corn cobs, corn straw, and wheat straw as feedstocks by chopping, pretreatment, hydrolysis, fermentation, and distillation methods. Secondly, the benefits of three raw materials are compared for preparing bioethanol, and their impact on the environment and energy production is analyzed. The comparison indicates that corn cobs offer the best overall benefits, with a net energy balance (NEB) of 6902 MJ/Mg of ethanol and a net energy ratio (NER) of 1.30. The global warming potential (GWP) is 1.75 × 10−2, acidification potential (AP) is 1.02 × 10−2, eutrophication potential (EP) is 2.63 × 10−4, photochemical ozone creation potential (POCP) is 3.19 × 10−8, and human toxicity potential (HTP) is 1.52 × 10−4. This paper can provide a theoretical reference and data supporting the green refining of bioethanol and the high-value utilization of by-products, and broaden its application prospects.
- 22 February 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (5) , 1788
Open AccessResearch on Life Cycle Assessment and Performance Comparison of Bioethanol Production from Various Biomass Feedstocks
Bioethanol, as a renewable energy source, has been widely used in the energy sector, particularly in replacing traditional petroleum energy, and holds great potential. This study involves a whole life cycle assessment of bioethanol production and the co-production of high-value by-products—xylose, lignin, and steam—using three types of waste biomass: corn cobs, corn straw, and wheat straw as feedstocks by chopping, pretreatment, hydrolysis, fermentation, and distillation methods. Secondly, the benefits of three raw materials are compared for preparing bioethanol, and their impact on the environment and energy production is analyzed. The comparison indicates that corn cobs offer the best overall benefits, with a net energy balance (NEB) of 6902 MJ/Mg of ethanol and a net energy ratio (NER) of 1.30. The global warming potential (GWP) is 1.75 × 10−2, acidification potential (AP) is 1.02 × 10−2, eutrophication potential (EP) is 2.63 × 10−4, photochemical ozone creation potential (POCP) is 3.19 × 10−8, and human toxicity potential (HTP) is 1.52 × 10−4. This paper can provide a theoretical reference and data supporting the green refining of bioethanol and the high-value utilization of by-products, and broaden its application prospects.
- 23 August 2023
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 128, 569-577
Layered double hydroxide nanosheets embedded β-cyclodextrin composite membranes with enhanced chiral separation performance
- 23 August 2023
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 128, 569-577
Layered double hydroxide nanosheets embedded β-cyclodextrin composite membranes with enhanced chiral separation performance
- 29 June 2023
- Published by Elsevier in Chemosphere
- Vol. 337, 139317
Anti-fouling PVDF membranes incorporating photocatalytic biochar-TiO2 composite for lignin recycle
- 29 June 2023
- Published by Elsevier in Chemosphere
- Vol. 337, 139317
Anti-fouling PVDF membranes incorporating photocatalytic biochar-TiO2 composite for lignin recycle
- 21 January 2023
- Published by Elsevier in Chemosphere
- Vol. 318, 137930
Roles and gains of coordination chemistry in nanofiltration membrane: A review
- 21 January 2023
- Published by Elsevier in Chemosphere
- Vol. 318, 137930
Roles and gains of coordination chemistry in nanofiltration membrane: A review
- Open Access
Designing Multi-Stage 2 A/O-MBR Processes for a Higher Removal Rate of Pollution in Wastewater
Multi-stage A/O-MBR processes were designed to improve wastewater treatment efficiency; three different designs were carried out and compared in this study. The 2(A/O)-MBR process, i.e., with two sets of anoxic/oxic tanks in series, showed better effluent quality than A/O-MBR and 3(A/O)-MBR processes. The removal rates of COD, NH-N, TP and TN were 95.29%, 89.47%, 83.55% and 78.58%, respectively, complying satisfactorily with China’s urban sewage treatment plant pollutant discharge standards. In terms of membrane fouling, the 3(A/O)-MBR process demonstrated the lowest fouling propensity. The microbial community structure in each bioreaction tank was analyzed, the results from which matched with the process efficiency and fouling behavior.Open AccessDesigning Multi-Stage 2 A/O-MBR Processes for a Higher Removal Rate of Pollution in Wastewater
Multi-stage A/O-MBR processes were designed to improve wastewater treatment efficiency; three different designs were carried out and compared in this study. The 2(A/O)-MBR process, i.e., with two sets of anoxic/oxic tanks in series, showed better effluent quality than A/O-MBR and 3(A/O)-MBR processes. The removal rates of COD, NH-N, TP and TN were 95.29%, 89.47%, 83.55% and 78.58%, respectively, complying satisfactorily with China’s urban sewage treatment plant pollutant discharge standards. In terms of membrane fouling, the 3(A/O)-MBR process demonstrated the lowest fouling propensity. The microbial community structure in each bioreaction tank was analyzed, the results from which matched with the process efficiency and fouling behavior.