Kyoya Uemura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kyoya Uemura has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Tomoyuki Obuchi
Kyoto University
3 shared publications - Toshiyuki Tanaka
Kyoto University
2 shared publications H. Matsuda
Dep. Mater. Sci. Technol., Grad. Sch. Eng. Sci., Kyushu Univ., Kasuga, Fukuoka 816, Jap
1 shared publicationN. Miura
Dep. Mater. Sci. Technol., Grad. Sch. Eng. Sci., Kyushu Univ., Kasuga, Fukuoka 816, Jap
1 shared publicationN. Yamazoe
Dep. Mater. Sci. Technol., Grad. Sch. Eng. Sci., Kyushu Univ., Kasuga, Fukuoka 816, Jap
1 shared publicationS. Ohta
Department of Neurosurgery, Hamamatsu University, School of Medicine, Japan
1 shared publication
Latest Publications
- Open Access
- 2 March 2026
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 8 (1)
Approximate modeling for supercritical Galton-Watson branching processes with compound Poisson-gamma distribution
We study asymptotic properties of supercritical Galton-Watson (GW) branching processes in the asymptotic where the mean of the offspring distribution approaches 1 from above. We show that the population-size distribution of the GW branching processes at a sufficiently large generation in this asymptotic can be approximated by a compound Poisson-gamma distribution. Numerical experiments revealed that the compound Poisson-gamma models were in good agreement with the corresponding GW models for sufficiently large generations under a reasonable parameter regime. Our results can be regarded as supporting the use of the compound Poisson-gamma model as a model for cascaded multiplication processes.
- 2 March 2026
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 8 (1)
Open AccessApproximate modeling for supercritical Galton-Watson branching processes with compound Poisson-gamma distribution
We study asymptotic properties of supercritical Galton-Watson (GW) branching processes in the asymptotic where the mean of the offspring distribution approaches 1 from above. We show that the population-size distribution of the GW branching processes at a sufficiently large generation in this asymptotic can be approximated by a compound Poisson-gamma distribution. Numerical experiments revealed that the compound Poisson-gamma models were in good agreement with the corresponding GW models for sufficiently large generations under a reasonable parameter regime. Our results can be regarded as supporting the use of the compound Poisson-gamma model as a model for cascaded multiplication processes.
- 25 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 72 (1053587X) , 1724-1738
Sparse Modeling for Spectrometer Based on Band Measurement
In typical spectrometric measurement systems, a high-resolution spectrum is obtained directly via sequential observations with a narrow slit-like measurement window at the expense of sensitivity. In this paper, we propose a novel spectrometric method applicable to these typical spectrometric systems: a multiplexed low-resolution measurement with a wide measurement window, band measurement (BM), is combined with sparse-modeling-based post-processing to obtain the original high-resolution spectrum. BM is expected to improve the measurement signal-to-noise ratio because of the increase in the sample quantities reaching the detector by widening the measurement window. BM has the significant practical advantage that it can be easily implemented in spectrometric measurement systems without device alterations. To evaluate the effectiveness of our proposal both theoretically and experimentally, we formulate the sparse-modeling-based post-processing in the proposal in terms of the least absolute shrinkage and selection operator (lasso) and perform a theoretical analysis and simulation studies concerning the resulting spectrometric method named BM-lasso. In the theoretical analysis, we derive density evolution equations for belief propagation on the BM-lasso model and obtain the expected errors of estimators of BM-lasso. The numerical evaluations of the theoretical analysis result revealed that BM-lasso achieved lower mean square error than the conventional measurement method under the same parameter conditions. Furthermore, simulation studies with both artificial and actual mass spectra show that BM-lasso significantly improves the accuracy, sensitivity, and specificity compared with the conventional measurement method, demonstrating the practicality of the proposed method.
- 25 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 72 (1053587X) , 1724-1738
Sparse Modeling for Spectrometer Based on Band Measurement
In typical spectrometric measurement systems, a high-resolution spectrum is obtained directly via sequential observations with a narrow slit-like measurement window at the expense of sensitivity. In this paper, we propose a novel spectrometric method applicable to these typical spectrometric systems: a multiplexed low-resolution measurement with a wide measurement window, band measurement (BM), is combined with sparse-modeling-based post-processing to obtain the original high-resolution spectrum. BM is expected to improve the measurement signal-to-noise ratio because of the increase in the sample quantities reaching the detector by widening the measurement window. BM has the significant practical advantage that it can be easily implemented in spectrometric measurement systems without device alterations. To evaluate the effectiveness of our proposal both theoretically and experimentally, we formulate the sparse-modeling-based post-processing in the proposal in terms of the least absolute shrinkage and selection operator (lasso) and perform a theoretical analysis and simulation studies concerning the resulting spectrometric method named BM-lasso. In the theoretical analysis, we derive density evolution equations for belief propagation on the BM-lasso model and obtain the expected errors of estimators of BM-lasso. The numerical evaluations of the theoretical analysis result revealed that BM-lasso achieved lower mean square error than the conventional measurement method under the same parameter conditions. Furthermore, simulation studies with both artificial and actual mass spectra show that BM-lasso significantly improves the accuracy, sensitivity, and specificity compared with the conventional measurement method, demonstrating the practicality of the proposed method.
- Open Access
- 21 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in TechRxiv
Sparse Modeling for Spectrometer Based on Band Measurement
- 21 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in TechRxiv
Open AccessSparse Modeling for Spectrometer Based on Band Measurement
- 1 January 1998
- Published by Taylor & Francis in British Journal Of Neurosurgery
- Vol. 12 (5) , 419-422
Regrowth of the residual tumour after acoustic neurinoma surgery
Ideally, acoustic neurinomas should be completely removed without neurological deficit. In some cases, however, removal is subtotal in order to preserve anatomical continuity of the facial nerve. In this report we discuss the regrowth of residual tumour in these patients and the difference between regrowing and dormant tumours. Eight of 81 patients with acoustic neurinomas where the facial nerve was anatomically preserved leaving tumour overlying it were investigated and followed-up. Only one case with residual tumour along the 7th nerve from the intrameatal portion to its entry to the brainstem showed regrowth 3.5 years after the operation. In the other seven cases with residual tumour along the nerve from the porus to the brainstem, the tumour remained dormant during a follow-up period of 4.5-8.5 years. Removal of tumour in the internal auditory meatus may make regrowth unlikely.
- 1 January 1998
- Published by Taylor & Francis in British Journal Of Neurosurgery
- Vol. 12 (5) , 419-422
Regrowth of the residual tumour after acoustic neurinoma surgery
Ideally, acoustic neurinomas should be completely removed without neurological deficit. In some cases, however, removal is subtotal in order to preserve anatomical continuity of the facial nerve. In this report we discuss the regrowth of residual tumour in these patients and the difference between regrowing and dormant tumours. Eight of 81 patients with acoustic neurinomas where the facial nerve was anatomically preserved leaving tumour overlying it were investigated and followed-up. Only one case with residual tumour along the 7th nerve from the intrameatal portion to its entry to the brainstem showed regrowth 3.5 years after the operation. In the other seven cases with residual tumour along the nerve from the porus to the brainstem, the tumour remained dormant during a follow-up period of 4.5-8.5 years. Removal of tumour in the internal auditory meatus may make regrowth unlikely.
- 15 January 1991
- Published by Wiley in ChemInform
- Vol. 22 (2)
ChemInform Abstract: Bi-Functional Oxygen Electrode Using Large Surface Area La1-xCaxCoO3 for Rechargeable Metal-Air Battery.
ChemInform is a weekly Abstracting Service, delivering concise information at a glance that was extracted from about 100 leading journals. To access a ChemInform Abstract of an article which was published elsewhere, please select a “Full Text” option. The original article is trackable via the “References” option.
- 15 January 1991
- Published by Wiley in ChemInform
- Vol. 22 (2)
ChemInform Abstract: Bi-Functional Oxygen Electrode Using Large Surface Area La1-xCaxCoO3 for Rechargeable Metal-Air Battery.
ChemInform is a weekly Abstracting Service, delivering concise information at a glance that was extracted from about 100 leading journals. To access a ChemInform Abstract of an article which was published elsewhere, please select a “Full Text” option. The original article is trackable via the “References” option.