Ariosvaldo Junior Sousa Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ariosvaldo Junior Sousa Silva has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Marcos Vinicius dos Santos Rezende
Advanced Materials Physics Laboratory Physics Department Federal University of Sergipe São Cristóvão Sergipe Brazil
4 shared publications Iure da S. Carvalho
3 shared publications- Eralci Moreira Therézio
Institute of Physics, Federal University of Mato Grosso, Cuiabá, MT, Brazil, Brazil
2 shared publications Patresio A.M. Nascimento
2 shared publications- Adriano Borges Andrade
Materials Science and Engineering Department, Federal University of Sergipe, São Cristóvão 49107-230, SE, Brazil
1 shared publication Amanda I. dos S. Barbosa
Grupo de Nanomateriais Funcionais (GNF), Departamento de Física, Universidade Federal de Sergipe, 49100-000, São Cristóvão, SE, Brazil
1 shared publication
Latest Publications
- Open Access
- 21 January 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (4) , 6697-6706
The Optimization of the Luminescence Intensity Ratio in the YVO 4 :Er 3+ ,Nd 3+ Phosphors within the First and Second Biological Windows
The optimization of the host materials is one of the methods that could be used to improve the relative sensitivity of luminescent thermometers. Here, we show the host optimization emission of Er3+ and Nd3+ ions in the YVO4 phosphors produced by a modified sol–gel route using glucose as a polymerizing agent. X-ray diffraction (XRD) was realized to analyze the formation of the crystalline phase. We found that the emission ratio depends on the size of the YVO4 particle. Here, we show that YVO4:Er3+,Nd3+ phosphors exhibit particle size-dependent relative sensitivity values, varying from 1.32 ± 0.02 to 1.80 ± 0.02% K–1 at 293 K, and temperature uncertainties below 0.7 K within the physiological range 293–233 K, operating entirely in the first and second biological windows. These sensitivity and temperature uncertainty values were achieved by defining two thermometric parameters as the luminescence intensity ratios, exploiting a combination of emissions from both ion species.
- 21 January 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (4) , 6697-6706
Open AccessThe Optimization of the Luminescence Intensity Ratio in the YVO 4 :Er 3+ ,Nd 3+ Phosphors within the First and Second Biological Windows
The optimization of the host materials is one of the methods that could be used to improve the relative sensitivity of luminescent thermometers. Here, we show the host optimization emission of Er3+ and Nd3+ ions in the YVO4 phosphors produced by a modified sol–gel route using glucose as a polymerizing agent. X-ray diffraction (XRD) was realized to analyze the formation of the crystalline phase. We found that the emission ratio depends on the size of the YVO4 particle. Here, we show that YVO4:Er3+,Nd3+ phosphors exhibit particle size-dependent relative sensitivity values, varying from 1.32 ± 0.02 to 1.80 ± 0.02% K–1 at 293 K, and temperature uncertainties below 0.7 K within the physiological range 293–233 K, operating entirely in the first and second biological windows. These sensitivity and temperature uncertainty values were achieved by defining two thermometric parameters as the luminescence intensity ratios, exploiting a combination of emissions from both ion species.
- 19 January 2026
- Published by IOP Publishing in Physica Scripta
- Vol. 101 (4)
Substrate effect on the degradation process of hybrid perovskite halide thin films
A quantitative analysis of the substrate influence on the degradation process induced by exposure to heat and humidity, and its effect on the optoelectronic properties of multication hybrid perovskite thin films (FAYCs1₋Y Pb(BrₓI1-x)₃), was carried out using traditional spectroscopic techniques such as UV-Vis optical absorption and photoluminescence (PL), along with X-ray diffraction (XRD) to investigate the structural characteristics of the samples. The films were deposited onto FTO and PEDOT:PSS substrates via the spin-coating technique for two different cesium and bromine concentration ratios: 17%/17% and 17%/38%, respectively. During the degradation process, the perovskite film undergoes phase segregation, leading to a cation-rich zone formed by the combination of multiple halides. The presence of hexagonal perovskite phases was observed, attributed to the crystallization process. The results demonstrate a correlation between the degradation rate of the films and the morphological roughness of the substrates, with films deposited on FTO substrates degrading more slowly than those on PEDOT:PSS. A decrease in the maximum absorption values was observed as a function of material degradation. Moreover, the sample with the higher bromine content exhibited a blueshift in the onset of the absorption spectrum, consequently increasing the optical bandgap of the film. In the photoluminescence spectra, we observed a decay in the emission intensity and a shift in the emission peak position of the films due to halide segregation. This work provides insights into the degradation mechanisms of hybrid perovskites, with particular emphasis on the substrate effect and its impact on the emission properties of these materials.
- 19 January 2026
- Published by IOP Publishing in Physica Scripta
- Vol. 101 (4)
Substrate effect on the degradation process of hybrid perovskite halide thin films
A quantitative analysis of the substrate influence on the degradation process induced by exposure to heat and humidity, and its effect on the optoelectronic properties of multication hybrid perovskite thin films (FAYCs1₋Y Pb(BrₓI1-x)₃), was carried out using traditional spectroscopic techniques such as UV-Vis optical absorption and photoluminescence (PL), along with X-ray diffraction (XRD) to investigate the structural characteristics of the samples. The films were deposited onto FTO and PEDOT:PSS substrates via the spin-coating technique for two different cesium and bromine concentration ratios: 17%/17% and 17%/38%, respectively. During the degradation process, the perovskite film undergoes phase segregation, leading to a cation-rich zone formed by the combination of multiple halides. The presence of hexagonal perovskite phases was observed, attributed to the crystallization process. The results demonstrate a correlation between the degradation rate of the films and the morphological roughness of the substrates, with films deposited on FTO substrates degrading more slowly than those on PEDOT:PSS. A decrease in the maximum absorption values was observed as a function of material degradation. Moreover, the sample with the higher bromine content exhibited a blueshift in the onset of the absorption spectrum, consequently increasing the optical bandgap of the film. In the photoluminescence spectra, we observed a decay in the emission intensity and a shift in the emission peak position of the films due to halide segregation. This work provides insights into the degradation mechanisms of hybrid perovskites, with particular emphasis on the substrate effect and its impact on the emission properties of these materials.
- 8 September 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 288
Tunable visible luminescence from Tb3+/Fe3+ co-doped LiAl5O8 under UV and X-ray excitation
- 8 September 2025
- Published by Elsevier in Journal of Luminescence
- Vol. 288
Tunable visible luminescence from Tb3+/Fe3+ co-doped LiAl5O8 under UV and X-ray excitation