Fumihiko Aiga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Fumihiko Aiga has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Hiroki Iwanaga
Corporate Research & Development Center, Toshiba Corporation, 1 Komukai-Toshiba-cho, Saiwai-ku, Kawasaki 212-8582, Japan
2 shared publications - Yasutaka Nishida
Corporate Research & Development Center, Toshiba Corporation, 1 Komukai-Toshiba-cho, Saiwai-ku, Kawasaki 212-8582, Japan
1 shared publication
Latest Publications
- Open Access
- 21 September 2026
- Published by Elsevier in SSRN Electronic Journal
Distinctive Photoluminescence Properties of Eu(III) β-Diketonate Complexes Containing an Asymmetric Diphosphine Dioxide Ligand in a Fluorinated Solvent
Eu(III) complexes containing β-diketonate ligands are promising red-emitting materials; however, their photophysical properties in fluorinated solvents have rarely been investigated because of their generally low solubility in such media. In this study, we examined the photoluminescence properties of a series of Eu(III)-β-diketonates containing asymmetric diphosphine dioxide ligands in ethyl acetate and a fluorinated solvent (2,3-dihydrodecafluoropentane).The Eu(III) complexes exhibited higher emission intensities in the fluorinated solvent than those observed in ethyl acetate, accompanied by increased asymmetry ratios, energy-transfer efficiencies (ΦET), and total photoluminescence quantum yields (ΦTOT).Among the investigated complexes, complex 2, containing an asymmetric diphosphine dioxide ligand with four methylene units between the phosphine oxide groups, showed the most distinctive behavior. This complex exhibited a lower non-radiative decay rate and enhanced 5D0→ 7F3 emission relative to structurally related complexes, indicating a more asymmetric local coordination environment around the Eu(III) ion in the fluorinated solvent.These results suggest that the molecular structure of the diphosphine dioxide ligand strongly influences the photophysical properties of Eu(III) complexes in fluorinated media and that the ligand containing four methylene units provides a favorable coordination environment for achieving high photoluminescence efficiency among the investigated complexes.
- 21 September 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDistinctive Photoluminescence Properties of Eu(III) β-Diketonate Complexes Containing an Asymmetric Diphosphine Dioxide Ligand in a Fluorinated Solvent
Eu(III) complexes containing β-diketonate ligands are promising red-emitting materials; however, their photophysical properties in fluorinated solvents have rarely been investigated because of their generally low solubility in such media. In this study, we examined the photoluminescence properties of a series of Eu(III)-β-diketonates containing asymmetric diphosphine dioxide ligands in ethyl acetate and a fluorinated solvent (2,3-dihydrodecafluoropentane).The Eu(III) complexes exhibited higher emission intensities in the fluorinated solvent than those observed in ethyl acetate, accompanied by increased asymmetry ratios, energy-transfer efficiencies (ΦET), and total photoluminescence quantum yields (ΦTOT).Among the investigated complexes, complex 2, containing an asymmetric diphosphine dioxide ligand with four methylene units between the phosphine oxide groups, showed the most distinctive behavior. This complex exhibited a lower non-radiative decay rate and enhanced 5D0→ 7F3 emission relative to structurally related complexes, indicating a more asymmetric local coordination environment around the Eu(III) ion in the fluorinated solvent.These results suggest that the molecular structure of the diphosphine dioxide ligand strongly influences the photophysical properties of Eu(III) complexes in fluorinated media and that the ligand containing four methylene units provides a favorable coordination environment for achieving high photoluminescence efficiency among the investigated complexes.
- Open Access
- 10 April 2024
- Published by AIP Publishing in APL Quantum
- Vol. 1 (2)
Applications of quantum circuit learning model using particle-number-conserving state on quantum chemical calculations
Although the variational quantum eigensolver is a typical quantum algorithm utilized in near-term quantum devices, many measurements are required in an iterative closed feedback loop between the classical and quantum computers to obtain sufficient accuracy. In this study, we attempt to construct a quantum circuit learning model to infer potential energy surfaces and atomic forces without using the iterative loop to optimize parameters for every bond length. To realize a high, accurate inference performance, measurement is introduced in the middle of the circuit. When the proposed quantum circuit learning model is applied to the H2 molecule, the energies and atomic forces can be estimated with high accuracy in a single feed-forward calculation with varying bond lengths. A nonlinear relation between outcomes from data-encoding layer and inputs can also be used to eliminate the data-encoding layer, allowing for our quantum circuit model with lower learning costs by reducing the number of parameters to be optimized. Our model can be also extended to six-qubit systems, such as the H3 molecule, and to the water molecule with two internal degrees of freedom. Finally, we use the IBM Quantum backend to perform inference with a real quantum computer and show the effect of noise on the actual quantum device.
- 10 April 2024
- Published by AIP Publishing in APL Quantum
- Vol. 1 (2)
Open AccessApplications of quantum circuit learning model using particle-number-conserving state on quantum chemical calculations
Although the variational quantum eigensolver is a typical quantum algorithm utilized in near-term quantum devices, many measurements are required in an iterative closed feedback loop between the classical and quantum computers to obtain sufficient accuracy. In this study, we attempt to construct a quantum circuit learning model to infer potential energy surfaces and atomic forces without using the iterative loop to optimize parameters for every bond length. To realize a high, accurate inference performance, measurement is introduced in the middle of the circuit. When the proposed quantum circuit learning model is applied to the H2 molecule, the energies and atomic forces can be estimated with high accuracy in a single feed-forward calculation with varying bond lengths. A nonlinear relation between outcomes from data-encoding layer and inputs can also be used to eliminate the data-encoding layer, allowing for our quantum circuit model with lower learning costs by reducing the number of parameters to be optimized. Our model can be also extended to six-qubit systems, such as the H3 molecule, and to the water molecule with two internal degrees of freedom. Finally, we use the IBM Quantum backend to perform inference with a real quantum computer and show the effect of noise on the actual quantum device.
- 20 December 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 59 (SD) , SDDF05
A simple and sensitive detection method for the pesticide dichlorvos in solution using Eu(III)- β -diketonate as a luminescent probe
We developed a novel detection method for the pesticide dichlorvos (2,2-dichlorovinyl dimethyl phosphate) in which tris[4,4,5,5,6,6,6-heptafluoro-1-(2-naphthyl)-1,3-hexanedionato]europium(III) [Eu(III)(hfnh) 3 ] served as a highly sensitive luminescent probe. The photoluminescence intensity of Eu(III)(hfnh) 3 was drastically and rapidly decreased by the action of dichlorvos in ethyl acetate. The quantum yield of Eu(III)(hfnh) 3 decreased monotonically with increasing dichlorvos concentration, explaining the decrease in photoluminescence intensity. Dynamic and static quenching mechanisms possibly co-existed in ethyl acetate because the Stern–Volmer plot of Eu(III)(hfnh) 3 and dichlorvos could be approximated by a quadratic function. 31 P-NMR revealed that dichlorvos molecules coordinated to Eu(III) and exhibited dynamic behavior supporting a dynamic quenching mechanism. When dichlorvos was mixed with Eu(III)(hfnh) 3 1 , Φ ET drastically decreased from 0.64 to 0.15. A plausible mechanism is that quenching of Eu(III)(hfnh) 3 1 occurred between the dichlorvos molecules and the β -diketonates before energy transfer from the β -diketonates to Eu(III). Density functional theory calculations support this mechanism.
- 20 December 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 59 (SD) , SDDF05
A simple and sensitive detection method for the pesticide dichlorvos in solution using Eu(III)- β -diketonate as a luminescent probe
We developed a novel detection method for the pesticide dichlorvos (2,2-dichlorovinyl dimethyl phosphate) in which tris[4,4,5,5,6,6,6-heptafluoro-1-(2-naphthyl)-1,3-hexanedionato]europium(III) [Eu(III)(hfnh) 3 ] served as a highly sensitive luminescent probe. The photoluminescence intensity of Eu(III)(hfnh) 3 was drastically and rapidly decreased by the action of dichlorvos in ethyl acetate. The quantum yield of Eu(III)(hfnh) 3 decreased monotonically with increasing dichlorvos concentration, explaining the decrease in photoluminescence intensity. Dynamic and static quenching mechanisms possibly co-existed in ethyl acetate because the Stern–Volmer plot of Eu(III)(hfnh) 3 and dichlorvos could be approximated by a quadratic function. 31 P-NMR revealed that dichlorvos molecules coordinated to Eu(III) and exhibited dynamic behavior supporting a dynamic quenching mechanism. When dichlorvos was mixed with Eu(III)(hfnh) 3 1 , Φ ET drastically decreased from 0.64 to 0.15. A plausible mechanism is that quenching of Eu(III)(hfnh) 3 1 occurred between the dichlorvos molecules and the β -diketonates before energy transfer from the β -diketonates to Eu(III). Density functional theory calculations support this mechanism.