KKKonstantin Köster

Konstantin Köster

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Konstantin Köster has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Zr Incorporation Into Lithium Nickel Oxides: Bulk or Surface Substitution?

    by Lars Winkler, Geon‐Tae Park, Liang‐Yin Kuo, Martin Ihrig, Konstantin Köster, Johan E. Ten Elshof, Mark Huijben, Myoung‐Chan Kim, Min‐Gyu Seo, Yang‐Kook Sun, et al.

    High‐capacity lithium nickel oxides (LNO) are promising cathode active materials for next‐generation batteries. However, their practical application is limited by poor cycling stability. Doping the LNO cathode with high‐valence elements is an effective strategy to enhance structural stability. In this study, we investigate the mechanism of Zr 4+ incorporation into LNO using experimental and theoretical techniques. Our findings reveal that under oxygen‐rich conditions, Zr‐doped LNO can be realized as a single phase, but most Zr cations localize at the surface of primary particles. In contrast, under oxygen‐deficient or non‐equilibrium conditions a secondary layered Li 1‐x Ni 1+x O 2 phase, characterized by Ni migration into the Li layers (cation ordering), is stabilized coexisting with Zr‐doped LNO. This promotes elongation of primary particles at the aggregation surface. The Zr enrichment at the microparticle surface, Zr‐induced cation‐ordered superstructure, and the formation of elongated grains enhance the chemical stability as well as the structural integrity at atomistic‐ and micro‐scale of the LNO cathode, improving its cycling performance. However, only 1–3% Zr is necessary to maintain the initial capacity and enhance cyclability through surface coating and low bulk doping with Zr. With increasing Zr concentration, an electronically insulating impurity (Li 2 ZrO 3 ) forms, leading to a decrease in the initial capacity.

  • Open Access

    Computational studies on O2-P2 phase-transition dynamics in layered-oxide sodium-ion cathode materials

    by Konstantin Köster, Payam Kaghazchi

    Sodium-ion batteries have gained much interest over the past years and especially layered oxides are highly considered as cathodes for the next generation of batteries. However, there are still significant challenges to overcome in these materials for practical applications mainly related to capacity degradation and voltage fading. A key influence factor for these challenges are phase transitions that occur by gliding of layers during operation of these materials. Until now there is limited atomistic-level understanding on such transitions as simulations of these processes are computationally demanding. In this work, we trained a classical pairwise Coulomb-Buckingham potential versus extensive data using a genetic algorithm to study O2-P2 phase transitions in Na x CoO 2 . Our density functional theory (DFT) and classical potential calculations show that phase-transition barriers decrease upon desodiation and are further lowered if dynamic conditions are considered through molecular dynamics simulations. Our developed classical potential is able to capture phase transitions and its related increase in the Na-ion diffusivity under standard laboratory conditions at the µ s timescale of molecular dynamics simulation. Furthermore, it is found that the phase transition occurs gradually via various OP n phases.

  • Open Access

    Inductive-effect engineering of transition-metal–oxygen covalency and structural ordering in P2-type high-voltage sodium-ion cathodes

    by Natalia Voronina, Konstantin Köster, Jun Ho Yu, A-Yeon Kim, Hun-Gi Jung, Koji Yazawa, Payam Kaghazchi, Seung-Taek Myung


  • Open Access

    Simulating charging characteristics of lithium iron phosphate by electro-ionic optimization on a quantum annealer

    by Tobias Binninger, Yin-Ying Ting, Konstantin Köster, Nils Bruch, Payam Kaghazchi, Piotr M. Kowalski, Michael H. Eikerling

    The rapid evolution of quantum computing hardware opens up new avenues in the simulation of energy materials. Today's quantum annealers are able to tackle complex combinatorial optimization problems. A formidable challenge of this type is posed by materials with site-occupational disorder for which atomic arrangements with a low, or lowest, energy must be found. In this article, a method is presented for the identification of the correlated ground-state distribution of both lithium ions and redox electrons in lithium iron phosphate (LFP), a widely employed cathode material in lithium-ion batteries. The point-charge Coulomb energy model employed correctly reproduces the LFP charging characteristics. As is shown, grand-canonical transformation of the energy cost function makes the combinatorial distribution problem solvable on quantum annealing (QA) hardware. The QA output statistics follow a pseudothermal behavior characterized by a problem-dependent effective sampling temperature, which has bearings on the estimated scaling of the QA performance with system size. This work demonstrates the potential of quantum computation for the joint simulation of the electronic and ionic structure in energy materials.


  • Open Access

    ‘Oxygen bound to magnesium’ as high voltage redox center causes sloping of the potential profile in Mg-doped layered oxides for Na-ion batteries

    by Yongchun Li, Konstantin Köster, Katherine Mazzio, Yanan Sun, Annica Freytag, Deniz Wong, Christian Schulz, Götz Schuck, Volodymyr Baran, Alba Mendez, et al.

    The potential profile of layered oxides as cathodes for Na-ion batteries can be well tuned by cation doping. Doping typically leads to changes in the phase behavior and the redox chemistry, but the processes and design rules are often unclear, especially at potentials above approximately 4 V vs. Na+/Na. Here, we study by means of synchrotron methods and DFT calculations how Mg- and Sc-doping influences the properties of layered O3-NaNi0.5Mn0.5O2. A strong oxygen redox activity is observed at high voltages and both dopants are found to be effective for decreasing the number of phase transitions and for improving cycle life. When comparing the effect of the dopants, notable differences in the first cycle are observed. While the Sc doping maintains the high voltage plateau, Mg doping causes a more sloping behavior. This difference can be understood from the appearance of a new redox center (arising from the ‘O bound to Mg') having a higher redox potential but being more irreversible compared to the redox activity of ‘O bound to Ni'. The appearance of an additional redox center explains findings obtained for other doped Ni- and Mn-based layered oxides, which also show a sloping potential in the high voltage region.

  • Hybrid functionals with nonempirical Hartree-Fock parameters for electronic structure calculation of layered oxides

    by Konstantin Köster, Payam Kaghazchi

    Accurate electronic structure descriptions of layered oxides are highly relevant yet complex to obtain by ab initio methods. The functionalities of layered transition metal oxides are usually heavily influenced by their electronic structure and the hybridization/delocalization of d electrons of the transition metals. Therefore understanding the electronic structure can enable a more rational design of this highly important material class, which is widely utilized in practical applications such as cathodes in secondary batteries of portable electronic devices and electric vehicles. However, it is well known that standard quantum-mechanic approximations to the many-body problem overlocalize (Hartree-Fock) or overdelocalize (density functional theory) electrons in these systems. A mixture of different methods (hybrid functionals) can partially resolve the problem but introduces at least one additional parameter (the mixing parameter) that has to be determined by e.g., higher levels of theory (GW). In this study, we focus on the electronic structure of lithiated layered transition-metal oxides based on Co, Ni, Mn, and their binary systems that form the foundation of state-of-the-art lithium-ion batteries. The influence of Hartree-Fock mixing in the PBE0 hybrid functional on the electronic structure is compared as well as using different Hartree-Fock mixings as starting points for GW calculations. Two nonempirical GW-based fitting approaches to determine the optimal Hartree-Fock mixing are considered. We show that one of the fitting approaches suggests small mixing parameters and is in satisfactory agreement with experimental results, while the other approach has a stronger theoretical foundation and indicates higher mixing parameters, which are close to the value obtained by perturbation theory by Perdew, Ernzerhof, and Burke. Finally, it is shown that larger mixing parameters are required when screening is introduced to the Hartree-Fock term.