MMM. A. Markova

M. A. Markova

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


M. A. Markova has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Low-temperature tribological testing of PTFE composites modified with carbon fillers

    by T. A. Isakova, P. N. Petrova, M. A. Markova, A. L. Fedorov

    Wear processes in polymer composite materials (PCMs) at subzero temperatures remain insufficiently studied. Therefore, tribological investigations of polymer composites under low-temperature conditions are essential for evaluating their performance in cold climates. The findings from such studies will support the development of new frost-resistant composite materials and contribute to safer, more reliable equipment operation in cold environments.    This study aims to investigate the tribological properties of PCMs at room and subzero temperatures. The materials examined were polytetrafluoroethylene (PTFE)-based composites containing 5 wt.% nanofibers (UNV-02) and microfibers (UVISAK-P). These were prepared using two methods: simple mixing in a paddle mixer and combined mechanical activation of half the polymer with filler in a planetary mill. Tribological tests were conducted in a KTX-150 thermal chamber (Technology LLC, Russia) and outdoors using a Tribometer-1 experimental setup (pinon-disk configuration) developed at the Institute of Oil and Gas Problems SB RAS. At –30 °C, the mass wear rate decreased by a factor of 4.5 for PTFE, by 1.4–1.7 times for UNV-02 composites, and by 1.5 times for the UVIS-AK-P composite. The coefficient of friction increased slightly for all PCMs except the original polymer. The enhanced wear resistance is attributed to the “freezing”of the composite structure during friction at low temperatures, which leads to increased hardness. Steadystate friction of the composites at subzero temperatures was achieved more rapidly in the chamber than at room temperature or in open air. The results obtained will contribute to the advancement of Arctic materials science, particularly in understanding the behavior of polymeric materials in cold climates.

  • Open Access

    Effect of production technologies on the properties and structure of PTFE-based composites

    by P. N. Petrova, M. A. Markova, A. L. Fedorov

    In the development of polymer composite materials, it is crucial to use various technological methods for introducing fillers into the structure of the base polymer, by different activation technologies of energy exposure. In this study, the processes of structure formation of polymer composite materials based on polytetrafluoroethylene and discrete hydrate cellulose carbon fibers, depending on the production technology, were investigated by scanning electron microscopy. We considered joint mechanical activation of components and passing the powder mixture through laboratory rollers. To understand the processes occurring in the friction process of the developed PCM, surface studies before and after friction by infrared spectroscopy were carried out. We found that during the friction process, depending on the friction mode, the spiral conformation of the PTFE macromolecules changes. An increase in the sliding velocity and the load during PCM friction leads to a change in the spiral conformation of macromolecules with a transition from 136 to a more stable conformation 157. We also found that the combination of technologies for joint mechanical activation of components and rolling of a powder mixture are technological techniques that can increase the structural activity of discrete hydrocarbons and intensify the adhesive interaction at the polymer-filler phase interface, which leads to an increase in the resistance of composites to creep and wear. The developed technological approaches can be used in the production of fluorocomposites containing not only carbon but also other types of fibers.