Qizhen Chen

The advancement of portable high-definition organic light-emitting diode (OLED) displays necessitates thin film transistors (TFTs) with low power consumption and high pixel density. Amorphous indium gallium zinc oxide (a-IGZO) TFTs are promising candidates to meet these requirements. However, conventional silicon dioxide gate insulators provide limited channel modulation due to their low dielectric constant, while alternative high-k dielectrics often suffer from high leakage currents and poor surface quality. Plasma-enhanced atomic layer deposition (PEALD) enables the atomic-level control of film thickness, resulting in high-quality films with superior conformality and uniformity. In this work, a systematic investigation was conducted on the properties of HfO₂ films and the electrical characteristics of a-IGZO TFTs with different HfO₂ thicknesses. A Vth of −0.9 V, μ_sat of 6.76 cm²/Vs, SS of 0.084 V/decade, and I_on/I_off of 1.35 × 10⁹ are obtained for IGZO TFTs with 40 nm HfO₂. It is believed that the IGZO TFTs based on a HfO₂ gate insulating layer and prepared by PEALD can improve electrical performance.

The surface morphology of porous source electrodes plays a significant role in the performance of vertical channel indium–gallium–zinc oxide thin-film transistors (VC-IGZO-TFTs). This study systematically investigates the properties of porous MXene-based source electrodes and their impact on VC-IGZO-TFTs fabricated with varying MXene concentrations. As the MXene concentration increases, both the sheet resistance and porosity of the electrodes decrease. VC-IGZO-TFTs based on a 3.0 mg/mL MXene concentration exhibit optimal electrical performance, with a threshold voltage (V_th) of 0.16 V, a subthreshold swing (SS) of 0.20 V/decade, and an on/off current ratio (I_on/I_off) of 4.90 × 10⁵. Meanwhile, the VC-IGZO-TFTs exhibit excellent electrical reliability and mechanical stability. This work provides a way to analyze the influence of sheet resistance and porosity on the performance of VC-IGZO-TFTs, offering a viable approach for enhancing device efficiency through porous MXene electrode engineering.

It is usually difficult to realize high mobility together with a low threshold voltage and good stability for amorphous oxide thin-film transistors (TFTs). In addition, a low fabrication temperature is preferred in terms of enhancing compatibility with the back end of line of the device. In this study, α-IGZO TFTs were prepared by high-power impulse magnetron sputtering (HiPIMS) at room temperature. The channel was prepared under a two-step deposition pressure process to modulate its electrical properties. X-ray photoelectron spectra revealed that the front-channel has a lower Ga content and a higher oxygen vacancy concentration than the back-channel. This process has the advantage of balancing high mobility and a low threshold voltage of the TFT when compared with a conventional homogeneous channel. It also has a simpler fabrication process than that of a dual active layer comprising heterogeneous materials. The HiPIMS process has the advantage of being a low temperature process for oxide TFTs.