Abed Abdel Qader
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abed Abdel Qader has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Ali Issa Ismail
Department of Chemistry, Faculty of Science, The Hashemite University, Zarqa, Jordan
1 shared publication - Börje Sellergren
Department of Biomedical Sciences, Faculty of Health and Society, Malmö University, 20506 Malmö, Sweden
1 shared publication - Eman Zmaily Dahmash
Department of Applied Pharmaceutical Sciences and Clinical Pharmacy, Faculty of Pharmacy, Isra University, Amman, Jordan
1 shared publication Lina Mohammad Saleh Al-Sarayra
Isra University, Faculty of Pharmacy, Jordan
1 shared publication- Lubna Alrawashdeh
Department of Chemistry, Faculty of Science, The Hashemite University, P.O. Box 330127, Zarqa 13133, Jordan
1 shared publication - Mike Kh. Haddad
Faculty of Engineering Isra University Amman Jordan
1 shared publication
Latest Publications
- Open Access
Dummy Templated Receptors Showing Enhanced Affinity for Vitamin D3
Vitamin D3 (VD3) is an essential micronutrient, but its analytical determination in biological matrices is often hindered by structurally related metabolites and the limited selectivity of conventional analytical sorbents. The preparation of a molecularly imprinted polymer (MIP) using VD3 as a template is challenging due to its hydrophobic structure and lack of polar groups. Therefore, in this work, MIPs were prepared using the closely related structure hyodeoxycholic acid methyl ester as a template and tested for their adsorption capacity toward VD3. Several MIPs were first prepared using different functional monomers, and the results showed that 4-vinylpyridine (4VP) monomer in combination with divinylbenzene (DVB) as a crosslinker exhibited a relatively high binding capacity and imprinting factor. UV spectroscopy indicated an optimal VD3–monomer ratio of 1:4, while computational modeling further confirmed favorable interactions between VD3 and 4VP. The effect of incorporating styrene as a co-monomer with 4VP was also investigated, showing an enhancement in adsorption capacity with a slight increase in the imprinting factor. However, TGA analysis revealed that the thermal stability of the MIPs decreased with higher styrene content. Overall, the prepared MIPs demonstrated improved selectivity and recognition of VD3 compared to the non-imprinted polymers, offering a promising approach for its selective extraction and quantification.
Open AccessDummy Templated Receptors Showing Enhanced Affinity for Vitamin D3
Vitamin D3 (VD3) is an essential micronutrient, but its analytical determination in biological matrices is often hindered by structurally related metabolites and the limited selectivity of conventional analytical sorbents. The preparation of a molecularly imprinted polymer (MIP) using VD3 as a template is challenging due to its hydrophobic structure and lack of polar groups. Therefore, in this work, MIPs were prepared using the closely related structure hyodeoxycholic acid methyl ester as a template and tested for their adsorption capacity toward VD3. Several MIPs were first prepared using different functional monomers, and the results showed that 4-vinylpyridine (4VP) monomer in combination with divinylbenzene (DVB) as a crosslinker exhibited a relatively high binding capacity and imprinting factor. UV spectroscopy indicated an optimal VD3–monomer ratio of 1:4, while computational modeling further confirmed favorable interactions between VD3 and 4VP. The effect of incorporating styrene as a co-monomer with 4VP was also investigated, showing an enhancement in adsorption capacity with a slight increase in the imprinting factor. However, TGA analysis revealed that the thermal stability of the MIPs decreased with higher styrene content. Overall, the prepared MIPs demonstrated improved selectivity and recognition of VD3 compared to the non-imprinted polymers, offering a promising approach for its selective extraction and quantification.
- Open Access
- 1 January 2024
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 27, e20230365
Gold Nanoparticles Loaded with Chitosan Encapsulate Donepezil as a Novel Nanocomposite for Alzheimer's Disease Therapy
Alzheimer's disease (AD) is the most common cause of dementia worldwide. Fifty million people today are affected by this disease globally. AD has had a tremendous impact on the affected individual, caregiver, and society, in both developed and developing nations. Donepezil—chitosan-gold nanocomposite (Donz-CS-AuNPs) was prepared by co-precipitation technique. Placket-Burman experimental design was used in this work to estimate the effect of the three independent variables (concentration of chitosan, gold, and donepezil) on the dependent variables (loading efficiency, and particle size) by using Minitab 18.1 software. The quantities for the independent variables used were: 10 and 40 mg of donepezil, 24.6 and 73.8 mg of gold, and 500 and 1500 mg of chitosan. The Donz-CS-AuNPs were characterized using energy dispersive X-ray (EDX) analysis, X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), UV-Vis spectroscopy and release study. The results of EDX showed strong signals of Au (1.5–2, 2–2.5 and 9.5–10 keV), which confirmed the specific gold peaks from the Donz-CS-AuNPs. The XRD pattern of Donz-CS-AuNPs nanocomposites showed the existence of AuNPs peak at 2θ= 38.2°, 43.8° and 64.5°. The SEM images demonstrated spherical shapes of the AuNPs. In the in vitro release study, the release increased steeply and reached 75% after 1440 min.
- 1 January 2024
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 27, e20230365
Open AccessGold Nanoparticles Loaded with Chitosan Encapsulate Donepezil as a Novel Nanocomposite for Alzheimer's Disease Therapy
Alzheimer's disease (AD) is the most common cause of dementia worldwide. Fifty million people today are affected by this disease globally. AD has had a tremendous impact on the affected individual, caregiver, and society, in both developed and developing nations. Donepezil—chitosan-gold nanocomposite (Donz-CS-AuNPs) was prepared by co-precipitation technique. Placket-Burman experimental design was used in this work to estimate the effect of the three independent variables (concentration of chitosan, gold, and donepezil) on the dependent variables (loading efficiency, and particle size) by using Minitab 18.1 software. The quantities for the independent variables used were: 10 and 40 mg of donepezil, 24.6 and 73.8 mg of gold, and 500 and 1500 mg of chitosan. The Donz-CS-AuNPs were characterized using energy dispersive X-ray (EDX) analysis, X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), UV-Vis spectroscopy and release study. The results of EDX showed strong signals of Au (1.5–2, 2–2.5 and 9.5–10 keV), which confirmed the specific gold peaks from the Donz-CS-AuNPs. The XRD pattern of Donz-CS-AuNPs nanocomposites showed the existence of AuNPs peak at 2θ= 38.2°, 43.8° and 64.5°. The SEM images demonstrated spherical shapes of the AuNPs. In the in vitro release study, the release increased steeply and reached 75% after 1440 min.