Abdul Rahman El Falou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abdul Rahman El Falou has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Abdullah S. Karar
College of Engineering and Technology, American University of the Middle East, Egaila 54200, Kuwait
1 shared publication - Julien Moussa H. Barakat
College of Engineering and Technology, American University of the Middle East, Egaila 54200, Kuwait
1 shared publication - Mariam M. Moussilli
Department and Electrical and Computer Enginerring, Beirut Arab University (BAU), Lebanon
1 shared publication - Raed M. Shubair
Engineering Division, New York University (NYU), Abu Dhabi, UAE
1 shared publication - Shadi A. Alboon
Department of Electronics Engineering, Hijjawi Faculty for Engineering Technology, Yarmouk University, Irbid, Jordan
1 shared publication - Zeynep Nilhan Gürkan
College of Engineering and Technology, American University of the Middle East, Egaila 54200, Kuwait
1 shared publication
Latest Publications
- Open Access
- 9 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 16 (3) , 1-8
Enhanced Performance of Intensity Modulation With Direct Detection Using Golay Encoded Nyquist Pulses and Electronic Dispersion Compensation
The performance of intensity modulation (IM) with direct detection (DD) transmission systems is enhanced through a novel combination of multidimensional coding, Nyquist pulse shaping, and electronic dispersion compensation (EDC) at the transmitter using a finite impulse response (FIR) filter. A 24-dimensional (24D) extended Golay binary code effectively transforms each incoming 12-bit message into a 24-bit codeword, achieving a coding efficiency of 0.5 bits per symbol for a 56 Gb/s on-off keying (OOK) transmission over 80 km of single mode fiber. While this encoding process introduces a 50% overhead, the required bandwidth is maintained at 56 GHz through doubling the symbol rate and the application of Nyquist pulse shaping with a raised cosine (RC) profile and a roll-off factor of zero, resulting in a flat power spectral density. This flat distribution contrasts with standard OOK transmission at 56 Gb/s with a roll-off factor of 1.0, where signal power is predominantly concentrated in the lower frequency range. One of the key advantages of the 24D Golay code is its substantial error correction capability. However, the benefits of this multidimensional coding and Nyquist pulse shaping extend beyond error correction. It is shown that, while both the proposed and standard OOK methods exhibit comparable performance in a white Gaussian noise channel at back-to-back, they differ significantly under frequency selective power fading conditions caused by the interplay of chromatic dispersion (CD) and direct detection. The misalignment between the frequency notches introduced by the FIR pre-EDC and those inherent in the channel response, especially severe at lower frequencies, favors transmission schemes with a flat power spectral density, like the 24D Golay-coded Nyquist pulses.
- 9 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 16 (3) , 1-8
Open AccessEnhanced Performance of Intensity Modulation With Direct Detection Using Golay Encoded Nyquist Pulses and Electronic Dispersion Compensation
The performance of intensity modulation (IM) with direct detection (DD) transmission systems is enhanced through a novel combination of multidimensional coding, Nyquist pulse shaping, and electronic dispersion compensation (EDC) at the transmitter using a finite impulse response (FIR) filter. A 24-dimensional (24D) extended Golay binary code effectively transforms each incoming 12-bit message into a 24-bit codeword, achieving a coding efficiency of 0.5 bits per symbol for a 56 Gb/s on-off keying (OOK) transmission over 80 km of single mode fiber. While this encoding process introduces a 50% overhead, the required bandwidth is maintained at 56 GHz through doubling the symbol rate and the application of Nyquist pulse shaping with a raised cosine (RC) profile and a roll-off factor of zero, resulting in a flat power spectral density. This flat distribution contrasts with standard OOK transmission at 56 Gb/s with a roll-off factor of 1.0, where signal power is predominantly concentrated in the lower frequency range. One of the key advantages of the 24D Golay code is its substantial error correction capability. However, the benefits of this multidimensional coding and Nyquist pulse shaping extend beyond error correction. It is shown that, while both the proposed and standard OOK methods exhibit comparable performance in a white Gaussian noise channel at back-to-back, they differ significantly under frequency selective power fading conditions caused by the interplay of chromatic dispersion (CD) and direct detection. The misalignment between the frequency notches introduced by the FIR pre-EDC and those inherent in the channel response, especially severe at lower frequencies, favors transmission schemes with a flat power spectral density, like the 24D Golay-coded Nyquist pulses.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1311-1312
Performance Parameter Optimization of Graphene Enhanced Surface Plasmon Resonance Biosensors
In this paper, we perform a theoretical study in order to optimize the sensitivity S n and detection accuracy DA performance parameters of a proposed Silver-based and Graphene enhanced Fiber Optic Surface Plasmon Resonance (FO-SPR) biosensor. Upon simulation utilizing the 4-layer model, it was found that the physical and geometrical parameters of this biosensor such as the metal layer type, addition of a Graphene coating, sensing region length L, core diameter D and thickness of the metal layer d 2 have an effect on the sensor performance parameters and thus need to be optimized. The optimal design was found to be a Silver-based and Graphene enhanced FO-SPR biosensor with L = 10 mm, D = 100 mm and d 2 = 40 nm.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1311-1312
Performance Parameter Optimization of Graphene Enhanced Surface Plasmon Resonance Biosensors
In this paper, we perform a theoretical study in order to optimize the sensitivity S n and detection accuracy DA performance parameters of a proposed Silver-based and Graphene enhanced Fiber Optic Surface Plasmon Resonance (FO-SPR) biosensor. Upon simulation utilizing the 4-layer model, it was found that the physical and geometrical parameters of this biosensor such as the metal layer type, addition of a Graphene coating, sensing region length L, core diameter D and thickness of the metal layer d 2 have an effect on the sensor performance parameters and thus need to be optimized. The optimal design was found to be a Silver-based and Graphene enhanced FO-SPR biosensor with L = 10 mm, D = 100 mm and d 2 = 40 nm.