JNJohn Niroula

John Niroula

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


John Niroula has a total of 67 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Low-temperature plasma-enhanced ALD of c-axis textured GaN on sapphire

    by Loïs Talli, Dadam Kang, John Niroula, Elham Rafie Borujeny, Aubrey Penn, Tomás Palacios, Joseph Casamento

    This paper demonstrates the deposition of GaN on c-plane sapphire by plasma-enhanced atomic layer deposition (PE-ALD) at 250 °C using triethylgallium and forming gas (95% N2, 5% H2) plasma. The films exhibit a wurtzite crystal structure with a full-width at half maximum of 0.31° for the (0002) peak via x-ray diffraction and an abrupt GaN–sapphire interface confirmed by scanning transmission electron microscopy. X-ray photoelectron spectroscopy and secondary-ion mass spectrometry reveal carbon and oxygen concentrations of 1 at. % and less than 3 at. %, respectively. Transfer length method analysis demonstrates a sheet resistance of 1.37 × 108Ω/□. These results provide an understanding for the low-temperature PE-ALD growth of GaN with high crystalline fidelity and minimized impurity incorporation.


  • Experimental and computational study of the high-temperature 2DEG mobility in AlGaN/GaN heterostructures

    by Matinehsadat Hosseinigheidari, Animesh Datta, John Niroula, Shisong Luo, Yuji Zhao, Tomás Palacios, Uttam Singisetti

    AlGaN/GaN heterostructures are widely used in high power RF applications due to the high two-dimensional electron gas (2DEG) mobility. The wide bandgap of GaN makes it attractive for high-temperature electronics applications. In this work, we report both experimental and computational studies of the AlGaN/GaN 2DEG mobilities at elevated temperatures. AlGaN/GaN heterostructures were grown by MOCVD. After forming Ohmic contacts, the 2DEG mobility and density were measured using van der Pauw structures up to 500 °C. The 2DEG mobility drops to <20% of the room temperature values. To understand the mobility limiting mechanisms, a comprehensive ab initio-based electron–phonon interactions calculations were carried out to accurately quantify the electron–phonon scattering rates. Contributions from polar optical phonons, piezoelectric scattering by acoustic phonons including the quadrupole corrections, and non-polar deformation potential scattering were included. In addition, interface roughness and remote alloy disorder scattering were also included. First, the Poisson's and Schrödinger's equations are solved self-consistently to get the 2DEG wavefunctions. Then, using ab initio methods, the electronic band structure, phonon modes, and the electron–phonon interaction matrix elements were calculated. For all the scattering mechanisms, a temperature-dependent static screening has been used. Finally, the Boltzmann Transport Equation is solved using Rode's iterative method to get the low-field mobility. The calculated results show a good fit with experiments over the whole temperature range. Even though all the phonon scatterings increase with temperature, the polar optical phonon scattering dominates at higher temperatures due to increased Bose–Einstein occupancy and reduced screening ultimately limiting the mobility.

  • High Responsivity Optically-Triggered Vertical GaN Heterojunction Power Switches With kHz Operation

    by Jung-Han Hsia, Zhongyunshen Zhu, Yizheng Liu, John Niroula, Minsik Oh, Joshua Andrew Perozek, Joseph Park, Sriram Krishnamoorthy, Tomás Palacios

    Optically controlled power switches could reduce circuit complexity and electromagnetic interference (EMI) susceptibility for high-voltage power systems. This work demonstrates a novel LED-triggered vertical GaN junction switch (Op-VJS) with sub-millisecond turn-off. The devices show a large optical response (R > 103 A/W) and high on-off current ratio exceeding 105 when illuminated by a 365 nm LED, translating to optical Ron,sp of 20 mΩcm². The Op-VJS uses p-NiOx/n-GaN heterojunction fins to eliminate minority carrier screening, as a result, τoff of 90 μs was successfully achieved. This performance underscores the great potential of the proposed device for low-cost, optically controlled high-voltage power applications.


  • Degradation Analysis of InAlN/GaN Transistors Under Simulated Venus Surface Conditions

    by Savannah R. Eisner, Zahra N. Heussen, Sergio Cordero, John Niroula, Jared Naphy, Mohamed Fadil Isamotu, Harshad Surdi, Mengyang Yuan, Qingyun Xie, Robert J. Nemanich, et al.

    The Venusian surface presents extreme thermal, chemical, and pressure challenges for long-term lander electronics. Gallium nitride (GaN) heterostructure devices exhibit chemical robustness and thermal stability, enabling harsh environment operation. This study examines the degradation mechanisms of depletion-mode InAlN/GaN-on-Si high-electron-mobility transistors (HEMTs) featuring a refractory iridium oxide (IrOx) gate in Venus surface conditions. Over an 11-day operational period at 460 °C and 93 bar, device characteristics were monitored in situ, revealing a 94% decreased drain current from 62.46 to 3.71 mA/mm, an increased on-resistance from 137.87 to 1266.50 $\Omega {\cdot }$ mm, decreased on/off current ratio from ${2}.{88} \times {10}^{{3}}$ to ${9}.{88} \times {10}^{{2}}$ and + 2.37-V threshold voltage shift. Post-exposure electric measurements showed that both unbiased and biased HEMT characteristics were not recoverable at room temperature. Materials characterization, including scanning electron microscopy (SEM), atomic force microscopy (AFM), transmission electron microscopy (TEM), and energy-dispersive X-ray spectroscopy (EDX), identified surface roughening and clustering of the IrOx gate region, attributed to dewetting and interdiffusion effects after exposure. Despite these changes, the transistors remained functional, and Hall measurements confirmed an intact 2-D electron gas (2DEG). An unbiased control device exposed to the same environment exhibited improved transconductance and a negative threshold voltage shift, but worse on/off from increased OFF-state current at room temperature. This investigation demonstrates the potential of InAlN/GaN HEMTs for signal conditioning electronics on-board future Venus missions, while highlighting the need for improved gate and passivation layers and emphasizing the need for in situ bias testing under harsh conditions.


  • Top Cited Papers
    Open Access

    High breakdown electric field (>5 MV/cm) in UWBG AlGaN transistors

    by Seungheon Shin, Hridibrata Pal, Jon Pratt, John Niroula, Yinxuan Zhu, Chandan Joishi, Brianna A. Klein, Andrew A. Allerman, Tomás Palacios, Siddharth Rajan

    We report on the design and demonstration of ultra-wide bandgap (UWBG) AlGaN-channel metal–insulator heterostructure field effect transistors (HEFTs) for high-power, high-frequency applications. We find that the integration of gate dielectrics and field plates greatly improves the breakdown field in these devices, with one of the highest average breakdown fields of 5.3 MV/cm (a breakdown voltage of >260 V) with an associated maximum current density of 342 mA/mm and a cutoff frequency of 9.1 GHz. The reported results provide the potential of UWBG AlGaN HEFTs for the next generation of high-power radio frequency applications.


  • High Temperature AlGaN/GaN MISHEMT With W/AlON Gate Stack and I max>1 A/mm at 500 ∘C

    by John Niroula, Qingyun Xie, Elham Rafie Borujeny, Shisong Luo, Minsik Oh, Matthew A. Taylor, Yuji Zhao, Tomás Palacios

    This work demonstrates a scaled (L ${}_{\text {g}}=50$ nm, L ${}_{\text {gs}}=270$ nm, L ${}_{\text {gd}}=360$ nm) RF AlGaN/GaN MISHEMT with a record current density of 1.16 A/mm at 500°C and a corresponding Ion/Ioff of 9. The device was made using a plasma enhanced atomic layer deposited (PEALD) aluminum oxynitride (AlON) gate dielectric and passivation which was found to increase the 2D electron gas density by 33%. The devices were fabricated utilizing a sputtered tungsten refractory metal T-gate process and achieved a room temperature ft/fmax of 28.5/28.8 GHz, limited by RF loss through the conductive silicon substrate. Overall, the promising results highlight the potential of RF GaN HEMTs to operate at high temperatures to enable new applications.


  • Hole transport mechanism at high temperatures in p-GaN/AlGaN/GaN heterostructure

    by Bejoy Sikder, Toiyob Hossain, Qingyun Xie, John Niroula, Nitul S. Rajput, Koon Hoo Teo, Hiroshi Amano, Tomás Palacios, Nadim Chowdhury

    This Letter reports an investigation of hole transport in p-GaN/AlGaN/GaN heterostructures through experimental and theoretical analyses under varied conditions. Highly non-linear current–voltage (I–V) characteristics, obtained via the linear transmission line method measurements, are utilized for this study. At low bias voltage, the transport can be ascribed to the Schottky nature of the contact, while at high bias, the conduction is observed to be governed by space-charge limited current (SCLC). The Schottky characteristics (Schottky barrier height and non-ideality factor) and the SCLC exponent were analyzed for devices with varying contact spacings and at different high temperatures. The SCLC exponent, m, is in the range of 2≤m≤4 depending on the applied voltage range, revealing the existence of the trap states in the channel region. The findings of this work indicate that the charge injection, field-induced ionization, and trap states in the p-GaN channel are critical factors in the current transport of p-GaN/AlGaN/GaN heterostructure.


  • Open Access

    High temperature stability of regrown and alloyed Ohmic contacts to AlGaN/GaN heterostructure up to 500 °C

    by John Niroula, Qingyun Xie, Nitul S. Rajput, Patrick K. Darmawi-Iskandar, Sheikh Ifatur Rahman, Shisong Luo, Rafid Hassan Palash, Bejoy Sikder, Mengyang Yuan, Pradyot Yadav, et al.

    This Letter reports the stability of regrown and alloyed Ohmic contacts to AlGaN/GaN-on-Si high electron mobility transistors (HEMTs) for high temperature applications up to 500 °C. Transfer length method (TLM) measurements from 25 to 500 °C in air show that the regrown contacts appear to be stable up to 500 °C during short term (approximately 1 h) testing, while alloyed contacts appear to decrease in contact resistance from 300 to 500 °C though increases in the error bounds due to increase sheet resistance make it difficult to conclude definitely. Additionally, longer term testing shows both technologies remain stable at least up to 48 h at 500 °C, after which the large increase in sheet resistance makes the measurement uncertainty too large to conclude definitively. Advanced microscopy images indicate both the regrown and alloyed contact regions remain structurally intact after prolonged high temperature exposure with no visible degradation in crystallinity or metal composition.


  • Open Access

    Device and material investigations of GaN enhancement-mode transistors for Venus and harsh environments

    by Qingyun Xie, John Niroula, Nitul S. Rajput, Mengyang Yuan, Shisong Luo, Kai Fu, Mohamed Fadil Isamotu, Rafid Hassan Palash, Bejoy Sikder, Savannah R. Eisner, et al.

    This Letter reports the device and material investigations of enhancement-mode p-GaN-gate AlGaN/GaN high electron mobility transistors (HEMTs) for Venus exploration and other harsh environment applications. The GaN transistor in this work was subjected to prolonged exposure (11 days) in a simulated Venus environment (460 °C, 94 bar, complete chemical environment including CO2/N2/SO2). The mechanisms affecting the transistor performance and structural integrity in harsh environment were analyzed using a variety of experimental, simulation, and modeling techniques, including in situ electrical measurement (e.g., burn-in) and advanced microscopy (e.g., structural deformation). Through transistor, Transmission Line Method (TLM), and Hall-effect measurements vs temperature, it is revealed that the mobility decrease is the primary cause of reduction of on-state performance of this GaN transistor at high temperature. Material analysis of the device under test (DUT) confirmed the absence of foreign elements from the Venus atmosphere. No inter-diffusion of the elements (including the gate metal) was observed. The insights of this work are broadly applicable to the future design, fabrication, and deployment of robust III-N devices for harsh environment operation.


  • Open Access

    GaN Memory Operational at 300 °C

    by Mengyang Yuan, Qingyun Xie, John Niroula, Nadim Chowdhury, Tomas Palacios

    The most commonly used memory cells, namely a 32-bit × 10-bit read-only memory, a 1-bit 4-transistor static random-access memory, D latch, and D flip-flop (DFF), were demonstrated using high temperature (HT) GaN technology on a monolithically integrated GaN-on-Si platform and n-FET-only E/D-mode logic (E: enhancement, D: depletion). The memory cells exhibit stable operation at 300 °C. A maximum clock frequency of 36 MHz at 300 °C was estimated for the DFF using the measured setup time. To the best of the authors’ knowledge, the operational temperature of the reported prototypes represents the highest value for GaN memory, paving the way for the realization of robust mixed-signal systems operating at HT.