Elyes Garoudja
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Elyes Garoudja has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Slimane Oussalah
Centre de Développement des Technologies Avancées, Algiers, Algeria
4 shared publications - Walid Filali
Plateforme Technologique de Microfabrication, Centre de Développement des Technologies Avancées, cité 20 août 1956, Baba Hassen, 16081 Algiers, Algeria
4 shared publications - Fouaz Lekoui
Centre de Développement des Technologies Avancées
2 shared publications - Rachid Amrani
Département des Sciences de La Matière, Université Alger1 Benyoucef Benkhedda, Alger, Algeria
2 shared publications Asma Hamri
Département des Sciences de La Matière, Université Alger1 Benyoucef Benkhedda, Alger, Algeria
1 shared publicationBoumediene Zatout
Division Microélectronique et Nanotechnologies, Centre de Développement des Technologies Avancées, cité 20 août 1956, Baba Hassen, 16081 Algiers, Algeria
1 shared publication
Latest Publications
- 6 June 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (7) , 076003
Efficient whale optimization algorithm to extract electrical parameters of different CMOS based diodes
In this paper, experimental elaboration and investigation of three structures of diode, such as n+/p-well, p+/n-well and n-well/p-well are proposed. The diodes are elaborated on the basis of the standard 1 μm twin-well, double poly-Si and double level metal, complementary metal-oxide-semiconductor (CMOS) process technology. The mask design, diodes elaboration and electrical characterization were established in a cleanroom environment. Characterization results are employed to determine the electrical parameters of the elaborated diodes, such as ideality factor, saturation current and series resistance. The whale optimization algorithm, which mimics the hunting behavior of humpback whales, is used to accurately extract the diode parameters. A comparison study employing an analytical method and two optimization algorithms was carried out to assess the effectiveness of the proposed strategy. The outcomes are evaluated using MSE, RMSE, MAPE, and R2. The obtained results obviously demonstrate that WOA outperforms both analytical and numerical approaches.
- 6 June 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (7) , 076003
Efficient whale optimization algorithm to extract electrical parameters of different CMOS based diodes
In this paper, experimental elaboration and investigation of three structures of diode, such as n+/p-well, p+/n-well and n-well/p-well are proposed. The diodes are elaborated on the basis of the standard 1 μm twin-well, double poly-Si and double level metal, complementary metal-oxide-semiconductor (CMOS) process technology. The mask design, diodes elaboration and electrical characterization were established in a cleanroom environment. Characterization results are employed to determine the electrical parameters of the elaborated diodes, such as ideality factor, saturation current and series resistance. The whale optimization algorithm, which mimics the hunting behavior of humpback whales, is used to accurately extract the diode parameters. A comparison study employing an analytical method and two optimization algorithms was carried out to assess the effectiveness of the proposed strategy. The outcomes are evaluated using MSE, RMSE, MAPE, and R2. The obtained results obviously demonstrate that WOA outperforms both analytical and numerical approaches.
- 2 May 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (6) , 065914
Structural and optical properties of highly Ag-doped TiO2 thin films prepared by flash thermal evaporation
The present study investigates the structural and optical properties of silver (Ag)-doped titanium dioxide (TiO2) thin films prepared via flash thermal evaporation using TiO2 and Ag powders mixture at various mass ratios. The crystallinity and surface morphology of the films were studied by varying the percentage of Ag content. Structural properties were characterized using X-ray diffraction (XRD), Raman spectroscopy, and scanning electron microscopy (SEM), while optical properties were assessed through optical transmission spectra analysis. Results indicate that Ag doping enhances crystallinity, as evidenced by XRD and Raman spectroscopy, and induces surface plasmon resonance (SPR) absorption attributed to Ag nanoparticles. SEM micrographs reveal agglomerated silver particles on the film surface, confirming Ag diffusion during annealing. Surface analysis through Secondary Ion Mass Spectrometry (SIMS) measurements illustrated the diffusion of Ag within the TiO2 samples and its subsequent accumulation at the surface. We have suggested that the crystallization observed in the evaporated TiO2-Ag thin films may primarily result from the thermal diffusion of Ag metal rather than the annealing process alone. Optical transmission spectra demonstrate a shift in the absorption edge towards the visible region with increasing Ag concentration, indicating enhanced light absorption properties.
- 2 May 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (6) , 065914
Structural and optical properties of highly Ag-doped TiO2 thin films prepared by flash thermal evaporation
The present study investigates the structural and optical properties of silver (Ag)-doped titanium dioxide (TiO2) thin films prepared via flash thermal evaporation using TiO2 and Ag powders mixture at various mass ratios. The crystallinity and surface morphology of the films were studied by varying the percentage of Ag content. Structural properties were characterized using X-ray diffraction (XRD), Raman spectroscopy, and scanning electron microscopy (SEM), while optical properties were assessed through optical transmission spectra analysis. Results indicate that Ag doping enhances crystallinity, as evidenced by XRD and Raman spectroscopy, and induces surface plasmon resonance (SPR) absorption attributed to Ag nanoparticles. SEM micrographs reveal agglomerated silver particles on the film surface, confirming Ag diffusion during annealing. Surface analysis through Secondary Ion Mass Spectrometry (SIMS) measurements illustrated the diffusion of Ag within the TiO2 samples and its subsequent accumulation at the surface. We have suggested that the crystallization observed in the evaporated TiO2-Ag thin films may primarily result from the thermal diffusion of Ag metal rather than the annealing process alone. Optical transmission spectra demonstrate a shift in the absorption edge towards the visible region with increasing Ag concentration, indicating enhanced light absorption properties.
- 1 February 2021
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 16 (02) , P02034
Multi-guard ring TCAD simulations for different n-on-p planar silicon particle detectors
- 1 February 2021
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 16 (02) , P02034
Multi-guard ring TCAD simulations for different n-on-p planar silicon particle detectors
- 1 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 352-357
Modeling the irradiance dependency of photovoltaic modules using Artificial Neural Network
This paper suggests an efficient approach to accurately model the irradiance dependency of photovoltaic (PV) modules by using the artificial neural network (ANN). In fact, a Feed-Forward Back Propagation (FFBP) neural network has been developed in this paper to deal with this concern. This network uses the Levenberg-Marquardt (LM) as the back-propagation training algorithm to tuning the network bias and weights. Furthermore, in order to show the merits of this strategy, a set of real experimental current-voltage (I-V) characteristics, measured from a commercialized PV module (Multi-crystalline Shell S75 PV module) are employed as the training and test datasets. These data are measured at nine irradiances (200, 300, 400, 500, 600, 700, 800, 900 and $1000\mathrm{W}/ \mathrm{m}^{2})$. Finally, the real measured I-V characteristics and the estimated ones (using the trained network) are compared. The obtained results demonstrate clearly the high accuracy of the developed model to mimic the irradiance dependency of PV modules.- 1 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 352-357
Modeling the irradiance dependency of photovoltaic modules using Artificial Neural Network
This paper suggests an efficient approach to accurately model the irradiance dependency of photovoltaic (PV) modules by using the artificial neural network (ANN). In fact, a Feed-Forward Back Propagation (FFBP) neural network has been developed in this paper to deal with this concern. This network uses the Levenberg-Marquardt (LM) as the back-propagation training algorithm to tuning the network bias and weights. Furthermore, in order to show the merits of this strategy, a set of real experimental current-voltage (I-V) characteristics, measured from a commercialized PV module (Multi-crystalline Shell S75 PV module) are employed as the training and test datasets. These data are measured at nine irradiances (200, 300, 400, 500, 600, 700, 800, 900 and $1000\mathrm{W}/ \mathrm{m}^{2})$. Finally, the real measured I-V characteristics and the estimated ones (using the trained network) are compared. The obtained results demonstrate clearly the high accuracy of the developed model to mimic the irradiance dependency of PV modules.