Myriam Chems
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Myriam Chems has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Lázaro Adrián González-Fernández
Multidisciplinary Postgraduate Program in Environmental Sciences, Autonomous University of San Luis Potosi, Av. Manuel Nava 201, 2nd. Floor, University Zone, San Luis Potosí 78000, Mexico
2 shared publications - Manuel Sanchez Polo
Faculty of Sciences, University of Granada, 18071 Granada, Spain
2 shared publications - Ventura Castillo Ramos
Department of Inorganic Chemistry, Faculty of Science, University of Granada, 18071 Granada, Spain
2 shared publications - Abdellah Anouar
Laboratory of Applied Chemistry and Environment, Faculty of Sciences and Techniques, Hassan First University of Settat, Settat 26000, Morocco
1 shared publication - Javier Ernesto Vilasó Cadre
Institute of Metallurgy, Autonomous University of San Luis Potosí, Sierra Leona Av. 550, Lomas 2nd Section, San Luis Potosí 78210, Mexico
1 shared publication - Nahum Andrés Medellín-Castillo
Centro de Investigación y Estudios de Posgrado, Facultad de Ingeniería, Universidad Autónoma de San Luis Potosí, San Luis Potosí 78290, Mexico
1 shared publication
Latest Publications
- Open Access
- 23 July 2024
- Published by MDPI AG in Separations
- Vol. 11 (8) , 221
Efficient Photocatalytic Degradation of Triclosan and Methylene Blue by Synthesized Ag-Loaded ZnO under UV Light
Industrial discharge of hazardous organic and synthetic chemicals, such as antibacterials and dyes, poses severe risks to human health and the environment. This study was conducted to address the urgent need for efficient and stable zinc-oxide-based photocatalysts to degrade such pollutants. A novel approach to synthesizing silver-loaded zinc oxide (Ag@Z) catalysts was introduced by using a simple and efficient combination of hydrothermal and precipitation methods. Comprehensive characterization of Ag@Z photocatalysts was performed using XRD, XPS, Raman, UV–vis adsorption, FTIR, and SEM, revealing an enhancement of structural, optical, and morphological properties in comparison to pure zinc oxide. Notably, the 5%Ag@Z catalyst exhibited the highest degradation efficiency among the other synthesized catalysts under UV-C light irradiation, and enhanced the degradation rate of pure zinc oxide (Z) by 1.14 and 1.64 times, for Triclosan (TCS) and Methylene Blue (MB), respectively. the effect of catalyst dose and initial concentration was studied. A mechanism of degradation was proposed after investigating the effect of major reactive species. The 5%Ag@Z catalyst increased the photostability, which is a major problem of zinc oxide due to photocorrosion after reusability. We found that 50% and 74% of energy consumption for the photocatalytic degradation of TCS and MB by 5%Ag@Z, respectively, was saved in compassion with zinc oxide. The remarkable photocatalytic performance and the good recovery rate of Ag@Z photocatalysts demonstrate their high potential for photocatalytic degradation of organic contaminants in water.
- 23 July 2024
- Published by MDPI AG in Separations
- Vol. 11 (8) , 221
Open AccessEfficient Photocatalytic Degradation of Triclosan and Methylene Blue by Synthesized Ag-Loaded ZnO under UV Light
Industrial discharge of hazardous organic and synthetic chemicals, such as antibacterials and dyes, poses severe risks to human health and the environment. This study was conducted to address the urgent need for efficient and stable zinc-oxide-based photocatalysts to degrade such pollutants. A novel approach to synthesizing silver-loaded zinc oxide (Ag@Z) catalysts was introduced by using a simple and efficient combination of hydrothermal and precipitation methods. Comprehensive characterization of Ag@Z photocatalysts was performed using XRD, XPS, Raman, UV–vis adsorption, FTIR, and SEM, revealing an enhancement of structural, optical, and morphological properties in comparison to pure zinc oxide. Notably, the 5%Ag@Z catalyst exhibited the highest degradation efficiency among the other synthesized catalysts under UV-C light irradiation, and enhanced the degradation rate of pure zinc oxide (Z) by 1.14 and 1.64 times, for Triclosan (TCS) and Methylene Blue (MB), respectively. the effect of catalyst dose and initial concentration was studied. A mechanism of degradation was proposed after investigating the effect of major reactive species. The 5%Ag@Z catalyst increased the photostability, which is a major problem of zinc oxide due to photocorrosion after reusability. We found that 50% and 74% of energy consumption for the photocatalytic degradation of TCS and MB by 5%Ag@Z, respectively, was saved in compassion with zinc oxide. The remarkable photocatalytic performance and the good recovery rate of Ag@Z photocatalysts demonstrate their high potential for photocatalytic degradation of organic contaminants in water.
- Open Access
- 25 April 2024
- Published by MDPI AG in Separations
- Vol. 11 (5) , 131
Comparative Kinetic Analysis of Triclosan Degradation under UV-C and Simulated Solar Irradiation
This research delves deeply into the intricate degradation kinetics of triclosan, employing two distinct methodologies: UV and simulated solar irradiation. Through a comprehensive comparative analysis, the study endeavors to elucidate the efficacy of these techniques, aiming to shed light on their respective methodological strengths and limitations. The study compares the efficacy of UV and simulated solar irradiation techniques for triclosan degradation, revealing that both methods exhibit effectiveness in degrading triclosan, with variations observed in degradation rates and byproduct formation. Through a detailed examination of the kinetics of triclosan degradation, the study reveals the intricate pathways and mechanisms involved in the photodegradation process. Results highlight the influence of irradiance levels and residence times on degradation efficiency. The research identifies optimal conditions for triclosan degradation, emphasizing the importance of residence time and irradiance levels. Results show that a residence time of 4 h and an irradiance level of 450 W m−2 maximize degradation efficiency. Analysis of degradation byproducts provides insights into the transformation pathways of triclosan under UV and simulated solar irradiation, indicating the formation of 2,4-dichlorophenol, quinone, and hydroquinone as primary byproducts.
- 25 April 2024
- Published by MDPI AG in Separations
- Vol. 11 (5) , 131
Open AccessComparative Kinetic Analysis of Triclosan Degradation under UV-C and Simulated Solar Irradiation
This research delves deeply into the intricate degradation kinetics of triclosan, employing two distinct methodologies: UV and simulated solar irradiation. Through a comprehensive comparative analysis, the study endeavors to elucidate the efficacy of these techniques, aiming to shed light on their respective methodological strengths and limitations. The study compares the efficacy of UV and simulated solar irradiation techniques for triclosan degradation, revealing that both methods exhibit effectiveness in degrading triclosan, with variations observed in degradation rates and byproduct formation. Through a detailed examination of the kinetics of triclosan degradation, the study reveals the intricate pathways and mechanisms involved in the photodegradation process. Results highlight the influence of irradiance levels and residence times on degradation efficiency. The research identifies optimal conditions for triclosan degradation, emphasizing the importance of residence time and irradiance levels. Results show that a residence time of 4 h and an irradiance level of 450 W m−2 maximize degradation efficiency. Analysis of degradation byproducts provides insights into the transformation pathways of triclosan under UV and simulated solar irradiation, indicating the formation of 2,4-dichlorophenol, quinone, and hydroquinone as primary byproducts.