Nian Qiu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nian Qiu has a total of 60 co-authors. Here are the top co-authors by number of shared publications:
- Xiang Gao
Chinese Academy of Sciences
4 shared publications - Aiguo Sang
Institute of Plasma Physics, Hefei, Institutes of Physical Science, Chinese Academy of Sciences, Hefei, China
2 shared publications - Huajun Liu
Chinese Academy of Science
2 shared publications - Junhua Luo
Department of Basic Science, Lanzhou Institute of Technology, Lanzhou, 730050, China; Institute of New Energy, Hexi University, Zhangye, 734000, China
2 shared publications - Junjun Li
Institute of Plasma Physics, Hefei Institutes of Physical Science, Chinese Academy of Sciences, Hefei, CHINA
2 shared publications - Kun Yang
National High Magnetic Field Laboratory
2 shared publications
Latest Publications
- 14 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 35 (5) , 1-6
Predictive Analysis of the Current Sharing Temperature Test of the CFETR CSMC
The Central Solenoid Model Coil (CSMC) has been manufactured and assembled as part of the R&D projects for the China Fusion Engineering Test Reactor (CFETR), and will be tested at ASIPP. The measurement of the current sharing temperature (Tcs) of the coil at maximum operating current of 47.65 kA is proposed to assess the performance of the coil. The Tcs is defined as the point where the electric field locally reaches 10 μV/m. During the Tcs test, voltage taps measure the voltage of each cooling channel of the CSMC. Reliable thermal-hydraulic predictions are necessary to estimate the total voltage across a cooling channel when the local electric field is 10 μV/m, supporting the definition of the Tcs loop heating strategy. A predictive analysis of the Tcs tests for the CSMC is carried out, using the GANDALF code. An optimum heating scenario, based on the staircase strategy is developed to reduce cryogenic costs.
- 14 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 35 (5) , 1-6
Predictive Analysis of the Current Sharing Temperature Test of the CFETR CSMC
The Central Solenoid Model Coil (CSMC) has been manufactured and assembled as part of the R&D projects for the China Fusion Engineering Test Reactor (CFETR), and will be tested at ASIPP. The measurement of the current sharing temperature (Tcs) of the coil at maximum operating current of 47.65 kA is proposed to assess the performance of the coil. The Tcs is defined as the point where the electric field locally reaches 10 μV/m. During the Tcs test, voltage taps measure the voltage of each cooling channel of the CSMC. Reliable thermal-hydraulic predictions are necessary to estimate the total voltage across a cooling channel when the local electric field is 10 μV/m, supporting the definition of the Tcs loop heating strategy. A predictive analysis of the Tcs tests for the CSMC is carried out, using the GANDALF code. An optimum heating scenario, based on the staircase strategy is developed to reduce cryogenic costs.
- 17 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (5) , 1-7
Quench Simulation of the CFETR Central Solenoid Model Coil
The Central Solenoid Model Coil (CSMC) has been manufactured as part of the R&D projects for the China Fusion Engineering Test Reactor (CFETR), and it will undergo testing in the second half of 2024. For the safety operation of magnet, predictive analyses are required to study thermal-hydraulic behavior of the CSMC during the quench. In this paper, the different quench initial position is detailed studied, for example, quench initiates at the peak magnetic field region and the lowest magnetic field region. In addition, the different quench disturbances are considered, such as (disturber length 0.01 m and disturber time 3 ms), (disturber length 1 m and disturber time 3 ms), and (disturber length 6 m and disturber time 100 ms). In all cases, the designed quench protection system is satisfied with the present design criteria concerning the hot spot temperature and the maximum helium pressure.
- 17 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (5) , 1-7
Quench Simulation of the CFETR Central Solenoid Model Coil
The Central Solenoid Model Coil (CSMC) has been manufactured as part of the R&D projects for the China Fusion Engineering Test Reactor (CFETR), and it will undergo testing in the second half of 2024. For the safety operation of magnet, predictive analyses are required to study thermal-hydraulic behavior of the CSMC during the quench. In this paper, the different quench initial position is detailed studied, for example, quench initiates at the peak magnetic field region and the lowest magnetic field region. In addition, the different quench disturbances are considered, such as (disturber length 0.01 m and disturber time 3 ms), (disturber length 1 m and disturber time 3 ms), and (disturber length 6 m and disturber time 100 ms). In all cases, the designed quench protection system is satisfied with the present design criteria concerning the hot spot temperature and the maximum helium pressure.
- 21 June 2000
- Published by AIP Publishing in Physics of Plasmas
- Vol. 7 (7) , 2933-2938
Plasma density behavior in the Hefei tokamak-7
The density profiles were measured in the Hefei tokamak-7 (HT-7) [World Survey of Activities in Controlled Fusion Research, Nuclear Fusion Special Supplement (International Atomic Energy Agency, Vienna, 1997), p. 61] ohmic discharges by means of a new multichannel far-infrared (FIR) laser interferometer. The progress on the extension of the HT-7 ohmic discharge operation region was introduced. The experiment results at the density limit, the multifaceted asymmetric radiation from the edge (MARFE) phenomena, the rf (radio frequency) boronization experiments, and the fueling efficiency studies were reported. The plasma physics in the molecular beam injection (MBI), the pellet injection (PI), and the gas puffing (GP) fueling experiments was studied and discussed.
- 21 June 2000
- Published by AIP Publishing in Physics of Plasmas
- Vol. 7 (7) , 2933-2938
Plasma density behavior in the Hefei tokamak-7
The density profiles were measured in the Hefei tokamak-7 (HT-7) [World Survey of Activities in Controlled Fusion Research, Nuclear Fusion Special Supplement (International Atomic Energy Agency, Vienna, 1997), p. 61] ohmic discharges by means of a new multichannel far-infrared (FIR) laser interferometer. The progress on the extension of the HT-7 ohmic discharge operation region was introduced. The experiment results at the density limit, the multifaceted asymmetric radiation from the edge (MARFE) phenomena, the rf (radio frequency) boronization experiments, and the fueling efficiency studies were reported. The plasma physics in the molecular beam injection (MBI), the pellet injection (PI), and the gas puffing (GP) fueling experiments was studied and discussed.
- 1 November 1999
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 41 (11) , 1349-1355
Improved confinement mode induced by the MARFE on the HT-7 superconducting tokamak
In the HT-7 superconducting tokamak, the onset of a multifaceted asymmetric radiation from the edge (MARFE) usually occurs in the early ohmic discharges of each experimental campaign before wall conditioning. The occurrence and location of a MARFE is identified by different diagnostic systems. An improved confinement mode plasma which was induced by the MARFE is observed, and the global particle confinement time increases 1.9 times. The relaxation time between the MARFE event trigger and the L-H transition is about 1.4 ms, the following L-H transition time is 1.9 ms, and the improved confinement mode phase is maintained for about 40 ms. The MARFE cools the plasma edge, and the electron density profile is observed to become more narrow and peaked. The occurrence of a MARFE is strongly correlated with Zeff but not with the density, and it always occurs at Zeff = 3-8 ohmic discharges. In the case of a good wall condition (Zeff = 1-2), the onset of MARFEs has not been observed before reaching the Greenwald density limit.
- 1 November 1999
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 41 (11) , 1349-1355
Improved confinement mode induced by the MARFE on the HT-7 superconducting tokamak
In the HT-7 superconducting tokamak, the onset of a multifaceted asymmetric radiation from the edge (MARFE) usually occurs in the early ohmic discharges of each experimental campaign before wall conditioning. The occurrence and location of a MARFE is identified by different diagnostic systems. An improved confinement mode plasma which was induced by the MARFE is observed, and the global particle confinement time increases 1.9 times. The relaxation time between the MARFE event trigger and the L-H transition is about 1.4 ms, the following L-H transition time is 1.9 ms, and the improved confinement mode phase is maintained for about 40 ms. The MARFE cools the plasma edge, and the electron density profile is observed to become more narrow and peaked. The occurrence of a MARFE is strongly correlated with Zeff but not with the density, and it always occurs at Zeff = 3-8 ohmic discharges. In the case of a good wall condition (Zeff = 1-2), the onset of MARFEs has not been observed before reaching the Greenwald density limit.