Fei Long
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Fei Long has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Chen Gong
School of Information Science and Technology, University of Science and Technology of China, Hefei, China
4 shared publications - Zhengyuan Xu
University of Science and Technology of China
4 shared publications - Jingyang Chen
CAS Key Laboratory of Wireless-Optical Communications, School of Information Science and Technology, University of Science and Technology of China, Hefei, China
2 shared publications - Jingyin Tang
CAS Key Laboratory of Wireless-Optical Communications, University of Science and Technology of China, Hefei, Anhui, China
2 shared publications - Lingfeng Li
CAS Key Laboratory of Wireless-Optical Communications, School of Information Science and Technology, University of Science and Technology of China, Hefei, China
2 shared publications - Chao Shen
Fudan University
1 shared publication
Latest Publications
- 1 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 73 (12) , 14668-14681
Beacon-Based Time Synchronization Protocol Design for Layered Ultraviolet Communication Network
To construct time slot synchronization for further resource management of ultraviolet (UV) networks, we propose a slot synchronization protocol based on flooding time and power optimization. Beacon sequence is applied to broadcast slot information without exchanging messages. Firstly, we propose slot synchronization schemes based on beacon sequence for two cases, with both multiple initialization nodes and a single initialization node. Then, we investigate the network synchronization accuracy with non-overlapping and overlapping beacons, as well as the synchronization accuracy of the entire network. Based on the network synchronization accuracy results, we propose power optimization to expand the synchronization range and enhance the synchronization probability. Numerical results show that power optimization can approximately achieve 18% higher synchronization success probability and 15% larger network synchronization range. Moreover, the proposed synchronization scheme is approximately 10 time periods shorter than meshed emergent firefly synchronization (MEMFIS), with approximately 40% lower network synchronization error.
- 1 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 73 (12) , 14668-14681
Beacon-Based Time Synchronization Protocol Design for Layered Ultraviolet Communication Network
To construct time slot synchronization for further resource management of ultraviolet (UV) networks, we propose a slot synchronization protocol based on flooding time and power optimization. Beacon sequence is applied to broadcast slot information without exchanging messages. Firstly, we propose slot synchronization schemes based on beacon sequence for two cases, with both multiple initialization nodes and a single initialization node. Then, we investigate the network synchronization accuracy with non-overlapping and overlapping beacons, as well as the synchronization accuracy of the entire network. Based on the network synchronization accuracy results, we propose power optimization to expand the synchronization range and enhance the synchronization probability. Numerical results show that power optimization can approximately achieve 18% higher synchronization success probability and 15% larger network synchronization range. Moreover, the proposed synchronization scheme is approximately 10 time periods shorter than meshed emergent firefly synchronization (MEMFIS), with approximately 40% lower network synchronization error.
- Open Access
- 14 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 17 (3) , 1-10
An Adaptive Threshold Updating Algorithm for PMT-Based Ultraviolet Communication
To address varying environmental conditions, this paper proposes an adaptive threshold updating algorithm for photomultiplier tube (PMT) signals in ultraviolet (UV) communication. The receiver maintains a set of pulse detection thresholds and performs channel estimation for each threshold. Using the channel estimation of both signal and background radiation components, we introduce a method to estimate the bit error rate (BER) corresponding to each threshold. Additionally, an adaptive threshold selection system is developed to dynamically update signal detection in response to changing environments. The accuracy of the optimal detection threshold is experimentally evaluated. The effectiveness of the proposed adaptive threshold algorithm is validated through indoor experiments, where trends in channel estimation results, detection thresholds, and frame error rates (FER) are recorded. Moreover, an outdoor experiment is conducted to verify the algorithm's performance under sunlight. The experimental results demonstrate that the adaptive threshold algorithm effectively adjusts the pulse detection threshold based on the current channel state, ensuring robust communication performance in dynamic channel conditions.
- 14 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 17 (3) , 1-10
Open AccessAn Adaptive Threshold Updating Algorithm for PMT-Based Ultraviolet Communication
To address varying environmental conditions, this paper proposes an adaptive threshold updating algorithm for photomultiplier tube (PMT) signals in ultraviolet (UV) communication. The receiver maintains a set of pulse detection thresholds and performs channel estimation for each threshold. Using the channel estimation of both signal and background radiation components, we introduce a method to estimate the bit error rate (BER) corresponding to each threshold. Additionally, an adaptive threshold selection system is developed to dynamically update signal detection in response to changing environments. The accuracy of the optimal detection threshold is experimentally evaluated. The effectiveness of the proposed adaptive threshold algorithm is validated through indoor experiments, where trends in channel estimation results, detection thresholds, and frame error rates (FER) are recorded. Moreover, an outdoor experiment is conducted to verify the algorithm's performance under sunlight. The experimental results demonstrate that the adaptive threshold algorithm effectively adjusts the pulse detection threshold based on the current channel state, ensuring robust communication performance in dynamic channel conditions.
- 16 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (10) , 563-566
A Large FoV UV LED Array Transmitter Enabling Optical Wireless Communication Over 1.1 km
Ultraviolet (UV) communication, as an emerging wireless data communication technology, has attracted increasing attention from researchers. Without the need for complicated pointing, acquisition, and tracking, UV optical wireless communication has emerged as a practical solution for free space data links. This paper reports the utilization of a large FoV UV LED array transmitter enabling a long-range UV communication system over 1.1 km. The measured data transmission rate is 1.25 Mbps using an on-off keying (OOK) modulation scheme and a photomultiplier tube receiver. Error-free data transmission was achieved using the Binarization Algorithm and forward error correction (FEC) coding. These findings indicate that communication links based on UV LED arrays offer a novel means of communication for emergency, secure, and complex environment applications.
- 16 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 37 (10) , 563-566
A Large FoV UV LED Array Transmitter Enabling Optical Wireless Communication Over 1.1 km
Ultraviolet (UV) communication, as an emerging wireless data communication technology, has attracted increasing attention from researchers. Without the need for complicated pointing, acquisition, and tracking, UV optical wireless communication has emerged as a practical solution for free space data links. This paper reports the utilization of a large FoV UV LED array transmitter enabling a long-range UV communication system over 1.1 km. The measured data transmission rate is 1.25 Mbps using an on-off keying (OOK) modulation scheme and a photomultiplier tube receiver. Error-free data transmission was achieved using the Binarization Algorithm and forward error correction (FEC) coding. These findings indicate that communication links based on UV LED arrays offer a novel means of communication for emergency, secure, and complex environment applications.
- Open Access
- 23 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 16 (3) , 1-10
Adaptive Modulation and Coding With LDPC Codes and Retransmission for Ultraviolet Communication
To adapt to different transmission power and distances, we design a rate-compatible transmission protocol to realize different transmission rates for ultraviolet (UV) communication. We have designed ensembles based on low-density parity-check (LDPC) codes, incorporating various code lengths and rates working under different channel conditions. Furthermore, the direct sequence spreading technique is adopted to obtain different channel codes working in weaker channel conditions. Through simulating the frame error rate (FER) performance across various signal and background radiation intensities, we obtain a table of switching thresholds for channel coding under distinct channel conditions. Different from that for radio-frequency (RF) communication with only one parameter of signal-to-noise ratio (SNR), the switching threshold table is constructed based on the combination of two parameters for UV Communication, the signal intensity and background radiation intensity. We also propose adaptive coding with hybrid automatic retransmission requests based on the combination of signal intensity and background intensity. It is verified through simulation that our designed system shows larger throughput under varying channel conditions compared with channel coding with a fixed rate in UV Communication.
- 23 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 16 (3) , 1-10
Open AccessAdaptive Modulation and Coding With LDPC Codes and Retransmission for Ultraviolet Communication
To adapt to different transmission power and distances, we design a rate-compatible transmission protocol to realize different transmission rates for ultraviolet (UV) communication. We have designed ensembles based on low-density parity-check (LDPC) codes, incorporating various code lengths and rates working under different channel conditions. Furthermore, the direct sequence spreading technique is adopted to obtain different channel codes working in weaker channel conditions. Through simulating the frame error rate (FER) performance across various signal and background radiation intensities, we obtain a table of switching thresholds for channel coding under distinct channel conditions. Different from that for radio-frequency (RF) communication with only one parameter of signal-to-noise ratio (SNR), the switching threshold table is constructed based on the combination of two parameters for UV Communication, the signal intensity and background radiation intensity. We also propose adaptive coding with hybrid automatic retransmission requests based on the combination of signal intensity and background intensity. It is verified through simulation that our designed system shows larger throughput under varying channel conditions compared with channel coding with a fixed rate in UV Communication.
- Open Access
- 1 April 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1486 (2) , 022033
Bi-objective Optimization of Black Start Allocation for Regional Power Grid
Under the influence of extreme weather events, black start allocation is more and more important for regional power grids lack of hydroelectric units and pumped-storage aggregates. This paper proposes a bi-objective optimization model considering both the time of the whole restoration and the risk of line recovery, an improved TOPSIS method is employed to solve the problem based the non-inferior solution. The results of the Dongguan power grid verify the effectiveness of this method.
- 1 April 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1486 (2) , 022033
Open AccessBi-objective Optimization of Black Start Allocation for Regional Power Grid
Under the influence of extreme weather events, black start allocation is more and more important for regional power grids lack of hydroelectric units and pumped-storage aggregates. This paper proposes a bi-objective optimization model considering both the time of the whole restoration and the risk of line recovery, an improved TOPSIS method is employed to solve the problem based the non-inferior solution. The results of the Dongguan power grid verify the effectiveness of this method.